Report presenting a comparison of three hypervelocity vehicles: a ballistic rocket, a skip rocket, and a rocket glider. Range efficiency, automatic heating, and problems of glide rockets are explored.

From Summary: "Experimental force, moment, and center-of-pressure variations for a large number of bodies of revolution have been compared with the calculated characteristics based on the approximate theory developed in NACA-RM-A9I26. The bodies varied in fineness ratio from 4.5 to 21.1, from blunt unboattailed bodies to airship hulls, and the experimental results are given for widely varying Mach number ranges of angle of attack. It is shown that the lift and drag characteristics are fairly accurately predicted by the theory but that the actual center of pressure is more rearward than the theory indicates."

Memorandum presenting flight tests conducted on two straight-wing jet airplanes of generally similar configuration, one exhibiting a diving tendency and the other a climbing tendency, in order to investigate the cause for the particular type of behavior of each airplane at high Mach numbers. The results showed that the diving tendency experienced by the one airplane was due to the predominant effect of an increased angle of attack of the horizontal tail.

Report presenting an investigation of an NACA submerged inlet operating over a range of mass-flow ratios and oncoming flow angles through a range of Mach numbers by use of a transonic bump. Results regarding the ram-recovery ratio, pressure distributions, and tuft studies are provided.

From Introduction: "The engine evaluation of blends reported herein was conducted at the NACA Lewis laboratory. The data contained in references 2 to 14 are therefore summarized and the effect of the molecular structure of fuels on antiknock performance is shown in herein."

Report presenting an experimental investigation performed to determine the effect on base and forebody pressures of using a sting modified with varying length splitter plates and fins instead of a conventional sting to support a cone-cylinder body of revolution.

Memorandum presenting the results of a wind-tunnel investigation of the damping in pitch of a model triangular wing with an aspect ratio of 4 combined with a slender pointed body. The investigation was conducted at Mach numbers from 0.10 to 0.95 for Reynolds numbers of 550,000 and 1,250,000 with additional data obtained at Reynolds numbers of 3,000,000 and 6,000,000 at Mach number 0.23. Results regarding the effects of oscillation amplitude, Mach number, Reynolds number, angle of attack, frequency, and pitching axis position are provided.

An investigation was made of the variation of the pressure limits of flame propagation with tube diameter for quiescent propane with tube diameter for quiescent propane-air mixtures. Pressure limits were measured in glass tubes of six different inside diameters, with a precise apparatus. Critical diameters for flame propagation were calculated and the effect of pressure was determined. The critical diameters depended on the pressure to the -0.97 power for stoichiometric mixtures. The pressure dependence decreased with decreasing propane concentration. Critical diameters were related to quenching distance, flame speeds, and minimum ignition energy.

From Introduction: "In the present investigation, lift, drag, and pitching moment were determined over a Mach number range 0.6 to 1.42. Smooth-water takeoff and landing stability and resistance were investigated. A brief check of the rough-water spray and behavior was also made."

"A supplementary investigation has been conducted in the Langley 20-foot free-spinning tunnel on a l/24-scale model of the Grumman F11F-1 airplane to determine the spin and recovery characteristics with alternate nose configurations, the production version and the elongated APS-67 version, with and without empty and full wing tanks. When spins were obtained with either alternate nose configuration, they were oscillatory and recovery characteristics were considered unsatisfactory on the basis of the fact that very slow recoveries were indicated to be possible. The simultaneous extension of canards near the nose of the model with rudder reversal was effective in rapidly terminating the spin" (p. 1).

Report presenting an investigation of the performance of slurry fuels consisting of 50 percent magnesium powder in a hydrocarbon carrier in a flight-type, 6.5-inch-diameter ramjet engine mounted in a connected-pipe facility. Results regarding the slurry performance and a comparison of slurry and ethylene performance are provided.

Report presenting measurements in a wind tunnel of the static and dynamic-rotary stability derivatives of a model with an unswept wing of low aspect ratio and a high horizontal tail. Tests were conducted at a range of Mach numbers and angles of attack. Results regarding a variety of aerodynamic characteristics are provided.

Memorandum presenting the effects on combustor performance of operation at the high inlet-air pressures, temperatures, and velocities representative of conditions that may be encountered in high-pressure-ratio turbojet engines or at high flight speeds studied in a single tubular combustor. Some of the performance characteristics investigated were combustor-liner temperatures, carbon deposition, smoke formation, and combustion efficiency.

