The following report describes the welding characteristics of several high-strength stainless steels that were considered for use as a pressure vessel to operate at high pressures at 800 F.

None

Letter opinion issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, John Ben Shepperd, regarding a legal question submitted for clarification;Constitutionality of the form of Senate Bill No.1 as amended by the House Committee on Appropriation.

None

Introduction: "Because of the importance of the value of the transport mean free path of thermal neutrons in deuterium oxide, Kash and Woods proposed to redetermine this value in deuterium oxide (99.4 atom-percent deuterium, by an extrapolation method. Kash and Woods thought that the low value of the transport mean free path might be a source of error. This paper relates studies of procedures by which (1) boron material would be dissolved in high content deuterium oxide without adding foreign atoms, particularly hydrogen atoms which might adversely affect the test, (2) the boron content of the deuterium oxide solvent may be determined, (3) ion exchangers may be deuterized and de-deuterized, and (4) ion exchange may remove specific ions from solution."

Report presenting an investigation at Mach number 1.61 to determine the effect of 10-percent control are attached tabs on the hinge-moment characteristics of a trailing-edge flap-type control on a trapezoidal wing with a 23 degree sweptback leading edge, aspect ratio of 3.1, and taper ratio of 0.4. Results regarding hinge-moment coefficients, tab parameters, and control effectiveness are provided.

"A comparison is presented between the experimentally measured and theoretically calculated (by the method of NACA TN 3067) rates of roll of two rocket-propelled models with flexible rectangular wings. The comparisons show that although there are large aeroelastic losses in rolling rate, the theory predicts the actual rate of roll accurately" (p. 1).

Report presenting ramjet engine performance data over a range of engine design variables to permit selection and evaluation of a ramjet engine configuration for a long-range supersonic missile. Results include engine thrust, drag, fuel consumption, area ratios, and weight, and are suitable for use in design studies of missiles incorporating either internally or externally mounted ramjet engines.

"Free-flight drag measurements are presented which show the practicability of duplicating the zero-lift drag rise of many airplane configurations by simple bodies of revolution. The results confirm the transonic area rule for straight wings, and for delta and modified-delta wings with and without nacelles. The results showed that the area rule did not apply to one swept-wing configuration and an explanation is advanced to explain why it does not apply" (p. 1).

From Summary: "As part of an overall program for the experimental investigation of large-scale jet nozzles, a preliminary evaluation of the internal performance characteristics of several variable-throat extended-plug-type nozzles was obtained over a range of nozzle pressure rations from 2 to 15 with nozzle throat variations as great as 2:1. The extended-plug nozzle attained peak thrust coefficients as high as those which have been attained with fixed-geometry convergent-divergent nozzles. The thrust coefficients of the extended-plug nozzles were relatively insensitive to both nozzle pressure ratio and throat area over the range investigated."

Report presenting an investigation at a Mach number of 1.61 to determine the control effectiveness characteristics of seven tip controls on a 60 degree delta wing. Pressure distribution measurements were made for a range of angles of attack and control deflections. Results regarding the effect of control deflection, effect of wing angle of attack, effect of hinge-line location, effect of fences, and effect of control size and location are provided.

"The explosion limits of five alkylsilanes were determined as a function of temperature and composition at a pressure of 1 atmosphere. Over a fuel concentration range of 2 to 10 percent, the lowest temperatures (zero C) below which explosion did not occur for the five fuels studied were: tetramethylsilane (CHsub3)sub4Si, 450 degrees; trimethlysilane (CHsub3)sub3SiH, 310 degrees;dimethylsilane (CHsub3)sub2SiHsub2, 220 degrees; methylsilane CHsub3SiHsub3, 130 degrees; and vinylsilane Hsub2C=CH-SiHsub3, 90 degrees. Explosion limits for hydrocarbons analogous to these silanes fall in a temperature range of 500 degrees to 600 degrees C" (p. 1).

Report presenting an investigation in the 16-foot transonic tunnel to determine the effects of leading-edge slats on the aerodynamic and longitudinal stability characteristics of a model of a swept-wing fighter-type airplane. Two different spanwise extents of leading-edge slats were tested, from 35 to 95 percent semispan and from 46 to 95 percent semispan. Results regarding the lift characteristics, drag characteristics and lift-drag ratios, stability characteristics, and flow-study pictures are provided.

