"Tests of a 1/20-scale model of the Fleetwings XBTK-1 airplane have been performed in the Langley 15-foot free-spinning tunnel to determine the trim tendencies of the airplane at attitudes above the stall. The results of the tests indicated that the model would trim longitudinally only in the normal range of angles of attack and that the yaw trim tendencies for such longitudinal trim conditions were normal. Although wide oscillations in yaw were noted for some conditions, they occurred at angles of attack larger than those indicated as possible for longitudinal trim and spin equilibrium" (p. 1).

"In order to determine the aerodynamic effects of an auxiliary belly fuel tank on the Grumman F8F-1 airplane, a wind-tunnel investigation was made on a 1/5 - scale model of the Grumman XF8F-1 airplane. Pitch and yaw tests were made with the model in the cruising and landing configurations for windmilling and take-off power conditions. Tuft studies and static-pressure measurements were also made to determine the flow characteristics in the region of the fuel tank" (p. 1).

"An investigation has been conducted in the Langley 20-foot free-spinning tunnel of a 1/29-scale model of the Republic XF-91 airplane with a.conventional-tail arrangement installed. Previously, tests were made on the model with a vee tail installed. The erect spin and recovery characteristics of the model were determined for the normal loading with the wing installed at various amounts of incidence. The spin investigation also included inverted-spin tests, spin-recovery-parachute tests, tests with the center of gravity moved rearward, and tests with external fuel tanks added to the model" (p. 1).

"Available information on gust structure, airplane reactions, and pertinent operating statistics has been examined. This report attempts to coordinate this information with reference to the prediction of gust loads on airplanes. The material covered represents research up to October 1947" (p. 807).

The present paper is a continuation of a theoretical investigation of the stability of the laminar boundary layer in a compressible fluid. An approximate estimate for the minimum critical Reynolds number, or stability limit, is obtained in terms of the distribution of the kinematic viscosity and the product of the mean density and mean vorticity across the boundary layer. The extension of the results of the stability analysis to laminar boundary-layer gas flows with a pressure gradient in the direction of the free stream is discussed.

Report discussing testing on two types of single cylinders to determine the effect of the relation of exhaust pressure to inlet-air pressure on knock-limited performance. Variables explored included exhaust pressure, fuel-air ratio, and engine speed. Three types of fuels were also used to explore the effect of exhaust pressure on fuel ratings.

From Summary: "An investigation was conducted in the combustor of a 3000-pound-thrust turbojet engine to determine the altitude performance characteristics of AN-F-58 fuels. Three fuels conforming to AN-F-58 specification were prepared in order to determine the influence of boiling-temperature range and aromatic content on altitude performance. The performance of the three AN-F-58 fuels was compared with the performance of AN-F-48 (grade 100/130) fuel in the range of simulated altitudes from 20,000 to 55,000 feet, corrected engine speeds from 6000 to 12,500 rpm, and flight Mach numbers of 0.2 and 0.6."

Introduction. the conventional procedures of analysis for uranium and manganese can be employed in the analysis of alloys of these metals. The alloys are reacted with perchloric acid and hydrogen peroxide, fumed to remove any chloride ions, diluted to volume and aliquots analyzed by redoximetry.

The work described in this technical report was undertaken as part of a larger program dealing with a systematic investigation of changes in the physical prosperities of artificial graphite due to neutron bombardment. Very pronounced among those changes is the increase in the elastic modulus. Since there is a general relationship between the elastic modulus of a given substance and its specific heat, it was expected that corresponding changes will occur in the specific heat. In conclusion, the experiments determined that it appears that the low temperature specific heat measurements of strongly bombarded samples will be helpful for the understanding of the nature and the mechanism of the changes produced by neutron bombardment and annealing.

None

Data complied regarding wells and other water resources, including water quality analysis, measurements, and other relevant information.