On March 9, 2001, representatives of the Commodity Credit Corporation of the U.S. Department of Agriculture (CCC/USDA) and Argonne National Laboratory met with representatives from a number of federal and Nebraska state agencies (the wetlands agencies; see Table 1.1) to discuss the CCC/USDA's proposed aquifer remediation and wetlands restoration project at Utica, Nebraska. As part of those discussions, Argonne outlined preliminary recommendations for a long-term monitoring program to verify and document (1) the performance of the spray irrigation treatment process for the removal of carbon tetrachloride from extracted groundwater, (2) the geochemical quality of the extracted and treated groundwater delivered to the wetlands, and (3) the hydrogeologic and inorganic geochemical impacts of the groundwater delivery. General activities recommended included the following: (1) Periodic sampling and analysis for volatile organic compounds (VOCs) in groundwater extracted at each pumping well and in water discharged from the spray irrigation treatment units. (2) Periodic sampling of groundwater from each pumping well and directly from the sprinkler discharge, for analysis for selected inorganic water quality parameters. The CCC/USDA and Argonne also requested at the March 2001 meeting that the wetlands agencies accept responsibility for developing the ecological and biological monitoring programs needed to meet environmental …

The Chemical Flooding process, like a polymer treatment, as a tertiary (enhanced) oil recovery process can be a very good solution based on the condition of this field and its low cost compared to the drilling of new wells. It is an improved water flooding method in which high molecular-weight (macro-size molecules) and water-soluble polymers are added to the injection water to improve the mobility ratio by enhancing the viscosity of the water and by reducing permeability in invaded zones during the process. In other words, it can improve the sweep efficiency by reducing the water mobility. This polymer treatment can be performed on the same active oil producer well rather than on an injector well in the existence of strong water drive in the formation. Some parameters must be considered before any polymer job is performed such as: formation temperature, permeability, oil gravity and viscosity, location and formation thickness of the well, amount of remaining recoverable oil, fluid levels, well productivity, water oil ratio (WOR) and existence of water drive. This improved oil recovery technique has been used widely and has significant potential to extend reservoir life by increasing the oil production and decreasing the water cut. This new …