Report presenting measurements of the pitot-pressure distributions in the flow field, pressure distributions over the body, and downwash distributions through shed vortices for an inclined body of revolution at a free-stream Mach number of 1.98. Results regarding the experimental pressure distributions and vortex positions, vortex strengths computed from experiment, comparisons of theoretical and experimental vortex paths, and comparisons of theoretical and experimental downwash distributions through the body vortices are provided.

Report presenting the results of a wind-tunnel investigation to determine the effects of a variation in wing taper ratio on the longitudinal characteristics of a wing-body combination at a variety of Mach numbers. The wings had an aspect ratio of 3, an unswept midchord line, and an NACA 64A003 profile. Results regarding the lift and pitching-moment characteristics and drag characteristics are provided.

Report presenting a procedure for estimating the range of peak airplane load factors and maneuvering tail loads likely to be experienced in pitch-up maneuvers. Results of computations indicated that though the load factors and maneuvering tail loads were not critical in pitch-up maneuvers at 35,000 feet, they were likely to exceed design levels at 15,200 feet.

Report presenting an investigation in the full-scale tunnel to determine the effects on the aerodynamic characteristics of a 49.1 degree sweptback wing of blowing a high-energy stream of air over a trailing-edge flap and an aileron. The results indicated that significant increases in lift coefficient and an improvement in aileron effectiveness may be obtained by the blowing method of boundary-layer control.

Memorandum presenting an investigation in the 9-inch supersonic tunnel of several missiles with low-aspect-ratio, cruciform, tandem lifting surfaces with a view toward developing a missile with small variations of center-of-pressure location at various angles of attack and roll. The investigation centered about a basic configuration with equal-span wings and tails.

Memorandum presenting the results of an investigation of the stability, control, and induced rolling moments of a canard missile with cruciform wings of rectangular plan form at Mach number 1.7. All of the data obtained, including the measured hinge moments of the canard control surfaces, axial forces on the complete missile, and forces and moments on the various combinations of missile components are presented in tabular form.

Report presenting an investigation of two large-scale, semispan, wing-fuselage models with the 0.25-chord line swept back 45 degrees to determine and compare the effects of partial-span, double-slotted flaps on the characteristics of a 45 degree sweptback wing with and without camber and twist. A secondary investigation was also conducted to determine the effects of various full-span, leading-edge modifications on the characteristics of the models with and without the flaps.

Report presenting an investigation of the aerodynamic loads on a leading-edge slat on a 40 degree sweptback wing with NACA 64(sub 1)-112 airfoil sections in the low-turbulence pressure tunnel. Results regarding wing force data, slat force data, and slat pressure distributions are provided.

Report presenting an investigation in the full-scale tunnel to determine the effects of symmetrically located wing nacelles on the low-speed aerodynamic characteristics of a 60 degree sweptback delta-wing-fuselage combination. The testing occurred with three spanwise nacelle locations with three chordwise positions at each spanwise station.

Report presenting an investigation to determine the effect of controlled grain size and increased carbon content on engine performance and high-temperature properties of precision-cast Stellite 21 turbine blades. Results regarding blade stresses, engine operation, and metallurgical examination are provided.

Report presenting an investigation in the free-flight tunnel to determine the dynamic lateral stability and control characteristics of a high-aspect-ratio bomber model with a sweptback-wing fighter model attached to each wing tip with freedom in roll. The results indicated that the longitudinal position of the fighters with respect to the bomber had an important effect on the flight behavior of the coupled configuration.

Report presenting a low-speed investigation in the stability tunnel to determine the effects of tail height, length, and aspect ratio on the static longitudinal stability and control characteristics of a 60 degree triangular-wing model with twin triangular all-movable tails located near the wing tips.

Report presenting the results of a flight investigation of the lateral stability and control characteristics of a high-speed fighter airplane. Results regarding the control-free lateral oscillations, sideslip characteristics, rudder control characteristics, rudder hinge-moment characteristics, and rolling characteristics are provided.

