Abstract: "Thirty-four uranium ingots containing controlled amounts of carbon, nitrogen, and Mgl2 slag were cast, rolled, and examined to investigate the relation between these impurities and the quality of the rolled rod. Carbon in concentrations up to 1400 ppm and nitrogen up to 170 ppm, either singly or in combination, had no significant effect on the number of defects observed in the rolled rod. The quality of the rods, however decreased with increasing amount of slag necessary to cause observable differences in the rod could not be detected on analysis, but was visible in the microstructure."

Originally issued as S and P 1963A, Parts I and II. This report covers a design and feasibility study of a pebble bed reactor-steam power plant of 125 megawatt electrical output. The reactor design which evolved from this study is a two-region thermal breeder, operating on the uranium-thorium cycle, in which all core structural materials are graphite. Fuel is in the form of unclad spherical elements of graphite, containing fissile and fertile material. The primary loop consists of the reactor plus three steam generators and blowers in parallel. Plant design and system analysis including cost analysis and capital cost summary are given.

From abstract: "This report presents the progress in the laboratory development of a continuous solvent recovery process for the tributyl phosphate-diluent mixture used in the Purex Process. Investigations were made with 1/2" diameter pulse columns, using a nine foot sodium carbonate contacting column and a four foot water wash column."

From abstract: "The following report presents a summary of operating experience with decelerating receivers for ion beam reception. Sample calculations for design of such a receiver for the isotopes of lithium are presented. Estimates of maximum production and requirements to attain such production are given. The maximum ion beam envisioned is 17 amperes obtained from extrapolation of experimental results."

Technical report presenting preliminary results obtained in the static corrosion test program to screen promising construction materials for a proposed liquid fuel power breeder reactor.

Technical report investigating the distribution of rare earth elements between a liquid bismuth-uranium solution and fused KCI-LiCi mixtures. Report warrants further research on the liquid bismuth-uranium-fused salt system due to the benefit of continuous fission removal processes.

Technical report describing the Brookhaven National Laboratory nuclear reactor and the physical studies of heat transfer and efficiency conducted to improve nuclear reactor operations.

From introduction: "The work described in this report was carried out as part of the feasibility study (ORNL-117) of a supercritical water reactor (SCWR) for use in nuclear propulsion of aircraft. The object of this work was to study the dynamic behavior of a particular design of supercritical water reactor. Numerical results are presented in Appendix I."

Abstract: "Probes were used to measure certain properties of the cloud of positive ions and electrons ejected from a pulsed ion source having two hydrogen-loaded electrodes. Time-of-flight measurements show: the presence of H+ ions with 50 ev directed energy; an increase of this energy with increasing pulse current in the source; a higher peak yield of ions with higher peak currents in the source; and higher yields and higher ion energies up to 110 ev have been recorded with the use of a pulsed magnetic field impressed upon the source. The neutral positive ion-electron beam from the source has been projected against an increasing magnetic field and the reflected and transmitted signals have been recorded and compared as a function of the magnetic field. Probe signals from the plasma as it encounters the magnetic field are oscillatory, suggesting that magnetohydrodynamic phenomena are presented."

Abstract: "The reflections of microwaves from the walls of a plasma-containing vessel are studied. The probable cause of the reflections is discussed, and several suggestions are made for eliminating the reflections from the waveguide in the vessel and particularly from the pyrex vessel wall and copper tubing surrounding the pyrex. Quarter-wave-thick carbon-filled plastics or glasses having a very low vapor pressure room most promising when placed inside the pyrex cylinder. BaTiO3 appears to be an excellent material when placed outside the vacuum."

From abstract: A team consisting of R. A. Lindblom, S. A. Mayer, R. G. Young, W. L. Chenoweth, R. F. Droullard, and I. T. Fisk made a reexamination of the Anderson mine (Uranium Aire) of Interstate Oil and Development located near Wickenberg in Yavapai County, Arizona. The field examination was made from August 22, 1958 to September 2, 1958. This team was formed to resolve differences between company and AEC ore reserve estimates. A cooperative effort in which the company supplied labor, limited additional drilling and both parties were in attendance during the sampling resulted in the collection of additional data. Special attention was given to assessing the in-hole assaying with radiometric equipment by IOD and AEC, evaluation of tonnage factors, moisture content, continuity of ore, and current mapping of stripped and mined areas.

