Investigation of ignition characteristics of AN-F-32 and two AN-F-58a fuels in single can-type turbojet combustor (open access)

Investigation of ignition characteristics of AN-F-32 and two AN-F-58a fuels in single can-type turbojet combustor

Ignition characteristics of AN-F-32 and two AN-F-58a fuels were studied in a single can-type turbojet combustor under air-flow conditions representing engine speeds of 1600, 2500, and 4000 rpm, altitudes from sea level to 30,000 feet, ambient temperatures at sea level from 90 degrees to minus 36 degrees F, and flight Mach numbers of 0 and 0.6. Critical fuel-flow rates for ignition increased with increase in preignition engine speed, with increase in altitude, or with decrease in sea-level ambient temperature. This flow rate appears to increase in a direct relation to decrease in fuel volatility as indicated by the 10-percent-evaporated temperature.
Date: October 13, 1950
Creator: Rayle, Warren D. & Douglass, Howard W.
System: The UNT Digital Library
Preliminary analysis of three cycles for nuclear propulsion of aircraft (open access)

Preliminary analysis of three cycles for nuclear propulsion of aircraft

A preliminary study was made of the feasibility of three cycles for nuclear propulsion of aircraft: a direct-air-turbojet, a binary liquid-metal turbojet, and a helium compressor jet. All three cycles appeared feasible for flight at a Mach number of 0.9 and altitudes up to 50,000 feet; the liquid-metal cycle appeared feasible for flight at a Mach number of 1.5. The air and helium cycles resulted in heavier aircraft than did the liquid-metal cycle, particularly at a Mach number of 1.5. The relative advantage of the liquid-metal cycle became greater as the flight speed and altitude increased, and as the reactor wall temperature decreased.
Date: October 13, 1950
Creator: Humble, L. V.; Wachtl, W. W. & Doyle, R. B.
System: The UNT Digital Library
Preliminary Investigation of Several Root Designs for Cermet Turbine Blades in Turbojet Engine 2: Root Design Alterations (open access)

Preliminary Investigation of Several Root Designs for Cermet Turbine Blades in Turbojet Engine 2: Root Design Alterations

Report presenting engine evaluation tests of twelve sets of cermet turbine blades. The first five runs were similar to previous engine tests, but the remaining ones were modified based on information gained during the first runs.
Date: October 13, 1953
Creator: Meyer, A. J., Jr.; Deutsch, G. C. & Morgan, W. C.
System: The UNT Digital Library
Investigation of Flow Fluctuations at the Exit of a Radial-Flow Centrifugal Impeller (open access)

Investigation of Flow Fluctuations at the Exit of a Radial-Flow Centrifugal Impeller

Memorandum presenting surveys made at the exit of a radial-flow centrifugal impeller to obtain instantaneous values of velocity from blade to blade and at various positions between the front and rear diffuser walls. Surveys were also made at several radial stations midway between the walls of the diffuser to observe the radial change in the flow pattern through the vaneless diffuser. Results regarding typical trace, hub-shroud surveys, and radial surveys are provided.
Date: October 13, 1952
Creator: Hamrick, Joseph T. & Mizisin, John
System: The UNT Digital Library
Stability and Control Flight Tests of a Vertically Rising Airplane Model Similar to the Lockheed XFV-1 Airplane (open access)

Stability and Control Flight Tests of a Vertically Rising Airplane Model Similar to the Lockheed XFV-1 Airplane

From Summary: "This paper presents the results of an investigation of the dynamic stability and controllability of a model which approximately represents the Lockheed XFV-1 airplane to a 1/8 scale. The investigation consisted of hovering flights in still air at a considerable height above the ground, hovering flights very close to the ground, vertical take-offs and landings, flights through the transition range from hovering to normal forward flight, and sideways translational flights."
Date: October 13, 1954
Creator: Kirby, Robert H.
System: The UNT Digital Library