This report analyzes a linear, hard-core pinch tube built to examine tubes afflicted by small-scale instabilities evident from many observations.

This report describes a toroidal version of the hard-core pinch and the additional information it can obtain to what the analogous linear pinch can get.

"The pulsed source technique consists of introducing repeated short bursts of neutrons into a subcritical assembly, and following the decay of the leakage flux as a function of time...It is noted that plotting the decay constant as a function of buckling gives an apparently accurate way to extrapolate to prompt critical. The pulsed source technique can also be used to calibrate control rod and poison worth, and will give some estimate of the prompt neutron lifetime."

From abstract: "A detailed study is presented of some fundamental problems connected with the realization of a nuclear gaseous reactor rocket engine."

Abstract. The region where exact thermodynamic description of the state of matter at high pressure and high temperature is possible is located. In the remaining region various approximate theories and empirical relations are discussed. These considerations are applied to hydrogen to locate the density and pressure at which the diatomic bond collapses. Also the approximate conditions are determined at which no bound electron states exist.

Quarterly report of the Chemistry Division at the University of California Radiation Laboratory providing updates for each department about current findings and ongoing research.

The purpose of this report is to describe a method of obtaining deuterons from the 184-inch cyclotron of higher energy than can be achieved from direct acceleration.

The absolute differential cross sections for elastic scattering of 31-Mev He3 ions on Be, Al, Cu, Sn(nat), Sn120, and Bi have been measured in the angular range of approximately 10 to 120 deg in the center-of-mass system. Thin self-supporting foil targets were chosen to span the parameter A 1/3, where A is the target mass number. The first excited states of the isotopes of the above elements had sufficient energy separation from the ground state to enable elastic scattering to be resolved from inelastic scattering. The detection system, consisting of Cal(Tl) scintillation crystals, was capable of 3%pulse-height resolution and 1 degree angular resolution. Characteristically, the light-element angular distributions show strong diffraction effects. The differential cross section divided by the Rutherford cross section decreases exponentially at large angles for the heavy elements, and the differential cross sections break away from Rutherford behavior at angles which increase almost linearly with increase of atomic number of the target nucleus. A comparison of the results for natural tin, and tin enriched to 85% in Sn120, indicated that within the experimental uncertainties over the measured angular interval, there were no pronounced isotopic effects. The data are presented both in tabular and graphical form to allow …

Introduction. The phase diagram data reported in this paper were obtained during an investigation of the beryllium-metal compounds of the titanium group transition elements. Several compounds in these systems had been previously reported but their compositions and structures were not all known. In the course of this study many details of the phase diagrams of the system were observed. Tentative diagrams consistent with this data will be presented.

Previous studies have been made of the relationship among acceleration, specific power, payload fraction, and travel time for many interplanetary missions. These utilized tangential thrust and correspond to the high thrust Hohmann transfer orbits. In addition, a complete optimization of the one way Mars mission has been accomplished. Since the minimum Jupiter round trip time was six and a half years for tangential thrust, calculations were carried out using higher energy transfer orbits. It is shown that the orbit-matching problem cannot be solved with tangential thrust programming in this case. The initial period of acceleration away from the earth's orbit was accomplished using tangential thrust in order to minimize energy expenditure. This was followed by a period of coasting until the proper moment arrived for commencing the orbit-matching maneuver. This terminates when the velocity and spatial coordinates of Jupiter's orbit are matched. The technique used for accomplishing these various orbit matching conditions without iteration are described. Best results for the final maneuver were obtained with the thrust vector approximately normal to the velocity vector. By this technique it is shown that the round-trip Jupiter mission may be carried out in four and an half years with 16% payload and 0.10 …

Quarterly progress report for the Chemistry Division of the University of California Radiation Laboratory: nuclear chemistry, bio-organic chemistry, metals and high temperature thermodynamics, basic chemistry, and chemical engineering.