Report presenting wind-tunnel tests of a semispan model of a thin sharp-edged unswept wing of aspect ratio 4 and taper ratio 0.5 equipped with a full-span, constant-chord, leading-edge flap. The effectiveness of the leading-edge flap in improving the lift-drag ratio of the wing was investigated over a range of Mach and Reynolds numbers. Results regarding the lift characteristics, drag characteristics, pitching-moment characteristics, and lift-drag ratio are provided.

Memorandum presenting an investigation conducted to determine the pressure distribution on a conical body of elliptic cross section at a Mach number of 1.89. Experimental data are presented for a range of angles of yaw from -16 to 16 degrees and angles of attack from -10 to 10 degrees. As the angle of flow deflection was increased, the deviation from experiment of the theoretical pressure distribution slightly increased, although agreement was satisfactory over the entire range of calculations.

Contains low-speed longitudinal stability characteristics of a 52 degree sweptback wing of aspect ratio 2.88, taper ratio 0.625, and NACA 64 (sub 1)-112 airfoil sections normal to the 0.282-chord line, in combination with split flaps, leading-edge flaps, and upper-surface fences. Low-wing and midwing-fuselage aerodynamic characteristics are presented with and without a horizontal tail at various vertical locations. Tests were conducted at a Reynolds number of 6.8 x 10(exp 6).

Report presenting an investigation of the effect of the rate of change of angle of attack on the maximum lift coefficient of a pursuit airplane equipped with a low-drag-type wing in stalls of varying abruptness over a range of Mach and Reynolds numbers. Maximum lift coefficients were found to increase linearly with increasing rate of change of angle of attack per chord length of travel up to the maximum rate attained in the tests.

Report presenting data from two experiments. One used the NACA RM-2 drag research model equipped with a pilot's canopy to determine the effect on aerodynamics. The other was conducted with the same configuration and returned similar results.

Report presenting an investigation of the low-speed characteristics of a wing swept back 42 degrees at the leading edge and having various high-lift and stall-control devices and fuselage and horizontal tail vertical positions. Results regarding the characteristics of the basic wing, leading-edge flap investigation, wing fuselage investigation, and horizontal tail investigation are provided.

"The frequency of blade temperature to exhaust gas temperature is presented for two locations in the blade and at several operating conditions. The frequency response was determined by Fourier analysis of transient data. Two analytical methods are presented, and results are compared with experimental data. Dynamic response of turbine-blade temperature to exhaust-gas temperature exhibited the form of an approximate first-order lag" (p. 1).

"Tabulated pressure coefficients and aerodynamic characteristics obtained in flight from pressure distributions over six chordwise rows of orifices on the right wing of the D-558-I research airplane (BuAero No. 37972) are presented. The data were obtained through a Mach number range of 0.80 to 0.89 and throughout the normal-force-coefficient range at Mach numbers of 0.61, 0.70, 0.855, and 0.88. This paper supplements similar tabulated data which have been presented in NACA RM L50J10 and NACA RM L50L12a" (p. 1).

Report presenting a study of rocket-powered models at transonic speeds to determine the effect on the zero-lift drag coefficient of an indented fuselage modification and a thickened wing-root modification of a swept-wing airplane configuration. Results regarding the variation of drag coefficient with Mach number, effect of wing root thickening, and wing-plus-interference drag coefficients for the tested models are provided.

Report presenting an investigation at Mach number 1.6 and a range of Reynolds number of the skin-friction drag and boundary-layer transition of a body of revolution. The body had a parabolic-arc profile, a blunt base, and a fineness ratio of 12.2 (NACA RM-10). Results regarding the effect of surface condition, drag breakdown, and results of boundary-layer surveys are provided.

Report presenting an investigation to increase the compressor surge-limit pressure ratio of the XJ40-WE-6 turbojet engine at high equivalent speeds. The two compressor modifications investigated included twisting rotor blades to change blade section angles and inserting new stator diaphragms with different blade angles. Results regarding the effect of surge limit on engine performance, performance map of original compressor with mixer, effect of blade modifications on surge line, effect of mixer on surge limit, and effect of compressor modifications on performance are provided.

Report presenting the effect of Mach number on the characteristics of the downwash and wake behind an unswept, tapered wing of aspect ratio 2.67 with full-span, 25-percent-chord, leading- and trailing-edge flaps has been determined from wind-tunnel tests. Results regarding downwash characteristics and wake characteristics are provided.

Report discussing a pressure-distribution investigation of a wing of a supersonic aircraft in the presence of a fuselage at a specified Mach number and aerodynamic chord. The wing had a quarter chord swept back 40 degrees, an aspect ratio of 4, a taper ratio of 0.5, and 10-percent-thick circular-arc sections perpendicular to the quarter-chord line. The results were compared to a similar investigation at a different Mach number.

