This report discusses methods of producing aluminum nitrate for the Redox process. Large amounts of aluminum nitrate are consumed during the Redox process, so this report explores preparation of this material through the dissolution of hydrated aluminum oxide in nitric acid.

Introduction: "This report is an expanded version of the regular monthly letter report and is prepared in this form with the intention of reviewing work on the subject program for Euratom technical personnel. Work performed during the month of September, which normally constitutes the entire letter report, has been condensed under one heading."

Abstract: "A simple solution to Saha's equation has been obtained. The method of solution involves iteration with respect to the electron pressure or concentration and can be applied to the simultaneous calculations of any number of ions. Sample results are given for lithium and aluminum."

Introduction. It has been known for a long time that thorium is precipitated by oxalic acid in acid solutions, but a survey of the literature showed no study of the limits of the acidity and oxalic acid excess which yield quantitative results. V. I. Spitzin reports on the solubility of thorium oxalate in varying concentrations of several acids, but the effect of an excess oxalic acid is not included. Since solutions are sometimes presented for analysis that contain more than the recommended two per cent mineral acid, it would be advantageous to be able to quantitatively remove the thorium without otherwise altering the solutions. This was especially of interest in solutions containing bismuth, since it was hoped that some amounts of thorium could be precipitated in nitric acid solutions containing large quantities of bismuth. In removing the bismuth, first by a bismuth oxychloride precipitation, thee is every opportunity for carrying of the thorium.

The following report describes and foretells the situation in medium in which neutrons are being (a)produced as fast neutrons, (b) slowed down to thermal speeds by impacts with nuclei, and (c) absorbed by nuclei in such a manner that sometimes fresh fast neutrons appear at the place where a thermal neutron has just appeared.

Abstract: An analysis of SM-1 Core II and SM-1A Core I zero power experiments was made by comparing these cores to each other and to AM-1 Core I on the basis of critical bank positions, bank calibrations and available chemical analyses of the fuel plate compositions. The effects of replacing boron absorbers by europium absorbers upon rod worth and stuck rod conditions were studied. Comparisons of measured and calculated power distributions were made. It was concluded that both SM-1 Core II and SM-1A Core I contain nearly identical B-10 loading of 17.79 grams, compared to the best estimate of 15.75 grams for SM-1 Core I. The available data indicates that all three cores possess similar nuclear characteristics.

Introduction. the conventional procedures of analysis for uranium and manganese can be employed in the analysis of alloys of these metals. The alloys are reacted with perchloric acid and hydrogen peroxide, fumed to remove any chloride ions, diluted to volume and aliquots analyzed by redoximetry.

In a continuation of the study of the properties of the φ meson we have roughly doubled the available data on the φ production via the reactions [equations were not transcribed]. The data discussed here was obtained in the Brookhaven National 20" Hydrogen Bubble Chamber exposed at a separated beam of K- of 2.24 Gev/c.

Leaching investigations on low grade Belgian Congo uranium ores and recovery of uranium from acid leach solutions by uranous phosphate precipitation, uranyl phosphate precipitation and by sodium carbonate retreatment of alkali precipitates are described.

This document presents a set of machine-computed curves involving a wide range of Kb and Kc, from which both thermal and resonance values of (E-1) may be obtained.