Abstract: This report outlines the general techniques developed for replacement of PRE in-cell equipment or equipment components.

Abstract: This report presents a description of the Organic Moderated Reactor Experiment (OMRE), of the hazards associated with this experiment, and all of the safeguards taken to ensure the safety of the operating personnel and the population of the surrounding area.

Abstract: Testing of the Natural Circulation Steam Generator has been conducted with the Sodium Reactor Experiment. A necessary modification of the original feed-water control system was utilized.

Introduction: During the year 1952-1953, research on the Boulder batholith program was largely devoted to basic mineralogy studies of the "siliceous reef" and, to the extent possible at that time, the "base metal" deposits.

From abstract: The response of the reactor to forced oscillations has been investigated with the pile oscillator technique and the data are presently being analyzed.

"An investigation of the chemical effects of 1-Mev electrons on BrF3 at 25 degrees C has been carried out. Pressure measurements taken during the irradiation suggest the presence of Br2 and BrF5 as decomposition products and a fractional distillation of the irradiated liquid confirmed their presence. The extent of decomposition was determined both by fraction distillation and spectrophotometric methods. The radiation effect seemed to reach saturation when approximately 10 per cent of the BrF3 was destroyed. The exposure necessary for the decomposition products to reach a concentration of half the saturated value was calculated to be 2.7 microampere hours/cc BrF3 while the "G" value was found to be 1.5. A qualitative comparison of irradiation dosages from the Statiltron with that expected from spent fuels revealed that little decomposition of BrF3 reagent is to be expected from 1-say cooled Hanford fuel (in pile for 100 days) while in the case of 1-day cooled MTR type fuel (in pile for 12 days) a saturated effect might be realized in 1-3 hours. Since at most only 10 per cent of the BrF3 is destroyed it is concluded that BrF3, from a radiation resistance standpoint, is a suitable standpoint, is a suitable reagent for …

"The Atomic energy Commission has undertaken a development program to provide the technology needed for the evaluation and economic design of nuclear power plants. This program is to be carried out during the next five years at several national laboratories and industrial organizations. The Sodium Graphite Reactor (the SGR) is one of those to be investigated and experimentally tested as part of this 5-year effort. The program on the SGR is intended to expand our area of information covering sodium-graphite technology, experimentally demonstrate the feasibility of this reactor complex and extend its performance limits, and apply in information developed to designs suitable for the full-scale nuclear power plant. As a principal part of this program, a Sodium Reactor Experiment (the SRE) is to be constructed and operated; it will be the major experimental facility in which the performance of this reactor will be studied and new technological advances tested. This report continues an earlier series 2-7 in which previous work on the SGR and the SRE has been described. In this report, the progress on the program is described in two main sections. Section A is devoted to work relating to the general technology of Sodium Graphite Reactors, and to …

Abstract: "Most of the Nuclear Merchant Ship Reactor (NMSR) shield design work performed by The Babcock & Wilcox Company (B&W) is summarized. Primary and secondary shield results are presented, consistent with contractual requirements and designated design criteria. Methods of calculation and basic parameters are shown" (p. 1).

This report contains a description of the reactor plant portion of the Enrico Fermi Atomic Power Plant, with emphasis on the reactor system. Since this plant contains a developmental reactor, emphasis has been placed on reactor safety and on achieving reliable operation. The design is conservative and is flexible enough to permit incorporation of the results of developmental programs, which include nonnuclear, full-scale component test facility operations, and nuclear experiments, such as critical experiments.

From abstract: Liquid alkali metals were circulated in a series of structural alloy loops under reactor radiation at high temperature. The first of these loops was a lithium-stainless steel (type 316) system, and the remainder were sodium-Inconel. No effect of radiation other than radioactivation was found. Mass transfer and metallurgical processes attributable to the operating temperatures were observed."

From abstract: A conceptual design study has been performed for a sodium cooled, graphite moderated, thermal power-breeder reactor utilizing the Thorium-Uranium 233 breeding cycle. Several aspects of the design of the system are considered but no attempt has been made to supply all the details. It appears that the design presented is feasible and will allow the production of economic power as well as full utilization of thorium resources.

Introduction: The purpose of this experiment was to demonstrate that a liquid metal heat transfer system could be built and operated at very high temperatures.

Design and operational techniques are described for a freeze seal type centifugal pump for use in the Sodium Reactor Experiment.