From Summary: "A review of the status of the knowledge on turbine-blade cooling and a description of pertinent NACA investigations are presented. The current limitations in performance of uncooled and cooled engines are briefly discussed. Finally, the knowledge available and investigations to increase the knowledge on heat transfer, cooling-flow, and performance characteristics of cooled turbines are discussed."

Report presenting an investigation of the combined effects of wing taper ratio and low horizontal-tail position on the static longitudinal stability of a 45 degree sweptback wing-body combination with an aspect ratio of 4 at a range of Mach numbers. Results regarding tail-off pitch characteristics, tail-on pitch characteristics, and effective flow characteristics over horizontal tail are provided.

Memorandum presenting the use of the hypersonic similarity rule to correlate pressure distributions and wave drags for minimum-drag nose shapes derived by Von Karman and Newton. The computed results have been confirmed by comparison with available experimental data. Wave-drag results for both the Karman and Newtonian shapes are compared with each other and with results for ocnes and circular-arc tangent ogives.

Memorandum presenting an investigation to determine the effects of increase in angle of dead rise on the overall hydrodynamic characteristics of a seaplane having a length-beam ratio of 15 and a wing loading of 120 pounds per square foot. In general, increasing the angle of dead rise from 20 to 40 degrees and 60 degrees improved the trim limits of stability and the range of center-of-gravity positions for satisfactory take-off characteristics.

Report presenting an investigation to determine the effect of oxygen concentration of the inlet oxygen-nitrogen mixture on the combustion efficiency of a J33 single combustor operating with gaseous propane fuel. Combustion efficiency data were obtained at a variety of combustion-inlet total pressures, fuel flow rates, and inlet oxygen concentrations. Results regarding combustor data, application of fundamental combustion properties to combustor data, application of simplified reaction kinetics equation to combustor data, comparison of liquid and gaseous fuel data, and limitations of correlation parameters.

"Free-flight tests have been made to determine the drag at zero lift of several configurations of a missile having triangular wings and tails. Base-pressure measurements were also obtained for some of the configurations. The results show that increasing the wing thickness ratio from 4 to 6 percent increased the wing drag by about 100 percent at M = 1.3 and by about 30 percent at M = 1.8" (p. 1).

Report presenting a series of fence installations tested on a swept-wing jet airplane to determine their effects on the longitudinal instability, or "pitch-up", encountered in high-maneuvering flight. Longitudinal-stability measurements were made at a variety of Mach numbers with nine fence configurations that varied in chordwise extent and spanwise position. Results regarding longitudinal stability, flow phenomena, buffeting and wing dropping, drag, and low-speed stalls are provided.

Report presenting an investigation of the effects of many of the parameters significant to wing flutter on several untwisted rotating models to determine their significance with respect to stall flutter of propeller blades. The parameters included torsional stiffness, section thickness ratio, sweepback, length-chord ratio, section center-of-gravity location, blade taper, Mach number, and fluid density. Results regarding the considerations on method of presentation, experimental data and discussion, some possible applications, and a comparison of experiment with classical-flutter theory are provided.

Report presenting the total-pressure recovery characteristics of three circular internal-compression inlets with translating centerbodies at a range of free-stream Mach numbers. The inlets differed only in the shape of the internal compression contours. Results regarding the maximum pressure recoveries and pressure-recovery characteristics are provided.

Report presenting testing of models of rocket-motor fins of the ASROC missile for flutter and divergence in the supersonic flutter tunnel for a range of Mach numbers. Results indicate that both divergence of the overhung leading edge and flutter occur within the sea-level operating conditions of the missile at Mach numbers above 1.0. Results regarding the flutter boundary, type of flutter encountered, possible solutions to flutter problems, and possible effects of nondestructive type of flutter are provided.

Report presenting testing of scale models of rocket-motor fins of the ASROC missile for flutter and divergence in the supersonic flutter tunnel over a range of Mach numbers. Results regarding the flutter boundary, type of flutter encountered, and effects of flutter are provided.

Report presenting a wind-tunnel investigation to explore the possibility of employing boundary-layer suction slots as a means for delaying laminar separation at the leading edge and turbulent separation over the rear portions of the airfoil section at high lift coefficients. Results regarding lift and drag are explored.

