"An extended analysis was made of the previously reported performance investigation of the original compressor from the XJ-41-V turbojet engine and a similar compressor revised a to obtain a 33-percent increase in the geometric passage area at the vaned-collector entrance. This analysis was based on the concept of the vaned-collector entrance as the throat section of a nozzle. Because of nonuniform air distribution at the vaned-collector entrance, approximately 90 percent of the available flow area was utilized in the original compressor and 94 percent in the revised compressor" (p. 1).

A brief summary is made of methods available to the helicopter designer for obtaining desired stability characteristics by modifications to the airframe design. The discussion is based on modifications made during the establishment of flying-qualities criteria and includes sample indications of theoretical studies of additional methods.

From Summary: "An investigation of a vortex-generator configuration on the wings of a l/4-scale model of the X-1 airplane having a 10-percent-thick wing was conducted in the Langley 16-foot transonic tunnel. The effect of the vortex generators was determined by comparing the model aerodynamic characteristics, wing-pressure distributions, and wing-wake patterns for model configurations with and without vortex generators on the wings. Results are presented from tests at 0.1 increments in Mach number from about 0.69 to 0.99, at Reynolds numbers of about 4.1 x 10(exp 6) to 4.7 x 10(exp 6), and through an angle-of-attack range up to 1.5 deg at lower speeds and up to 5 deg at the highest speed."

One-dimensional mean-section flow and blade specific losses proportional to average specific kinetic energy are assumed in the analysis. Range of the work-speed parameter lambda considered includes low to moderate blade speeds with high specific work outputs, where critical turbojet, turbopump, and accessory-drive turbines are encountered. A diffusion factor of 0.5 limits the loading on the downstream stators. Turbine efficiences considered are total or aerodynamic, rating, and static. Efficiences of velocity-diagram types at impulse and that corresponding to values of maximum efficiency are presented and compared to indicate in what range of lambda downstream stators are beneficial as well as the attending improvements in efficiency.

From Summary: "Flight tests have been made to determine the longitudinal stability and control and stalling characteristics of a North American P-51H airplane. The results indicate that the airplane has satisfactory longitudinal stability in all the flight conditions tested at normal loadings up to 25,000 feet altitude. At Mach numbers above 0.7, the elevator push force required for longitudinal trim decreased somewhat because of compressibility effects."

"Tests were made of a 1/18-scale dynamically similar model of the Lockheed Constellation airplane to investigate its ditching characteristics and proper ditching technique. Scale-strength bottoms were used to reproduce probable damage to the fuselage. The model was landed in calm water at the Langley tank no. 2 monorail. Various landing attitudes, speeds, and fuselage configuration were simulated" (p. 1).

An experimental investigation has been conducted in the Langley stability tunnel at low speed to determine the pitching stability derivatives of a 1/9-scale powered model of the Convair XFY-1 vertically rising airplane. Effects of thrust coefficient, control deflections, and propeller blade angle were investigated. The tests were made through an angle-of-attack range from about -4deg to 29deg, and the thrust coefficient range was from 0 to 0.7. In order to expedite distribution of these data, no analysis of the data has been prepared for this paper.

Report presenting testing of a 5-percent-thick 2024-T3 aluminum-alloy multiweb wing (MW-1-(2)) at a Mach number of 2 under simulated supersonic flight conditions. The wing experienced dynamic failure as a result of catastrophic flag-waving flutter due to the combined action of aerodynamic heating and loading. Results regarding model temperatures, experimental pressures, strain results, accelerometer, and model failure are provided.

An investigation was conducted to relate the engine performance of the heat-resistant alloys, Stellite 21, Hastelloy B, cast S-816, forged S-816, X-40, Nimonic 80, Refractory 26, N-155, and Iconel X to their stress-rupture properties. The engine test consisted of the repetition of a 20-minute cycle, 15 minutes at rated speed and approximately 5 minutes at idle. The results of the investigation indicated a direct correlation between stress-rupture life and blade life for the relatively low-strength alloys. The stress-rupture life and blade life for the relatively high-strength alloys did not correlate because of the effects of the vibratory stresses and the corrosive-gas atmosphere.

Report presenting a wind-tunnel investigation on two series of twisted and cambered wings, which were identical except for wing section, to compare the effects of NACA 4-digit and NACA 64A chordwise distributions of thickness on the longitudinal aerodynamic characteristics of the wings. Results regarding the low-speed results, high-speed results, and flow studies are provided.

Report presenting an investigation of the effect of wing-mounted external stores on the loading and aerodynamic characteristics in pitch of a 45 degree sweptback wing combined with a fuselage. Store arrangements investigated consisted of stores mounted at the wing tips, stores mounted inboard on the wing undersurface at 46-percent semispan, and stores in both the tip and inboard locations.

Report presenting a sample of data on atmospheric turbulence on Lockheed U-2 airplanes during research flights. The intensity, amount, and extent of atmospheric turbulence observed in the United States is in good agreement with data from England and Western Europe. Results regarding overall gust distribution, intensity of turbulence, percent of rough air, and size of turbulent areas are provided.

