From introduction: "This report presents the apparent viscosities of supernate-sludge slurries prepared synthetically to simulate the conditions known to exist in the waste storage tanks, but with fission products and plutonium absent."

The following report examines methods to determine uranium nitrate hexahydrate on pretreated hexone in the range of 0 to 40 g./l. by infrared absorption measurements.

Objective: "The observations summarized in the present report were made to determine the stability of ferrous and sulfamate ions and sulfamic acid in RA Column scrub solution (RAS) and in aqueous solution comparable to the RA Column feed tee composition (RAFS). Knowledge of the stability of the reducing agent (ferrous iron) is necessary to properly plan the method of preparation and introduction of this component into the RA system and to assure dependable and reproducible performance."

This report presents the final results from the investigation of the ratio of Pu-239 fission cross section to U-235 fission cross section. Three sets of plutonium and uranium foils were prepared at KAPL and were investigated to acquire the final results.

From summary: "The relative absorptions of X-rays by various substances are listed as a guide to the application of the X-ray photometric method in chemical analysis and to the estimation of interference by extraneous substances."

This report follows an investigation of a cargo truck found contaminated by various radioactive material on a routine trip from Arco, Idaho to the Hanford plant on May 8, 1952. The report analyzes the truck's route in an attempt to find the location of the contaminating region.

Summary: A method was found for determining calcium concentrations in TBP process streams in spite of serious interferences bysodium, ferrous, uranyl, sulfate, phosphate, and sulfamate ions as well as by TBP. The precision attainable varied from sample to sample, depending upon its composition. In general, errors of 20% or greater occurred. The smallest determinable amount of calcium was about 10 mg/1.

This report discusses the settling rates and properties of 101-U sludge when slurried with increasing amounts of synthetic supernatant.

From introduction: "In this report an attempt was made to summarize the results of recent research on the effective height of smoke stacks. In this summary attention is paid only to the case in which the density of the stack effluent is the same as that of the surrounding air."

From introduction: The present report describes further refinements of the apparatus and the method to meet a need for a sensitive determination of carbon in plutonium.

Report summarizing data from Purex tests for pulse column specifications. These test results were used to estimate pilot plant specifications.

The following report describes work carried out to investigate whether the Hanford IB column as designed in a previous report will decontaminate the uranium adequately from plutonium, particularly if there's any slowness in either the rate of reduction or transfer of the plutonium.

This report describes an improved infrared absorption method to analyze aqueous samples and TBP after extraction. The method described in the following pages is the carbon tetrachloride extraction method.

The following report provides data from corrosion tests meant to evaluate the performance of Type 3098Cb stainless steel in BiP04 process dissolver solution containing mercuric ion.

"The attached report summarizes the work performed in the establishment of an improved spectrographic method for determining iron in plutonium."

An improved method of water plant control has been developed at Hanford which employs a sensitive turbidiy measuring microphorometer and a model water filtration plant. The microphotometer operates on a light scattering principle and is accurate in the range of 0.0 to 0.1 parts per million turbidity. The model filter plant used is a five gallon per minute plant which can simulate the conditions normally occurring in the large water plants. It is the purpose of this report to describe the model filter plant and to demonstrate the value of the model and microphotometer for effective water plant control and water plant design scoping.

This paper is a preliminary report of experiments being carried out on the compaction of UO₂ powders by swaging within a restraining tube. Various types of UO₂ have been tried with resulting apparent densities as great as 9.89 grams per cubic centimeter.

Different methods of decontaminating plutonium contaminated skin were studied by contamination localized areas of pig skin and then testing the different decontamination methods. Results indicate that the most effective of the decontamination methods tested involved the application of a plastic adherent material to the skin and its later removal by peeling.

Much attention has been given to the application of zirconium and zirconium alloys to process tubing for reactors. The properties of this material which make it attractive for such use are, as compared to aluminum: lower neutron absorption; higher design strength; and better corrosion resistance in hot water. Installation of process tubes in HAPO reactors requires that gas tight and water tight joints be maintained between the gunbarrel and process tube, and the process tube and nozzle, respectively. With aluminum tubes this is accomplished by forming a Van Stone flange at the ends of the tube and clamping the flanges between the gunbarrel and nozzle with suitable gasketing. No changes would be required in the existing pile components to install zirconium or zirconium alloy tubes if Van Stone flanges could be formed on these tubes. other methods have been tested, however, which eliminate the necessity for a flange. These will be discussed later.

This paper describes the measurement of control rod strength in the PCTR. The first section outlines the theory and method of such a measurement, and the second section presents the results of the measurement of the Experimental Gas Cooled Reactor (EGCR) control rod strength. The reactor parameter actually inferred is the difference in the infinitive multiplication factor for a control rod supercell with and without the control rod in place in the supercell. These measurements are, therefore, very closely related to the measurement of k∞ for an ordinary lattice cell.

High speed data handling and computing systems are coming into increasing use in the automatic control of complex industrial processes. One of the next significant developments in reactor design is believed to be the application of high speed data handling and control systems to nuclear reactors. This document is a study of such a system intended for use with the Plutonium Recycle Test Reactor.

These initial operating procedures have been prepared for interim use during the first operation of Basins I, II, and III. They will be revised and included in the operating manual for the entire 105-C Metal Examination Facility.

This article presents data on the effects of gamma radiation on the physical properties of a number of different classes of plastics materials of construction which were screened to determine their capabilities and limitations for service in applications where ionizing radiation exists. The irradiations were carried out in air at ambient temperature at normal atmospheric pressure to various gamma radiation doses up to 1*10^9 r depending upon the stability of the materials to radiation exposure. The different classes of materials and materials within a class are compared.

The design of NPR shows large quantities of carbon steel pipe and fittings in the front and rear face areas. These are also the area where the most work must be done during an outage, and consequently lower radiation levels are needed here than elsewhere in the piping system. A single pass decontamination of the front and rear piping without going through the entire loop is desirable. Because of the quantities of chemicals and available down time, an effective shorty interval process is needed. This report gives some recent laboratory data on this subject.