Note discussing the lift of a finite wing including the calculations and constants for each step of the lift. This information is compared against the lift of an infinite wing. From Summary: "Unsteady lift function for wings of finite aspect ratio have been calculated by approximate methods involving corrections of the aerodynamic inertia and of the angle of the infinite wing. The starting lift of the finite wing is found to be only slightly less than that of the infinite wing; whereas the final lift may be considerably less. The calculations indicate that the distribution of lift near the start is similar to the final distribution."

Report presenting an experiment regarding tank and float venting conditions that exist on diving airplanes undergoing rapid changes in altitude. The results indicated that large pressure differences build up between the outside and inside of tanks and floats on diving airplanes unless the correct size of venting tube is used.

"Pressure-distribution tests were made on the 32-foot whirling arm of the Daniel Guggenheim Airship Institute of a tapered wing to determine the rolling and yawing moments due to an angular velocity in yaw. The model was tested at 0 degree and 5 degrees pitch, -1 degree and 5 degree yaw, and with a full-span flap deflected 60 degrees. The results are given in the form of span load distributions and in calculated moment coefficients" (p. 1).

Experimental report written by an unknown scientist done on lab rats in order to test the Emulsol Corporation's "solvit" product. The tester has come to the conclusion that "solvit" is not dangerous and does not have any harmful consequences. Included are two tables documenting the results of the experiment on the rats.

"Flight tests were made to determine the profile-drag coefficients of a portion of the original wing surface of an all-metal airplane and of a portion of the wing made aerodynamically smooth and more nearly fair than the original section. The wing section was approximately the NACA 2414.5. The tests were carried out over a range of airplane speeds giving a maximum Reynolds number of 15,000,000. Tests were also carried out to locate the point of transition from laminar to turbulent boundary layer and to determine the velocity distribution along the upper surface of the wing" (p. 483).

"Factors derived from wing theory are presented. By means of these factors, the angle of zero lift, the lift-curve slope, the pitching moment, the aerodynamic-center position, and the induced drag of tapered wings with partial-span flaps may be calculated. The factors are given for wings of aspect ratios 6 and 10 , of taper ratios from 0.25 to 1.00, and with flaps of various length. An example is presented of the method of application of the factors. Fair agreement with experimental results is shown for two wings of different taper ratio having plain flaps of various spacing" (p. 1).

Report presents the results of an investigation made in the NACA 7 by 10-foot wind tunnel of a large-chord NACA 23012 airfoil with several arrangements of venetian-blind flaps to determine the aerodynamic section characteristics as affected by the over-all flap chord, the chords of the slats used to form the flap, the slat spacing, the number of slats and the position of the flap with respect to the wing. Complete section data are given in the form of graphs for all the combinations tested.

"Static thrust and power measurements were made of six full-scale propellers. The propellers were mounted in front of a liquid-cooled-engine nacelle and were tested at 15 different blade angles in the range from -7 1/2 degrees to 35 degrees at 0.75r. The test rig was located outdoors and the tests were made under conditions of approximately zero wind velocity" (p. 85).

Report presents the results of an investigation of full-scale nose-slot cowlings conducted in the NACA 20-foot wind tunnel to furnish information on the pressure drop available for cooling. Engine conductances from 0 to 0.12 and exit-slot conductances from 0 to 0.30 were covered. Two basic nose shapes were tested to determine the effect of the radius of curvature of the nose contour; the nose shape with the smaller radius of curvature gave the higher pressure drop across the engine. The best axial location of the slot for low-speed operation was found to be in the region of maximum negative pressure for the basic shape for the particular operating condition. The effect of the pressure operating condition on the available cooling pressure is shown.

The icing hazard can, in most cases, be avoided by correct execution of the flights according to meteorological viewpoints and by meteorologically correct navigation (horizontal and, above all, vertical). The zones of icing hazard are usually narrowly confined. Their location can be ascertained with, in most cases, sufficient accuracy before take-off.

"Three general theories treating the potential flow about an arbitrary wing section are discussed in this report. The first theory treats the method of conformal transformation as laid down by Theodorsen and Garrick; the second is a generalization of Birnbaum's theory for moderately thick airfoils; the third is a general investigation of the complex velocity function with particular reference to the relations first discussed by F. Weinig. The relative merits of the different methods in question are illustrated on a worked-out example and will be published in a subsequent issue of this periodical" (p. 1).

"An investigation of the interference associated with tail surfaces added to wing-fuselage combinations was included in the interference program in progress in the NACA variable-density tunnel. The results indicate that, in aerodynamically clean combinations, the increment to the high-speed drag can be estimated from section characteristics within useful limits of accuracy. The interference appears mainly as effects on the downwash angel and as losses in the tail" (p. 1).

Report presenting an approximate method of computing the induced efficiency of heavily loaded propellers in suitable form for extension to finite number of blades and a comparison of results obtained using the method with the data of the Betz-Helmbold theory for heavily loaded propellers.

Corporate income and excess-profits tax return of 1938 for Texas Cotton Industries. The return includes all necessary schedules. The franchise tax return and capital stock tax returns are also attached with their respective schedules and financial statements.