Report presenting an investigation to determine the effects of horizontal-tail location and plan form on the longitudinal stability and control characteristics of a fuselage and thin delta wing with extended double slotted flaps. Several configurations of the aircraft, including flaps with the tail off, extended double slotted flaps, and canard with extended double slotted flap and delta tail are explored.

Report presenting zero-lift drag data obtained on a series of eight fin-stabilized bodies with noses of fineness ratio 3 and differing nose shape by launching them from a helium gun. The nose shapes explored included a cone, x exp(3/4), x exp(1/2), parabolic, (3/4)P, (1/2)P, L-V Haack, and Von Karman. The results are compared with theoretical calculations and wind-tunnel measurements.

"An investigation of the effect on transonic and supersonic drag of a fuselage protuberance designed to improve the overall longitudinal distribution of cross-sectional area of an essentially unswept wing-fuselage combination has been made with free-flight rocket models. The wing-fuselage configuration was tested with and without a fuselage protuberance designed to relieve the steep area gradient over the rear portion of the wing" (p. 1).

Report of an investigation to determine the effects of inboard plan-form modifications on two unswept wings at Mach numbers 1.61 and 2.01. The only difference between the two wings was the spanwise thickness distribution. The modifications were performed by means of inserting sections that linearly extended the local chord from the 40 percent semispan station to the model center line.

Report presenting an investigation on a full-scale afterburner test rig and two turbojet-engine afterburner configurations to determine criteria for the design of fuel systems for afterburners. The effect of fuel-air ratio distributions at the flame holder on combustion performance was obtained along with the effects of variation in design variables on the ratio distributions.

From Introduction: "The investigation is discussed in the present report is an analysis of the turbojet engine as the power plant for bombers capable of supersonic flight speeds. A similar analysis, in which the turbojet engine is considered for the propulsion of supersonic fighter aircraft, is presented in reference 1. Two plans are considered in this report."

From Introduction: "The ram-jet missile studied in the present report is one type of shieldless which has the advantage of employing the simplest type of propulsion system."

"The flame velocities were measured of 20 percent oxygen and 80 percent carbon monoxide mixtures containing either light water or heavy water. The flame velocity increased from 34.5 centimeters per second with no added water to about 104 centimeters per second for a 1.8 percent addition of light water and to 84 centimeters per second for an equal addition of heavy water. The addition of heavy water caused greater increases in flame velocity with equilibrium hydrogen-atom concentration than would be predicted by the Tanford and Pease square-root relation" (p. 1).

From Summary: "Total vapor pressures were measured for 16 acid mixtures of the ternary system nitric acid, nitrogen dioxide, and water within the temperature range 10 degrees to 60 degrees Celsius, and with the composition range 71 to 89 weight percent nitric acid, 7 to 20 weight percent nitrogen dioxide, and 1 to 10 weight percent water. Heats of vaporization were calculated from the vapor pressure measurements for each sample for the temperatures 25, 40, and 60 degrees Celsius. The ullage of the apparatus used for the measurements was 0.46. Ternary diagrams showing isobars as a function of composition of the system were constructed from experimental and interpolated data for the temperatures 25, 40, 45, and 60 degrees C and are presented herein."

Corrosion of aluminum front cap supported shielding slugs has been noted at all reactors except C Reactor which has galvanized shielding pieces. There has been a considerable amount of difficulty caused by sticking of the places. The difficulty is caused by the growth of corrosion products in the annulus around the shielding piece which affectively siezes it. As recently as June, 1953 the shielding pieces on nearly 50 per cent of a group of 40 tubes at B Reactor were corroded to the extent that a pipe wrench was required for their removal. Similar instances, to varying degrees, have occurred at all reactors except C.The purpose of this test was to evaluate the radiation affects of removing the front shielding pieces as part of a program to eliminate the sticking problem.

Abstract: "The cross section for this reaction is calculated for three Hulthen deuteron wave functions. A hard core in the deuteron at one-half meson Compton wavelength reduces the total cross section and flattens the angular distribution in the backwards direction in agreement with experiment."