The following report discusses technical problems with ion cyclotron waves, and to suggest a possible application to ion magnetron work.

From objectives: This report demonstrates the concept of hydrogeochemical sampling to be used in the 12-state region for which UCC-ND has the responsibility if surveying as part of the NURE. The results of a geochemical survey at two sample spacings in the Crystal City Quadrangle in south Texas are presented.

Abstract: "Photographic plates have been used to measure the energy of neutrons from the fission of 25. The spectrum as inferred from the ranges of 850 protons recoiling in the forward direction shows a very wide maximum at ~1.5 Mev with an exponentially decreasing high energy tail which extends beyond 7 Mev. The minimum energy neutrons recorded were ~700 kv. If the spectrum is extrapolated to zero, one finds that this average neutron energy is about 1.85 Mev. The stopping power of the plates was calibrated by the use of monochromatic neutrons from the Li-7(pn) Be-7 reaction and the d-d reaction."

The multiplication constant and optimal concentration of a slurry pile is recalculated on the basis of Mitchell's recent experiments on resonance absorption. The smallest chain reacting unit contains 45 to 55 m3 of D2O.

A production test composed of preformed zirconium samples was prepared by R. S. Kemper of the Physical Metallurgy Unit⁽¹⁾ to determine the effect of exposure time and the influence of prior mechanical cold work on changes occuring [sic.] during irradiation. The first section was delivered to Radiometallurgy Unit is April, 1954, for examination after an exposure of 190 MWD/AT.

Whenever fissile materials are handled in significant quantities such as in fuel element fabrication, separation processes, or in exponential and/or critical experiments a potential criticality hazard exists. The usual procedure which is followed by those persons conducting critical mass experiments is to either place the potential reactor in a heavily shielded cell or to conduct the experiments remotely in which case distance provides a measure of safety in the event of an unscheduled radiation outburst. In considering potential critically incidents, especially for the personnel not specifically engaged in critical mass studies, it is very likely that at the time of the incident neither the conditions of shielding nor distance will prevail for the personnel involved.

The excitation function for the reaction T3 (p, y) He4 has been extended to proton energies of 7.3 Mev. No experimental evidence is found for a resonance in the reaction up to this energy of bombarding protons.

Data collected as part of a uranium geochemical survey in the Crystal City and Beeville Quadrangles in Texas including laboratory data stream sediments and water, well water, and botanical samples for phase 1 (pp. 1-8); for phase 2 including the same with lake samples (pp 9-36); well water samples only for phase G (p. 37); and field data for all phases (pp. 38-374).

Over the last decade, several computational methods have been developed and used to examine reactor flow transients caused by pump outage. The variations in system character which have been analyzed are sufficiently diverse that it appears worthwhile to compile them into a single report.

The circuits described herein and shown functionally in Fig. 1 are to be added to the HRT control circuit to provide control and protection for the revised HRT cooling water system. The circuitry will provide protection against excess pressure in the demineralized cooling water loop and cooling water activity, will initiate action to insure containment of activity in event of an explosion and will provide emergency cooling water from the tower basin when required.

The fact that material transport does occur under conditions of finite temperature difference in a flowing molten metal system was established. The rate mass transfer was thought to be either diffusion limited or solution rate limited. It is believed that the mass transfer of structural materials in Na or NaK systems is solution rate limited. The limiting process has not been qualitatively or quantitatively confirmed for the Inconel-Na or Inconel-NaK system. Increasing the maximum system wall temperature increases the amount of mass transfer, at least above 1300 deg F. The effect of the total temperature difference across the system on the amount of mass transfer was determined.