"Measurements were made, in dives to transonic speeds, of the static-pressure position error at a distance of one chord ahead of the McDonnell XF-88 airplane. The airplane incorporates a wing which is swept back 35 deg along the 0.22 chord line and utilizes a 65-series airfoil with a 9-percent-thick section perpendicular to the 0.25-chord line. The section in the stream direction is approximately 8-percent thick. Data up to a Mach number of about 0.97 were obtained within an airplane normal-force-coefficient range from about 0.05 to about 0.68" (p. 1).

"A model of the Convair Y2-2 airplane was tested in Langley tank no. 2 to determine whether satisfactory stability in yawed landings was possible with a certain ventral fin. Free-body landings were made in smooth and rough water at two speeds and two rates of descent with the model yawed 15 degrees. The behavior of the model was determined by visual observations and from motion-picture records" (p. 1).

From Summary: "A supplementary investigation to determine the effect of external fuel tanks on the spin and recovery characteristics of a l/28-scale model of the North American FJ-4 airplane has been conducted in the Langley 20-foot free-spinning tunnel. The model had been extensively tested previously (NACA Research Memorandum SL38A29) and therefore only brief tests were made to evaluate the effect of tank installation."

Report presenting the effect of inlet component blunting on performance using an axisymmetric external-compression inlet in order to determine the performance penalties associated with spike-tip and cowl-lip blunting. The data can be used as a design guide for blunt inlet components applicable to cooling techniques. Results regarding the effect of tip rounding, drag coefficients, flow distortion, lip blunting, and Schileren photographs are provided.

From Summary: "An investigation was conducted to determine the coolant-flow distribution, the cylinder temperatures, and the heat rejections of the V-1650-7 engine . The tests were run a t several power levels varying from minimum fuel consumption to war emergency power and at each power level the coolant flows corresponded to the extremes of those likely to be encountered in typical airplane installations, A mixture of 30-percent ethylene glycol and 70-percent water was used as the coolant. The temperature of each cylinder was measured between the exhaust valves, between the intake valves, in the center of the head, on the exhaust-valve guide, at the top of the barrel on the exhaust side, and on each exhaust spark-plug gasket."

"An investigation has been conducted in the Langley 4- by 4-foot supersonic pressure tunnel at a Mach number of 1.41 to determine the static stability and control and drag characteristics of a 1/15-scale model of the Grunman F9F-9 airplane. The effects of alternate fuselage shapes, wing camber, wing fences, and fuselage dive brakes on the aerodynamic characteristics were also investigated. These tests were made at a Reynolds number of 1.96 x l0 (exp 6) based on the wing mean aerodynamic chord of 0.545 foot" (p. 1).

From Summary: "An investigation was conducted in the Langley 19-foot pressure tunnel on a 0.3-scale model of the Republic RF-84F airplane to determine modifications which would eliminate the pitch-up that occurred near maximum lift during flight tests of the airplane. The effects of high-lift and stall-control devices, horizontal tail locations, external stores, and various inlets on the longitudinal characteristics of the model were investigated. For the most part, these tests were conducted at a Reynolds number of 9.0 x 10(exp 6) and a Mach number of 0.19. The results indicated that from the standpoint of stability the inlets should possess blunted side bodies. The horizontal tail located at either the highest or lowest position investigated improved the stability of the model."

"Spatial burnout calculations have been made of two types of water moderated cylindrical reactor using boron as a burnable poison to increase reactor life. Specific reactors studied were a version of the Submarine Advanced Reactor (sAR) and a supercritical water reactor (SCW). Burnout characteristics such as reactivity excursion, neutron-flux and heat-generation distributions, and uranium and boron distributions have been determined for core lives corresponding to a burnup of approximately 7 kilograms of fully enriched uranium" (p. 1).

"During an investigation of the J57-P-1 turbojet engine in the Lewis altitude wind tunnel, effects of inlet-flow distortion on engine stall characteristics and operating limits were determined. In addition to a uniform inlet-flow profile, the inlet-pressure distortions imposed included two radial, two circumferential, and one combined radial-circumferential profile. Data were obtained over a range of compressor speeds at an altitude of 50,000 and a flight Mach number of 0.8; in addition, the high- and low-speed engine operating limits were investigated up to the maximum operable altitude" (p. 1).

From Summary: "An investigation has been conducted in the NACA Cleveland altitude wind tunnel to evaluate the operational characteristics of a 3000-pound-thrust axial-flow turbojet engine over a range of simulated altitudes from 2000 to 50,000 feet and simulated flight Mach numbers from 0 to 1.04 throughout the operable range of engine speeds. Operational characteristics investigated include engine operating range, acceleration, deceleration, starting, altitude and flight-Mach-number compensation of the fuel-control system, and operation of the lubrication system at high and low ambient-air temperatures."

Report presenting an investigation in the high-speed tunnel using the transonic bump technique in order to study the effectiveness of full-span flap-type controls on 31 unswept rectangular wings. Results regarding lift-curve slope, flap-effectiveness parameter, and the agreement between predicted and experimental results are also provided.

Report presenting results of a flight investigation of a radar fire-control system installed in a fighter airplane. Some of the factors included in the radar evaluation are "noise" of the steering dot, lack of target-attitude information, and sensitivity and linearity of the display.