Report presenting pressure distribution tests of six NACA 16-series propeller sections with 1-foot chords in the 8-foot high-speed tunnel to determine the compressibility effects on peak section pitching-moment coefficients. Data is presented as curves of peak section pitching-moment coefficient against Mach number, thickness ratio, and camber. The peak pitching-moment coefficients were found to occur in the regions of positive and negative stall.

Description is given of flight tests conducted on gun fairings, designed to correct the detrimental effects of the projecting and submerged wing guns on an F4F-3 fighter. It was found that the installation of unfaired guns on a clean wing resulted in a premature stall that increased the stalling speed in the carrier-approach and landing conditions of flight by suitably fairing the guns, it was possible to reduce the stalling speeds to values approaching very nearly the clean-wing values.

Report presenting tests conducted in the 8-foot high-speed wind tunnel of a scale model pursuit-type fuselage with practicable internal duct arrangement designed to meet all of the air requirements of a 1000-horsepower radial engine submerged at the maximum section. The results showed that the required internal flow can be obtained with negligible ducting losses provided that basic principles are observed in designing the air passages.

Report presenting an analysis to compare longitudinal stability and control characteristics obtained with a conventional fixed-stabilizer, an adjustable-stabilizer, and an all-movable horizontal tail. The tail-area requirements, control forces required in the critical landing condition, static margin, control-force gradients in a dive recovery, and elevator-free stability are investigated.

Report presenting an investigation of the effects of propellers and of vibration on the extent of laminar flow on the NACA 27-212 airfoil by testing the airfoil in conjunction with a tractor and a pusher propeller and with a mechanical vibrator. The results show that neither the pusher propeller nor vibration with amplitudes up to 0.094 inch and with a frequency of 1650 cycles per minute had any consequential effect on the extent of laminar flow but that the tractor propeller had a very pronounced effect.

Report presenting problems relating to the stability and control of tailless airplanes in consideration of contemporary experience and practice. Some observations in regards to small and large airplanes are provided.

Report presenting an investigation of the effects of hub drag, solidity, dual rotation, and number of blades on the efficiency of high-pitch propellers. Testing occurred with two, three, four, and six-blade single propellers and four and six-blade dual-rotating propellers equipped with spinners and tested at a range of blade angles from 35 to 65 degrees. Results regarding a comparison of the large and small spinners, effects of spinners, comparison of constant-speed propellers, characteristics of constant-speed propellers, effect of solidity and dual rotation, effect of number of blades, and some peculiarities of four-blade propellers are provided.

Report presenting flight and ground-cooling tests with a Northrop A-17A attack airplane to determine the merits of a nose-blower engine cowling designed and built at the NACA laboratory. The main objective was to determine the cooling characteristics of the nose blower, especially for ground and low-speed operation. Results regarding the cooling properties, engine pressure drop, and maximum speed and drag are provided.

Report presenting an investigation to determine the knock-limited performance of AN-F-28, Amendment-2, fuel in a DCFR engine when water solutions of the following aliphatic amines were added as internal coolants: monomethylamine, dimethylamine, ethylendiamine, diethylamine, triethylamine, and butylamine. Results regarding the mean effective pressure, indicated specific fuel competition, indicated specific liquid consumption, and knock-limited inlet-air pressure plotted against fuel-air ratio are presented for each fuel and amine combination.

Report presenting a flight investigation made of boundary-layer and profile-drag characteristics of smooth wing sections of a P-47D airplane. Measurements were made at three stations on the wing: boundary-layer measurements, pressure-distribution measurements, and wake surveys. The results indicated that a minimum profile-drag coefficient of 0.0062 for the smooth section at 63 percent semispan was obtained.

Report presenting tests in the full-scale wind tunnel on 11 single-engine military airplanes to investigate methods for increasing their high speed. Results regarding the power-plant installation, flow characteristics, wings, cockpit canopies, landing gear, and air leakage are provided.

Report presenting tests performed in German and Italian supersonic tunnels to determine the aerodynamic characteristics of projectiles of various shapes. The results show that increasing the relative length of the nose causes the drag coefficient to decrease and the center of pressure to move forward.

Report presenting an investigation in the 19-foot pressure tunnel to determine the aerodynamic effects of several elevators with varying amounts of balance, of outboard split flaps, and of a droppable gas tank on a scale model of the F4U-1 airplane.

"As a part of a program of the NACA directed toward increasing the efficiency of compressors and turbines, data were obtained for application to the design of entrance vanes for axial-flow compressors or turbines. A series of blower-blade sections with relatively high critical speeds have been developed for turning air efficiently from 0 deg to 80 deg starting with an axial direction. Tests were made of five NACA 65-series blower blades (modified NACA 65(216)-010 airfoils) and of four experimentally designed blower blades in a stationary cascade at low Mach numbers" (p. 1).

The results of a preliminary investigation of submerged duct entrances are presented. It is shown that an entrance of this type possess desirable critical speed and pressure recovery characteristics when used on a fuselage or nacelle in a region of low incremental velocity and thin boundary layer. The data obtained indicate that submerged entrances are most suitable for use with internal-flow systems which diffuse the air only a small amount: for example, those used with jet motors which have axial-flow compressors. Where complete diffusion of the air is required, fuselage-nose or wing leading edge inlets may prove to be superior. The results of the investigation have been prepared in such a form as to permit their use by a designer and the application of these data to a specific design is discussed.