Report presenting tests of an airplane model equipped with missiles to investigate the capability of that combination to achieve satisfactory launching and jettisoning of the missiles. Information about pylon modifications, missiles in launch positions, missile trajectory, and missiles in jettison positions is provided.

Report presenting a consideration of the problem of shaping an adjoining fuselage for a given wing and supersonic Mach number so that the combination will have a low wave drag. Only fuselages that can be simulated by singularities distributed along the body axis are studied.

Report presenting a description of the Ames 2- by 2-foot transonic wind tunnel, its uses in testing, and a preliminary evaluation of the wall interference in the tunnel.

"Aerodynamic data have been obtained for a fuselage forebody alone and for canopy-body configurations consisting of four different canopies mounted on a fuselage forebody. Two of the canopies had the same shape and size rearward of the windshield but one had a "flat" and the other a "vee" windshield. The remaining two canopies were located at different body stations and were geometrically similar. The data indicated that the drag of the flat-windshield model was consistently lower than that of the vee-windshield model" (p. 1).

Memorandum presenting experimental flutter Mach numbers for several solid, thin, rectangular cantilever wings with uniform section properties, low aspect ratio, and high relative density estimated from the results of previous tests at zero angle of attack. The experimental values are considered estimates, rather than determinations, in the high subsonic speed range because in that range the amplitude criterion was necessarily arbitrary. Results regarding conservatism of standard analysis relative to the experiment, closeness of analytical and experimental results, and interpretation of the analytical and experimental uncertainties are provided.

Memorandum presenting a systematic transonic zero-lift drag investigation utilizing a swept-wing configuration with three different ratios of wing to fuselage size utilizing a 6-inch helium gun. The experiments and comparisons with other results indicated that the reduction of pressure drag obtainable from partial indentation is approximately proportional to the amount of indentation employed up to a Mach number of 1.3. Results regarding the basic data, total drag, pressure drag, equivalent bodies, and special projections are provided.

From Introduction: "The investigation reported herein was initiated to define further the effects on the aerodynamic characteristics and load distribution of a thin, sweptback wing of a low-pressure blowing system and also to provide information on which to base a more thorough study of a complete airplane configuration."

Report presenting shock-position controls designed to actuate the translating spike and variable bypass of a variable-geometry inlet in the 8- by 6-foot supersonic tunnel. The operation of the inlet was observed in combination with a J34 turbojet engine at a range of Mach numbers. Results regarding terminal-shock-positioning control systems and combination control are provided.

Report presenting an investigation of a turbojet engine with variable inlet guide vanes in an altitude test facility to determine the steady-state compressor performance and surge characteristics. Compressor surge pressure ratios were found to be unaffected by changes in flight condition for either position of the inlet guide vanes. Decreasing the inlet Reynolds number was found to reduce the corrected fuel flow required for compressor surge.

Report presenting chordwise pressure distributions measured over the left wing of a Convair XF-92A delta-wing airplane at low lift to determine the effect of Mach number on the wing characteristics at transonic speeds. The critical Mach number of the basic wing was 0.83 for an airplane normal-force coefficient at 0.09. The spanwise load distributions were roughly triangular in shape.

Report presenting a program to investigate the aerodynamic characteristics of a family of delta wings with a blunt double-wedge section in the hypersonic tunnel at Mach number 6.9. The wings varied at semiapex angle and were tested over a range of angles of attack and Reynolds numbers. Results regarding lift and drag characteristics, center of pressure and moment coefficient, Schlieren photographs, and surface film flow studies are presented.

Memorandum presenting flight tests conducted with an F-86D airplane equipped with a director-type radar fire-control system with scope presentation of the attack display. The effects of two attack-computer parameters and one attack-display parameter on the tracking performance in the manual mode of operation were investigated. Results regarding fixed-sight tracking and tracking with scope presentation are provided.