Report presenting a flight investigation using rocket-powered models to determine some of the effects of wing-to-tail distance on the stability and control characteristics of a canard-missile configuration with 60 degree delta wings and control surfaces. Both models were tested over a range of Mach numbers from 0.8 to 2.0, and canard hinge moment and model drag data are presented. Testing indicated that additional fuselage length increases the lift-curve slope slightly and has very little effect on minimum drag.

Report presenting a flight investigation using four rocket-propelled models of low-aspect-ratio tailless configurations between Mach numbers 0.7 and 1.35. The configurations investigated were a 45 degree delta model with NACA 63A010 airfoil sections parallel to free stream, a 45 degree delta-wing model with NACA 63A006 airfoil sections parallel to free stream, a 37.5 degree swept-tapered wing model with NACA 64(sub 1)A012 sections perpendicular to quarter chord, and a 39 degree swept-tapered-wing model with NACA 64A006 airfoil sections perpendicular to quarter chord. Results regarding time histories, static longitudinal stability, dynamic longitudinal stability, order of oscillation frequency, rotational damping in pitch, and drag are provided.

Report presenting an investigation of the influence of high-altitude supersonic flight on the operation and effectiveness of turbine-blade liquid-cooling systems for application in turbojet engines in guided missiles and in supersonic aircraft. The problems encountered in liquid-cooling systems were investigated with reference to several specific designs for alternate heat-rejection mediums.

Memorandum presenting tests of a triangular-wing-airplane model equipped with high-lift devices and lateral and directional controls. The model consisted of an aspect ratio 4 triangular wing in combination with a fuselage of fineness ratio 12.5, a thin, triangular, vertical tail with a constant-chord rudder, and a thin, unswept, all-movable horizontal tail. Results regarding the effects of flap deflection and tail incidence on the pitching moment characteristics, lift and drag characteristics, and rudder effects are provided.

Report presenting an investigation to determine the effects of turbine-blade coatings, supplied by fuel additives, on heat transfer with combustor exhaust gases to an S-816 alloy blade. Two fuel additives were used. The results indicated that the fuel additives provided an oxide coating on the combustor-liner wall and other metal parts, including the blade, exposed to the exhaust gas.

Report presenting wind-tunnel studies of the wake behind eight types of canard control surfaces of equal span mounted on a missile body at Mach number 1.93. The effect of simulated external rocket boosters on the pressure field was also determined for three control-surface plan forms. The investigation also included the effect of end plates attached to the tips of one of the controls surfaces.

Memorandum presenting an investigation of a 2:1 area-ratio diffuser of length equal to the inlet diameter with several arrangements of simple rectangular vortex generators over a speed range up to an inlet Mach number of 0.5. The investigation was for an inlet boundary layer of 5 percent of the inlet diameter, a condition for which this diffuser had substantial separated areas with no vortex generators. Results regarding the diffuser with no vortex generators, counterrotating vortex generators, other arrangements investigated, and a comparison with results from previous diffuser research are provided.

Experimental investigation of flow about a slender body of revolution (NACA RM-10 missile) aligned and inclined to a supersonic stream was conducted at Mach numbers from 1.49 to 1.98 at a Reynolds number of approximately 30,000,000. Boundary-layer measurements at zero angle of attack are correlated with subsonic formulations for predicting boundary-layer thickness and profile. Comparison of pressure coefficients predicted by theory with experimental values showed close agreement at zero angle of attack and angle of attack except over the aft leeward side of body. At angle of attack, pitot pressure measurements in plane of model base indicated a pair of symmetrically disposed vortices on leeward side of body.

From Introduction: "This paper presents the results of the investigation of the wing-alone and wing-fuselage configurations employing a wing with the quarter-chord line swept back 45^o, aspect ratio 4, taper ratio 0.3, and an NACA 65A006 airfoil section parallel to the stream."

Experimental study of effects of combustion roughness and controlled mechanical oscillations on diffuser operation was conducted on an 8-inch ram jet at Mach number 1.87. Within experimental accuracy, the optimum mean combustion-chamber static pressure occurred when the maximum instantaneous static pressure equalled the optimum steady-flow value and the corresponding decrement in optimum mean static pressure was equal to one-half the total amplitude of the pressure pulsations. A marked attenuation of amplitude of cold-buzz pressure fluctuations was effected over limited range of subcritical diffuser operation by means of properly tuned rotating disk located in combustion chamber.

Report presenting the results of a wind-tunnel investigation of the lift and moment characteristics of four 10-percent-thick circular-arc airfoil sections. Increases in the trailing-edge thickness were found to result in increases in maximum lift coefficient and lift-curve slope at all Mach numbers as well as increases in lift-divergence Mach number at all lift coefficients.