From Summary: "A method for computing the effect of surface roughness on the drag coefficient of an airplane is presented. Calculated results using this method are compared with experimental results from both flight and wind-tunnel tests. In general, the agreement is believed satisfactory."

Report presenting a method for calculating the drag, in a real compressible fluid and at subcritical Mach numbers, of airfoil sections at arbitrary life coefficients and of bodies of revolution at zero angle of attack. The values of drag coefficient are compared with values obtained for the same configurations by other methods. The differences between the results are found to lie withint he limits of accuracy of current experimental techniques.

Report presenting measurements of the behavior at supercritical Mach numbers of ailerons on a jet-propelled fighter plane. Results regarding aileron upfloat and aileron oscillations are provided.

Report discussing testing on a 42 degree swept-back wing to determine its low-speed aerodynamic characteristics in pitch and yaw at high Reynolds numbers. The main effect of increasing the Reynolds number was delayed wing stalling to higher angles of attack. Roughness on the wing leading edge also had a large adverse effect on lift, drag, and pitching-moment characteristics at higher Reynolds numbers.

"An investigation of an NACA submerged intake installation on the Ryan FR-1 was conducted to determine the full-scale aerodynamic characteristics of this installation. In addition, tests were conducted on the submerged inlet with revised entrance lips and deflectors to determine the configuration which would result in the best dynamic pressure recovery measured at the inlet for this installation without a major rework of the entrance. Stalling of the air flow over the inner lip surface created excessive dynamic pressure losses with the original entrance. The revised entrance produced a 12-percent increase in dynamic pressure recovery at the design high-speed inlet-velocity ratio and resulted in an improvement of the critical-speed characteristics of the entrance lip" (p. 1).

"The probable spin and recovery characteristics of the XSN2J-1 air-plane have been estimated on the basis of the results of brief test a performed on a model of an airplane of somewhat similar design. The spin-recovery tail-parachute requirements for the airplane were also determined end, in addition, an analysis was made to determine the best method of emergency pilot escape during a spin. The results of the investigation indicate that the recovery characteristics of the airplane will be satisfactory for all probable loading conditions of the airplane" (p. 1).

From Summary: "An investigation was conducted to determine the coolant-flow distribution, the cylinder temperatures, and the heat rejections of the V-1650-7 engine . The tests were run a t several power levels varying from minimum fuel consumption to war emergency power and at each power level the coolant flows corresponded to the extremes of those likely to be encountered in typical airplane installations, A mixture of 30-percent ethylene glycol and 70-percent water was used as the coolant. The temperature of each cylinder was measured between the exhaust valves, between the intake valves, in the center of the head, on the exhaust-valve guide, at the top of the barrel on the exhaust side, and on each exhaust spark-plug gasket."