Report presenting an investigation of the low-speed static stability characteristics of a complete model equipped with a W wing. The lift-curve slope of the wing-fuselage combination was found to be in good agreement with that predicted by available wing-alone theory. Results regarding the longitudinal characteristics, wing-juncture modifications, and lateral and directional stability characteristics are provided.

Report presenting a flight investigation to determine the zero-lift drag characteristics of a twin-engine supersonic ramjet configuration in order to make performance calculations below the design Mach number. Data was obtained over a range of Mach numbers for two power-off ramjet models with and without nacelles. Information about the variation of Reynolds number, total and external drag coefficients, and model-component drag coefficients is provided.

The altitude-ignition limits of a condenser-discharge ignition system installed on a turbojet engine were determined at a flight Mach number of 0.6 using 1.1-pound Reid vapor pressure fuel. Ignition was possible up to an altitude of 55,000 feet with 4.8 joules per spark and 6 sparks per second.

The nature of the flow at the exit of a row of turbine blades for the range of conditions represented by four different blade configurations was evaluated by the conservation-of-momentum principle using static-pressure surveys and by analysis of Schlieren photographs of the flow. It was found that for blades of the type investigated, the maximum exit tangential-velocity component is a function of the blade geometry only and can be accurately predicted by the method of characteristics. A maximum value of exit velocity coefficient is obtained at a pressure ratio immediately below that required for maximum blade loading followed by a sharp drop after maximum blade loading occurs.

Report presenting a comparison of fixed-geometry, translating-spike, and bypass-inlets on the basis of turbojet- and ramjet-engine performance. Results regarding a comparison of the experimental data and its application to ramjet and turbojet engines are provided.

Report presenting an investigation of the effects of tip-mounted jet-engine nacelles on the aerodynamic characteristics of low-aspect-ratio rectangular and tapered wings using the transonic-bump technique. The effect of the tip-mounted nacelles was generally to increase the lift-curve slopes for wings of aspect ratio 2 or larger with upper or lower mounted nacelles causing larger increases than symmetrically mounted nacelles. Results regarding rectangular wings and tapered wings are provided.

Investigation of the internal performance characteristics of three types of variable-throat convergent-divergent nozzles over a wide range of pressure ratios. Only small differences in peak thrust coefficient between the three types of variable-throat convergent-divergent nozzles were obtained.

Memorandum presenting a brief method for estimating the speed response of turbojet and turbine-propeller engines to a step change in fuel flow. The method approximates the dynamic equilibrium in the gas-turbine engine with a first-order linear differential equation, the time constant of which varies inversely with the equilibrium speed. Engine time constants computed by means of this method are compared with time-constant data obtained by direct measurement of transient on three turbojet engines and two turbine-propeller engines.

"The influence of triangular-shaped end plates on the lift and the flow field of a canard-type control surface mounted on a symmetrical fuselage was investigated in the Lewis 8- by 6-foot supersonic wind tunnel at a Mach number of 2.00, body angle of attack of 2 degrees, and control-surface deflection angles of 3 degrees, 6 degrees, 8 degrees, and 10 degrees. The investigation demonstrated that the addition of end plates to a canard-type control surface increased its lift and rearranged the single vortex into a two-vortex system. Perforating the end plates reduced these effects and resulted in a decrease in lift and a change in the flow-field characteristics" (p. 1).

Report presenting an investigation to determine the effectiveness of ethyl ether as an ignition aid for low-volatility turbojet-engine fuels. The minimum spark engines required to ignite a single J33 combustor over a range of altitude inlet-air pressures and flow rates with several fuel blends are provided.

Report presenting tests of the aerodynamic characteristics of two delta wings of the same aspect ratio and airfoil sections at Mach number 4.04. The results indicated that the ratio of the experimental lift-curve slope to the theoretical two-dimensional lift-curve slope from previous testing is valid at this Mach number.