Temperature moments vs poison moments (open access)

Temperature moments vs poison moments

The excess reactivity available in an operating pile is absorbed in poison columns and horizontal rods. The temperature distribution of the pile is determined by the relative strengths and locations of the poison columns and the configuration of control rods used. A method for adjusting poison columns and rods to improve upon the pile`s temperature distribution is given in Document {number_sign}7-2654, ``Procedure for Improving Temperature Distribution via Rods and Columns,`` Wheeler and Menegus to Jordan, September 9, 1945. A relationship between poison moment (inhour lattice units) and temperature moments (per coat) was theoretically derived in the above document and has since been measured on several occasions on the basis of operating experience. A survey of recent operating data for the F Pile has been made by H. A. Gauper, Jr. with the intent of improving the method for obtaining the temperature and poison moments and relating changes in the two. This study was concerned with only the horizontal and vertical dipole moments. The results of Mr. Gauper`s investigation are summarized in this memorandum.
Date: May 19, 1947
Creator: Staebler, U. M.
System: The UNT Digital Library
[Technical progress report for Hanford 100 and 300 areas]. Progress report ending May 15, 1943 (open access)

[Technical progress report for Hanford 100 and 300 areas]. Progress report ending May 15, 1943

This weekly report details technical activities for the week ending May 15, 1943.
Date: May 19, 1943
Creator: unknown
System: The UNT Digital Library
Final report on Production Test No. 105-245-P -- Effectiveness of cadmium coated splines (open access)

Final report on Production Test No. 105-245-P -- Effectiveness of cadmium coated splines

This report discussed cadmium coated splines which have been developed to supplement the regular control rod systems under emergency shutdown conditions from higher power levels. The objective of this test was to determine the effectiveness of one such spline placed in a tube in the central zone of a pile, and of two splines in the same tube. In addition, the process control group of the P Division asked that probable spline requirements for safe operation at various power levels be estimated, and the details included in this report. The results of the test indicated a reactivity value of 10.5 {plus_minus} 1.0 ih for a single spline, and 19.0 ih {plus_minus} 1.0 ihfor two splines in tube 1674-B under the loading conditions of 4-27-49, the date of the test. The temperature rise of the cooling water for this tube under these conditions was found to be 37.2{degrees}C for 275 MW operation.
Date: May 19, 1949
Creator: Carson, A. B.
System: The UNT Digital Library