In this work I have attempted to find a basis for the design of fuel cams, which will serve equally for large and small engines, both high-speed and low-speed.

Force tests on a systematic series of wing systems over a range of angle of attack from minus forty-five degrees to plus ninety degrees are covered in this report. The investigation was made on monoplane and biplane wing models to determine the effects of variations of tip shape, aspect ratio, flap setting, stagger, gap, decalage, sweepback, and airfoil profile.

A series of experiments made in the wind tunnel of the Daniel Guggenheim School of Aeronautics, New York University, on the effect of tip shields on a horizontal tail surface are described and discussed. It was found that some aerodynamic gain can be obtained by the use of tip shields though it is considered doubtful whether their use would be practical.

The S 64 is a large monoplane with an aspect ratio of 7. It has a cantilever wing made of a single piece, entirely of wood. The wing has three spars with a covering of plywood. The engine is mounted high over the wing's center. It was designed for long distance transatlantic flights.

The S-38, model 28 is a nine passenger Sesquiplane powered by two Pratt and Whitney Wasp 410 HP engines and is intended for routes where the ability to take off and land from both land and water is essential. A description of the weight, construction, power plant, fuel system, landing gear, hull and floats, dimensions, flight characteristics, blueprints, and photographs are provided.

The primary purpose of this investigation was to obtain simultaneous data on the loads and stress experience in flight by the U. S. S. Los Angeles which could be used in rigid airship structure design. A secondary object of the investigation was to determine the turning and drag characteristics of the airship. The aerodynamic loading was obtained by measuring the pressure at 95 locations on the tail surfaces, 54 on the hull, and 5 on the passenger car. These measurements were made during a series of maneuvers consisting of turns and reversals in smooth air and during a cruise in rough air which was just short of squall proportions.

From Introduction Purpose and Organization: "This report on a method of analysis of aircraft accidents has been prepared by a special committee on the nomenclature, subdivision, and classification of aircraft accidents organized by the National Advisory Committee for Aeronautics in response to a request dated February 18, 1928, from the Air Coordination Committee consisting of the Assistant Secretaries for Aeronautics in the Departments of War, Navy, and Commerce."

From Summary: "The usual type of altimeter contains a pressure element, the deflections of which are approximately proportional to pressure changes. An evenly divided altitude scale is secured by using a mechanism between the pressure element and pointer which gives the required motion of the pointer. A temperature-compensated altimeter was constructed at the Bureau of Standards for the Bureau of Aeronautics of the Navy Department which contained a manually operated device for controlling the multiplication of the mechanism to the extent necessary for temperature compensation. The introduction of this device made it difficult to adjust the multiplying mechanism to fit an evenly divided altitude scale. To meet this difficulty a pressure element was designed and constructed which gave deflections which were proportional to altitude; that is, to the logarithm of the pressure."

The chief contribution of modern research in the field of windmills is a better understanding of the phenomena and of the available means for the accomplishment of certain results, but also of the natural limits to their productive capacity.

The following conclusions on air resistance of spheres are drawn: 1) disturbances in front of the sphere and even single fine wires affect the critical Reynolds Number; 2) disturbances around the sphere increased the drag of the sphere without martially affecting the value of the Reynolds Number(sub crith); 3) great disturbances of the boundary layer of the sphere likewise change R.N.(sub crith); 4) turbulence of the approaching air stream lowers critical R.N.

Different control instruments are discussed such as: air-speed indicators; angle-of-attack indicators; longitudinal inclinometers; turn indicators; stall indicators; and drift indicators.