We have previously shown that epimorphin, a protein expressed on the surface of myoepithelial and fibroblast cells of the mammary gland, acts as a multifunctional morphogen of mammary epithelial cells. Here, we present the molecular mechanism by which epimorphin mediates luminal morphogenesis. Treatment of cells with epimorphin to induce lumen formation greatly increases the overall expression of transcription factor CCAAT/enhancer binding protein beta (C/EBPbeta) and alters the relative expression of its two principal isoforms, LIP and LAP. These alterations were shown to be essential for the morphogenetic activities, as constitutive expression of LIP was sufficient to produce lumen formation, while constitutive expression of LAP blocked epimorphin-mediated luminal morphogenesis. Furthermore, in a transgenic mouse model in which epimorphin expression was expressed in an apolar fashion on the surface of mammary epithelial cells, we found increased expression of C/EBPbeta, increased relative expression of LIP to LAP, and enlarged ductal lumina. Together, our studies demonstrate a role for epimorphin in luminal morphogenesis through control of C/EBPbeta expression.

Confidence limits are common place in physics analysis. Great care must be taken in their calculation and use especially in cases of limited statistics. We introduce the concept of statistical errors of confidence limits and argue that not only should limits be calculated but also their errors in order to represent the results of the analysis to the fullest. We show that comparison of two different limits from two different experiments becomes easier when their errors are also quoted. Use of errors of confidence limits will lead to abatement of the debate on which method is best suited to calculate confidence limits.

It is important that air emissions from tritium systems be kept as low as reasonably achievable. Thus, over the years a number of gas detritiation systems have been developed. Recently there has been interest in lower-cost, simpler systems which do not convert HT to the much more hazardous HTO form. Examples of such systems are (1) a bubbler/dehumidifier, (2) a bubbler/collector, and (3) an adsorber/collector. A computer model of each configuration was written and run. Each system's performance, including tritium buildup in liquid water, and tritium exhausted to the environment, are presented and compared.

Fused silica and Si-O{sub x} coatings are of interest for use under high flux conditions of laser light. Si-O{sub x} coatings are sputter deposited from silicon and fused quartz targets using planar magnetrons operated in the rf mode with a variable working-gas mixture of Argon-Oxygen. A series of coatings are prepared on optically flat, fused quartz substrates. Analysis of surface curvature reveals the deposition process conditions that minimize residual stress. Compressive stress levels that exceed 1.5 GPa can be reduced to less than 0.4 GPa for an optimum working gas pressure. Characterization using Rutherford backscattering and x-ray photoelectron spectroscopy indicates that both the fused quartz and silicon targets can be used to sputter deposit coatings with the chemical bonding features of the fused-quartz substrate material.

The Mallik site represents an onshore permafrost-associated gas hydrate accumulation in the Mackenzie Delta, Northwest Territories, Canada. An 1150 m deep gas hydrate research well was drilled at the site in 1998. The objective of this study is the analysis of various gas production scenarios from several gas-hydrate-bearing zones at the Mallik site. The TOUGH2 general-purpose simulator with the EOSHYDR2 module were used for the analysis. EOSHYDR2 is designed to model the non-isothermal CH{sub 4} (methane) release, phase behavior and flow under conditions typical of methane-hydrate deposits by solving the coupled equations of mass and heat balance, and can describe any combination of gas hydrate dissociation mechanisms. Numerical simulations indicated that significant gas hydrate production at the Mallik site was possible by drawing down the pressure on a thin free-gas zone at the base of the hydrate stability field. Gas hydrate zones with underlying aquifers yielded significant gas production entirely from dissociated gas hydrate, but large amounts of produced water. Lithologically isolated gas-hydrate-bearing reservoirs with no underlying free gas or water zones, and gas-hydrate saturations of at least 50% were also studied. In these cases, it was assumed that thermal stimulation by circulating hot water in the well was the …