Report issued by the Argonne National Laboratory over design studies conducted on Argonaut reactors for training and research purposes. As stated in the abstract, "the design presented in the form of a steady-state analysis based upon the small-signal linearization of the reactor kinetics transfer function. The measured controller performance and construction details of the equipment is given" (p. 7). This report includes tables, illustrations, and photographs.

Report issued by the Argonne National Laboratory covering a summary report of the work conducted by the Idaho Division. Experimental work and progress made on reactors are presented. This report includes tables, illustrations, and photographs.

Report issued by the Argonne National Laboratory discussing a summary report of the Particle Accelerator Division. As stated in the summary, "this report outlines two methods applicable respectively to longhand and computer calculations" (p. 4). This report includes tables, illustrations, and photographs.

From introduction: "The report is preliminary. At the time of writing, the status of the BORAX V project is that design of the reactor buildings and plant, done in collaboration with the architect-engineer with the architect-engineer has been completed and construction has just started; however, the mechanical design of the fuel and cores is still tentative."

Report describing "an AC-operated portable scintillation spectrometer consisting of a preamplifier, a linear pulse amplifier, a single-channel pulse-height analyzer, a linear count-rate meter, a scaler, and a high-voltage power supply. The operation and performance of the circuits are discussed" (p. 3).

From Introduction: "An experiment, designated MTR-W10, was designed to determine the effects of high burnup on the cladding and fuel of an aluminum-1% nickel alloy (M-388)-clad ceramic pellet-fuelded plate if the type manufactured at Argonne for the BORAX-IV core. Conditions of irradiation were selected to allow local boiling at the high flux end of the plate at a pressure of 600 psig."

Report issued by the Argonne national Laboratory discussing a technical and economic evaluation of a direct-cycle light-water boiling reactor designed for natural circulation and internal steam-water separation. The reference 100-Mw(e) reactor power plant design evolved from the study should have the best chance (compared to similar plants) of approaching the 8 to 9 mill/kwh total power-cost level. This report includes tables, and illustrations.

Report issued by the Argonne National Laboratory discussing irradiation tests of an aluminum alloy-clad, aluminum-uranium alloy fuel plate. As stated in the introduction, "calculations were made to determine the lowest possible pressure which would allow the maximum possible local boiling on the plate and still assure a margin of safety against burnout" (p. 9). This report includes tables, illustrations, and photographs.

Report describing the design of a Fast Fuel Test Reactor (FFTR), analyses of of the reactor's operations, related costs, and possible future projects.

From Introduction: "This report describes tests conducted on EBWR to evaluate the vapor recovery system."

From Introduction: "This hazards report covers the basic modifications to the EBWR plant as designed to increase the present operating design rating of 20 Mwt to a new rating of 100 Mwt. it is written as a supplement to ANL-5781 (the original hazards report) and follows the outline of that report for purposes of cross reference."

Report that provides "an understanding of the status of gas-cooled reactors as used for unclassified applications" and determining "phases of advanced research and development needed in the field and from these to recommend a program for high-temperature, gas-cooled reactors" (p. 5).

Report issued by the Argonne National Laboratory over studies conducted on designs for a lunar power plant. As stated in the abstract, "a concept of a nuclear power plant to be assembled on earth and operated on the moon in presented" (p. 9). This report includes tables, illustrations, and photographs.

From Introduction: "This report is a documentation, from inception in 1959 to termination in 1960, of the design and development effort by the Reactor Engineering Division pertinent to construction of an aqueous boiling slurry reactor design, the problems involved, and the various approaches pursued."

From Introduction: "This report summarizes the activities of the OEEC Halden Reactor Project, Halden, Norway, during the period of participation in the project by the author, from May 21, 1959 to September 22, 1960. The review is presented here in the interest of completeness of this report, in an effort to provide an impression of the character of research being carried out at Halden."

This seventh Annual Report is a summary of some of the progress in scientific and engineering research and development carried on at Argonne National Laboratory during 1961. As is customary in this series, only those portions of the total program that have reached such a stage that they may be of general interest are recorded. Thus, a comparison with the Annual Reports for 1959 (ANL-6125) and for 1960 (ANL-6275) will reveal the description of a generally different set of scientific activities. A more detailed presentation of any work covered in this report or of the many ANL projects not mentioned may be obtained by perusing the various progress and topical reports issued by the Laboratory during 1961. A list of the publications in the scientific journals during 1961 by Argonne personnel has been given as an Appendix.

Report issued by the Argonne National Laboratory discussing a summary of projects conducted with the Idaho Division. Descriptions of each project are presented. This report includes tables, and illustrations.

From Abstract: "This report describes a counting system capable of processing input pulses at an average rate in excess of 3 x 10 to the fifth power counts per second with less than 10 percent counting loss due to instrumental dead time."

Report containing zero power (<1 kw) Dry Critical Experiments that were "to be conducted in the EBR-II Reactor prior to filling the Primary System with sodium coolant" (p. 7.) The two primary objectives of these experiments were to determine how well the system performed without sodium coolant and to "determine and/or verify certain operational data to permit modification or improvement of the system (neutron shield, instrumentation, etc.) prior to the introduction of sodium into the system" (p. 7.)

From Introduction: "Information has been accumulated about the property changes produced, but there are essentially no reliable quantitative data correlating property changes with the magnitude and energy distribution of the neutron fluxes responsible for the changes. The design of the Basic Radiation Effects Reactor (BRER) presented herein stems from the two main requirements: 1. a fairly high-level, high-energy neutron flux with minimal thermal neutron and gamma-ray background is desired; 2. the peak of the neutron-energy spectrum should be variable within the approximate range from 10 to 1000 kev."

From Abstract: "The applicability of the centrifugal casting technique to the production of multiple castings of fuel pins of small diameter and of thin fuel plates was investigated."

Report issued by the Argonne national Laboratory discussing centrifugal casting of thin uranium plates. The applicability of the centrifugal casting technique to the production of multiple castings of fuel pins of small diameter and of thin fuel plates was investigated. This report includes tables, illustrations, and photographs.

Report describing the design and usage of the BORAX V nuclear reactor, its surrounding facility, systems, experimental programs, and possible hazards.

Report containing "[a] description (...) of the design of a prototype "packaged" nuclear power plant. The purpose of the plant is to alleviate fuel oil logistics and storage problems posed by remote auxiliary DEW Line radar stations north of the Arctic Circle. The ALPR (redesignated SL-1) is a 3 Mwt, heterogeneous, highly enriched uranium- fueled, natural-circulation boiling water reactor, cooled and moderated with light water. Steam at 300 psig, dry and saturated (421 deg F) is passed directly from the reactor to a conventional turbine-generator to produce electric power (300 kw nominal) and space-heating (400 kw) requirements consistent with rigid mechanical and structural specifications prescribed by the military, and dictated by the extreme geophysics prevailing at the ultimate site. The over-all design criteria emphasize: simplicity and reliability of operation and maintenance, with minimum supervision; minimum on-site construction; maximum use of standard components; limited water supply; utilization of local gravel for biological shielding; transportability by air lift; and nominal 3-year fuel operating lifetime per core loading." (p. 15)