Report containing results of a study regarding concentration of radioiodine in edible plants fed to animals.

This memorandum summarizes the results of an analysis to determine the extent of displacement of the EOCR core due to blowdown in case of several postulated hot main gas coolant pipe failures. Results show that the core will be damaged for any hot pipe double-ended failure. Excepting the improbable case of no coolant flow existing proper to the break, the core will be damaged for any hot pipe fracture exposing a total flow area to the atmosphere equal to that of one pipe. Smaller breaks will probably be safe in this respect.

The following report describes a current beam modulation designed to replace the standard regulator and to achieve an ion beam free from amplitude modulation.

In obtaining the results reported here a double focusing magnetic type spectrometer was used. Momentum spread was about 1%, and in most cases 2560 counts per point were taken. An end window Geiger tube was used as a detector. The window was of mica with areal density of 1.6 mg/cm2.

Various organizations in the Biophysics Section of the Radiological Sciences Department participated in evaluating local radioactive particle fallout as influenced by the nuclear explosions at the Nevada Proving Grounds during the early part of 1953. Data collected from approximately 50 air monitoring stations operated by the Regional Survey forces were used to determine the trend of radioactive particle concentrations in the atmosphere between March and June. These measurements were supplemented with the findings of associated organizations in the Biophysics Section during and immediately after the peak influx on May 26.

A system for scintillations from nuclear events has been developed and is presently in use at the Lawrence Radiation Laboratory. This paper primarily describes the pulsed light source used to simulate nuclear events; it also describes the necessary nanosecond pulse techniques to measure the light source parameters and to operate large numbers of lamps. Considerations concerning distribution networks are shown. Use of the light source as a spark gap trigger is also discussed.

At the request of Design Development Operation, various heat transfer and fluid flow problems were examined which are peculiar to the CO2 Gas-Cooled Loop in the PRTR. The results of these calculations are desired primarily to aid in demonstrating the adequacy of the design proposal. In addition, the operational limits of the loop and the consequences of the gas loop installation on the PRT reactor are of interest.

One of the research studies of the Chemical Effluents Technology Operation is the improvement of the method for predicting the capacity of a crib for the retention of wastes. In addition to laboratory work the research was extended a field experiment using a simulated crib fed with a solution containing a radioactive tracer. The purpose is twofold: (1) to check the validity of laboratory findings and (2) to observe several features of the behavior of solutions put to ground in the field.

The quantity and characteristics of fission products in coolant gases due to leaking fuel elements are discussed. It is concluded that the rare gases, the alkali metals, the halides, and Sb may act as permanent gases to a considerable extent. The other fission products are expected to condense out completely on walls or as dust consisting of metals, carbides, and oxides.

The maximum temperature in the interior of the fuel element could be greatly reduced by incorporating a liquid between the fuel element and the outer can to increase-heat transfer rates. It is of interest to consider what liquids would be chemically compatible with graphite and the actinide carbides. Elements which melt below 1100 and boil above 1400 deg C that form no stable solid carbides, include Cu, Ga, TI, Ge, Sn, Pb, Sb, Bi, and compounds include GeP, GeS, GaP, Ga/sub 2/S, GaTe, GaAs, SnTe, Sm/sub 3/As/sub 2/, Sb/sub 3/Te/sub 2/, Zn/sub 3/Sb/sub 2/, Zn/sub 3/P/sub 2/, ZnS, ZnTe, and Zn/s ub 3/As/sub 2/. Some of these compounds have equilibrium pressures that might be considered too high, but they may actually vaporize slowly enough because of low vaporization coefficients to make them suitable. There are probably rot enough data nor adequate theories for predicting the rates, and Langmuir type vaporization experiments would be necessary to determine the rates of vaporization of these compounds. The main problem in the use of a heat transfer fluid is that of reaction between the fluid and the actinide carbides. Thermodynamically extensive attack would be expected. However, it may be possible to make the rate …

From the point of view of constituents of a fuel element at temperatures between 2500 and 4500 degree K, the fuel elements can be considered to consist of six types of material: carbon, elements less volatile than carbon, 26 moles of rare gases, 21 moles of alkali metals, 17 moles of alkaline earth metals, and 4 moles of miscellaneous volatile elements. Various processes involving the constituents from 2000 to 45000 degree K are considered. Reactivity gain due to can rupture is discussed.