The problem of improving operational reliability of turbojet engines is studied in a series of papers. Failure statistics for this engine are presented, the theory and experimental evidence on how engine failures occur are described, and the methods available for avoiding failure in operation are discussed. The individual papers of the series are Objectives, Failure Statistics, Foreign-Object Damage, Compressor Blades, Combustor Assembly, Nozzle Diaphrams, Turbine Buckets, Turbine Disks, Rolling Contact Bearings, Engine Fuel Controls, and Summary Discussion.

Memorandum presenting the Bell X-5 variable-sweep research airplane tested primarily at 58.7 degrees sweepback to determine the characteristics at transonic speeds of a fighter-type airplane with extreme sweepback. Some of the dynamic and static lateral stability characteristics have been discussed previously. Results regarding the lateral control, roll coupling, lateral problems at high lift, wing dropping, rudder oscillation at supersonic Mach numbers, and some pilots' impressions are also provided.

Report presenting results of flutter testing on three cantilever delta-wing plan forms at a range of Mach numbers. The time and location of flutter and results of the flutter calculations are provided for each of the wings.

Report presenting an investigation of several fuels in a 16-inch ramjet engine during a free-jet investigation of ramjet performance in a wind tunnel. The fuels used were gasoline, kerosene, blend of 50-percent gasoline and 50-percent propylene oxide, blend of 75-percent kerosene and 25-percent propylene oxide, and isopentane. Results regarding ranges of operation, combustion efficiencies, and weight and volume specific fuel consumptions obtained with various fuels.

Report presenting the heat transfer and pressures on the lifting surfaces of a 60 degree delta wing with NACA 65A005 profile at angles of attack up to 9 degrees. Results obtained are compared to values obtained from flat-plate theory.

"An investigation was conducted in the Langley 20-foot free-spinning tunnel on a 1/23-scale model of the McDonnell F3H-1N airplane. The effects of control settings and movements upon the erect and inverted spin and recovery characteristics of the model were determined for the clean condition. Spin-recovery parachute tests were also performed. The results indicated that erect spins obtained on the airplane for the take-off or combat loadings should be satisfactorily terminated if full rudder reversal is accompanied by moving the ailerons to full with the spin (stick full right in a right spin)" (p. 1).

Report presenting an investigation in the 7- by 10-foot tunnel of the aerodynamic and hinge-moment characteristics of an untapered, aspect ratio 3, semispan horizontal-tail model with 45 degrees of sweepback through a range of Mach numbers. The model was equipped with an unbalanced and a horn-balanced 25-percent-chord elevator.

Report presenting an investigation at transonic speeds to determine the effects of fences, drooped nose, combination fences and drooped nose, and vortex generators on a 45 degree sweptback wing-fuselage combination. The purpose of undertaking this investigation was due to the pitch-up tendency that results from leading-edge vortex-type flow on thin sweptback wings. The data for each component and their interaction with one another is also provided.

Report presenting the results of an investigation to determine the drag, static stability, control effectiveness, boundary-layer conditions, and first-order effects of propeller operation on a scale model of a proposed high-submerged-speed submarine with various bridge-fairwater and tail configurations.

Report presenting an investigation to determine the longitudinal stability and afterbody pressure characteristics of the TX-14 and TX-16 special weapons at transonic and supersonic speeds. Results regarding dynamic testing and pressure testing are provided.

Report presenting an investigation to determine the aerodynamic characteristics of two three-blade propellers over a range of blade angles and Mach numbers. The thick-blade propeller was more adversely affected by compressibility than the thin-blade propeller, and the maximum efficiency of the thin-blade propeller was higher than the thick-blade propeller.

The present paper presents the results of a brief investigation made to determine the effectiveness of a proposed emergency spin-recovery device to be used during demonstration spins of the Northrop XF -89 airplane. The proposed device makes use of split-type ailerons deflected +/-60deg on the outboard wing (left wing in a right spin). Tests made on a model which represented the airplane to a scale of 7 indicated that, if an uncontrollable spin is obtained in the design gross--weight loading, the device is not sufficiently effective to insure recovery,.