Report presenting an analysis of the causes of compressor stall and flame-out when armament is fired during flight at high altitudes. Experimental data are also presented. The increase in compressor-inlet temperature during armament firing was found to be the most important single factor affecting engine performance.

From Summary: "As part of an overall program for the experimental investigation of large-scale jet nozzles, a preliminary evaluation of the internal performance characteristics of several variable-throat extended-plug-type nozzles was obtained over a range of nozzle pressure rations from 2 to 15 with nozzle throat variations as great as 2:1. The extended-plug nozzle attained peak thrust coefficients as high as those which have been attained with fixed-geometry convergent-divergent nozzles. The thrust coefficients of the extended-plug nozzles were relatively insensitive to both nozzle pressure ratio and throat area over the range investigated."

Tests of a 1/5 scale model of a proposed 153-foot high-speed submarine have been conducted in the Langley full-scale tunnel at the request of the Bureau of Ships, Department of the Navy. The test program included: (1) force tests to determine the drag, control effectiveness, and static stability characteristics for a number of model configurations, both in pitch and in yaw, (2) pressure measurements to determine the boundary-layer conditions and flow characteristics in the region of the propeller, and (3) an investigation of the effects of propeller operation on the model aerodynamic characteristics. In response to oral requests from the Bureau of Ships representatives t hat the basic data obtained in these tests be made available to them as rapidly as possible, this data report has been prepared to present some of the more pertinent results. All test results given in the present paper are for the propeller-removed condition and were obtained at a Reynolds number of approximately 22,300,000 based on model length.

Performance of a J47D (RX1-1) turbojet engine equipped with afterburner, variable-area exhaust nozzle, and integrated electronic control was determined over a range of flight conditions. These data were obtained with the electronic control both operative and inoperative. For operation with scheduled exhaust nozzle area, the minimum specific fuel consumption of 1.15 pounds of fuel per hour per pound of net thrust occurred at about 7200 rpm at altitudes from 5000 to 25,000 feet at a flight Mach number of 0.19.

Report describing an investigation conducted with a single combustor from a J47 turbojet engine using weathered aviation gasoline and several spark-plug modifications to determine altitude ignition, acceleration, and steady-state operating characteristics. Results regarding ignition, acceleration, altitude operational limits, combustion efficiency, and pressure loss are provided.

Report presenting pressure-distribution data for a drooped-nose-fuselage forebody alone and with four canopy shapes mounted on the forebody. Two canopies had the same shape and size rearward of the windshield but one had a flat and one had a v-shaped windshield, and the other two canopies were located at different body sections with smaller maximum cross-sectional areas, higher fineness ratios, and flat windshields. Results regarding the effect of windshield shape, canopy location, Mach number, sideslip, and angle of attack are provided.

Report presenting testing of a 4.5 inch by 4.5 inch tunnel with slots in two opposite walls in order to determine the effects of various slot exit shapes, mixing sections, and diffusers on power requirements. Some of the data obtained included measurements of the pressure ratio required to operate the tunnel, the effects of auxiliary bleed flow, diffuser static-pressure ratios and distributions, and diffuser total pressure distributions.

Memorandum compiling summaries from NACA reports on fuel that were published between July 1945 and 1952. The summaries are intended to be detailed enough to eliminate the need to obtain the complete report.

Report presenting a study and experimental investigation on the pressure rise across shock waves required to cause separation of the boundary layer on a flat plate. The interaction of shock wave and boundary layer was investigated experimentally when the boundary layer was caused to separate from the surface of a tube. Results regarding testing and correlation with other results are provided.

From Introduction: "Range in more or less steady level flight depends directly on aerodynamic lift-drag ratio at high supersonic speeds, just as it does at lower speeds. This result follows from the classical Breguet range equation in the case of powered flight, and it may be easily deduced from the equations of motion for unpowered or gliding flight (see refs. 1 and 2)."

Report presenting an investigation to determine the effects of inlet-annulus blockage on compressor performance and its corresponding effect on the computed performance of a hypothetical engine. The hypothetical engine performance was calculated from the overall compressor performance and assumed component performance characteristics. Results regarding the compressor performance with no inlet blockage, effect of hub blockage on compressor performance and stall characteristics, effect of sector blockage on compressor performance, effect of hub blockage on computed engine performance, and design and control problems are provided.