This report presents the results of a flight investigation to determine the effect on the performance of a turbosupercharged engine of an exhaust-gas-to-air heat exchanger installed between the engine-exhaust collector ring and the turbosupercharger. The background, results, and discussion of the investigation are described.

From Introduction: "The tests reported herein, conducted during the early part of 1945, were made to determine the inherent charge-air distribution characteristics of the engine-stage supercharger of the double-row radial engine."

Report presenting an investigation to develop methods and equipment for the measurement of operating stresses in aircraft-engine crankshafts and connecting rods. The results indicate that the measurement of stresses in connecting rods is feasible. Results regarding stresses in the crankshaft and stresses in the master connecting rod are provided.

"Air-consumption data from calibrations of two radial aircraft engines were analyzed to show the relation of engine air consumption to its primary influencing factors: intake-manifold pressure, exhaust back pressure, intake-manifold temperature, and engine speed. The analysis of the test data from these two engines led to the establishment of a relation of variables upon which the design of automatic metering controls can be based. The data obtained from one engine indicate that the air-consumption correlation obtained for this engine is accurate within 2 percent except under certain conditions that are well outside current engine-operation limits" (p. 1).

"The lateral- and directional-stability and -control characteristics of a twin-engine patrol airplane as predicted from the results of wind-tunnel tests of a powered model and as measured in flight are compared in this report. The predictions from wind-tunnel-test data were in good agreement with the flight-test results. The results show that such predicted flying-qualities characteristics are sufficiently accurate to indicate the unsatisfactory lateral- and directional-stability and -control characteristics of airplanes in the preliminary design stage" (p. 1).

Report discussing tests of a model of the XP-55 to determine which modifications would prevent trim at large positive and negative angles of attack. The model was found to not trim at flat attitudes if the large wing tips with an extension of the wing-tip trimmers and a large elevator are installed on the airplane.

Report discussing spin tests performed on a scale model of the Curtiss-Wright XP-55 airplane. A large elevator with increased deflections and large wing tips with extensions were installed to improve the longitudinal-trim characteristics. Information about the spins, attitude after rotation, and recommended technique for spin recovery is provided.

An investigation was conducted to determine the effect of a coolant solution of 25 percent ethyl alcohol, 25 percent methyl alcohol, and 50 percent water by volume and maximum-economy spark advance on knock-limited performance and fuel economy of a large air-cooled cylinder. The knock-limited performance of the cylinder at engine speeds of 2100 and 2500 rpm was determined for coolant-fuel ratios of 0.0, 0.2, and 0.4. The effect of water-alcohol injection on fuel economy was determined in constant charge-air flow tests. The tests were conducted at a spark advance of 20 deg B.T.C. and maximum-economy spark advance.

Report discusses the results of a study "of the requirements for the attainment of a straight-line trajectory for a preset guided missile in the presence of wind or target motion" (from Summary). Information about the straight-line trajectory, position of the launching airplane, straight-line collision course, and arrangement of the autopilot in the missile is provided. Recommendations are also made about the creation of a bombsight mounting for the pilot of the launching airplane in order to attain the desired straight-line collision course.

Report discussing a comparison between a centrifugal-flow-type turbojet engine with an adjustable-area exhaust nozzle and with a series of fixed-area nozzles of various throat diameters. The adjustable-area nozzle was found to be as efficient as the fixed-area nozzles in testing. Information about the corrected static thrust, fuel flow, and tail-pipe gas temperature for both types of nozzles is provided.

Report discussing an investigation to determine the effect of omitting some of the fuel constituents in AN-F-28 Amendment 2 fuel that are normally lost in flight on fuel-vapor loss. Removing the components was found to decrease the fuel-vapor loss and increase the critical altitudes.

Report discussing tests on three fuels in a 14-cylinder double-row radial air-cooled engine at different engine speeds, blower ratios, and spark settings.

"A comparison has been made in flight of the antiknock characteristics of 33-R fuel with that of 28-R and a triptane blend. The knock-limited performance of the three fuels - 33-R, a blend of 80 percent 28-R plus 20 percent triptane (leaded to 4.5 ml TEL/gal), and 28-R - was investigated in two modified 14-cylinder double-row radial air-cooled engines. Tests were conducted on the engines as installed in the left inboard nacelle of an airplane. A carburetor-air temperature of approximately 85 deg F was maintained" (p. 1).

Report discussing testing of 2-percent additions of seven aromatic amines on the knock-limited performance of 28-R fuel in a CFR engine. The most effective antiknock additives are described.