Memorandum presenting a turbojet engine with a two-stage turbine operated with pentaborane fuel continuously for 11.5 minutes at a simulated altitude of 55,000 feet at a flight Mach number of 0.8. The engine incorporated an NACA combustor designed specifically for use with pentaborane fuel. Results regarding oxide formation and deposition, engine operating point, effect of oxide deposits on component performance, effect of oxide deposition on overall performance, and some operational comments are provided.

Report presenting performance of a two-dimensional external-compression inlet designed for various methods of inlet-engine matching up to Mach 3 at Mach 1.89 and Mach 0. Results regarding shock geometry, two-shock ramps, isentropic ramps, profiles, and cowl drag for the various Mach number tests are provided.

Memorandum presenting the results of an experimental investigation to determine the pressure-distribution characteristics of a conically cambered wing with and without pylon-mounted engine nacelles for Mach numbers of 1.6 and 1.9. The pressure data obtained during this investigation indicate that the low-pressure region existing on the upper surface over the forward part of the wing was spread over a larger proportion of the local chord than would be the case for an uncambered wing.

Memorandum presenting a correlation of analyses of the effect of distributed surface injection on the heat transfer and skin friction associated with the turbulent boundary layer at high speeds to eliminate the effects of Mach and Reynolds number. Data for heat transfer and skin friction at three Mach numbers are compared with the analyses and the agreement is good.

Report presenting an experimental investigation in the transonic blowdown tunnel to determine effects of center-of-gravity location on the transonic flutter characteristics of a 45 degree sweptback-wing plan form of aspect ratio 4.0 and taper ratio 0.6. Solid-construction models with streamwise NACA 65A004 airfoil sections and center-of-gravity locations at three different chords were fluttered at a range of Mach numbers.

From Summary: "Hydrodynamic characteristics have been determined for a 1/13.33-scale jet-powered dynamic model of the Martin XP6M-1 flying boat with the forebody modified so as to increase the depth of step and the angle between the forebody and afterbody keels. Longitudinal stability during takeoff and landing in smooth water and resistance of the complete model in smooth water and in waves are presented."

Memorandum presenting an investigation conducted in the icing research tunnel to determine the icing characteristics, the effects of icing on radar operation, and the protection requirements for two radome configurations. The radomes were for the F-89 airplane and were investigated at airspeeds up to 290 miles per hour, air total temperatures from -15 to 20 degrees Fahrenheit, water contents up to 1.0 gram per cubic meter, and angles of attack of 0 and 4 degrees.

Report presenting an investigation of the ejection release characteristics of the MB-1 rocket from the missile bay of a model of the Convair F-106A airplane with its fin tips retracted at a simulated altitude of 18,670 feet. Successful ejections of the rocket were made at supersonic speeds by applying a combination of ejection velocity and nose-down pitching moment at release.

Memorandum presenting an investigation of a flight version of the NACA heated-wire liquid-water-content instrument, which was constructed and flight tested in natural icing conditions. Data obtained simultaneously with rotting multicylinders indicated that reliable flight measurements of liquid-water content could be made with the heated-wire instrument.

Memorandum presenting an experimental investigation on a production-model turbojet engine modified by the substitution of special combustors and air-cooled turbine stator and rotor assemblies to determine some of the problems pertinent to the operation of air-cooled engines at turbine-inlet temperatures over 2200 degrees R. The investigation was conducted in an altitude chamber at simulated altitudes of 50,000 and 60,000 feet and a simulated flight Mach number of 0.8. Results regarding the combustion system, turbine stator, turbine rotor blades, turbine disks, and tailcone and other engine parts are provided.

Memorandum presenting a high subsonic Mach number turbine with high suction-surface diffusion investigated experimentally. The subject turbine was designed for a high weight flow per unit frontal area, a high specific work output, and a relative critical velocity ratio of 0.82 at the rotor hub input.

Report presenting summaries of full-scale engine tests of pentaborane, pentaborane-JP-4 fuel mixtures, and trimethylborate-methyl-alcohol-azeotrope fuels. Tests were conducted at an altitude of 50,000 feet and Mach number of 0.8. Results regarding the fuel effects on overall performance, effects on component performance, effect of turbine-outlet temperature on engine performance, and miscellaneous observations are provided.