Report presenting outdoor static testing made on two high-solidity propellers of different design, one shrouded and the other unshrouded. Three shrouds were tested to determine the effects of shroud length and exit area. Results regarding the action of shroud, results and comparison of propellers, and comparison with theory are provided.

Report discussing an investigation of the DM-1 glider, which has an approximately triangular plan form, with auxiliary studies of a model of triangular wings. The pitching-moment coefficient, drag coefficient, and angle of attack with the lift coefficient are provided. Results indicated that the angles of descent without power are likely to be prohibitive and airplanes with the tested type of wings will not be able to land safely without power.

Memorandum presenting a determination of the performance of a single-cylinder spark-ignition engine modified to operate on a compression-ignition cycle with a compression ratio of 8.0. Experimental data were obtained at an inlet-manifold pressure of 100 inches of mercury absolute, fuel-air ratios of 0.040 and 0.025, and engine exhaust pressures of 30 to 100 inches of mercury absolute. Results regarding single-cylinder-engine experimental data and full-scale-engine calculations are provided.

Report presenting the results of flight testing to determine the zero-lift drag of an NACA 65-009 airfoil at a specified aspect ratio. The results are compared to previous testing of unswept and swept-back arrangements. The swept-forward and swept-back airfoils were found to produce lower values of zero-drag lift than the unswept airfoil.

Report presenting investigations to determine the antiknock effectiveness of various additive-water solutions used as internal coolants in conjunction with AN-F-28, Amendment-2, fuel in a modified CFR engine.

Report presenting an investigation to correlate the engine service performance of cast Vitallium turbine buckets with standard laboratory metallurgical data. Data was obtained on four turbine wheels of Timken alloy with cast Vitallium buckets. Results regarding the engine test and metallurgical examination are provided.

From Introduction: "Experimental investigations (reference 1) have shown that in some cases the thrust can be more than doubled by means of tail-pipe burning. A comparison is made of a standard turbojet engine, whose thrust is augmented by tail-pipe burning, and a ram-jet engine. The performance characteristics for the ram-jet engine were computed entirely from theoretical considerations and on the assumption that the burner-inlet velocity was constant."

Report presenting an investigation of an NACA 65A006 airfoil equipped with high-lift devices, including a 0.15-chord drooped-nose flap and a 0.20-chord plain trailing-edge flap. Airfoil section lift, pitching-moment, and drag characteristics obtained at high Reynolds numbers and low Mach numbers with the flaps deflected individually and simultaneously are presented. At Reynolds numbers up to 9.0 x 10(exp 6), the optimum combination of drooped-nose and plain trailing-edge flaps increased the maximum section lift coefficients from 0.78 to 1.89.

Report presenting tests to determine the effects of sweepback angle and aspect ratio on the drag of an NACA 65-009 airfoil at supersonic speeds. The results indicated that for the range of Mach numbers investigated, increasing the sweepback angle and decreasing the aspect ratio reduced the value of the wing drag coefficient.

Report presenting high-speed wind tunnel testing of horn- and overhang-balance elevators on a full-scale, semispan, horizontal tail. The effects of unshielding the horn and unsealing the overhang were investigated. Results regarding aerodynamic characteristics, distortions of the tail, and critical Mach numbers are provided.

Report presenting calculated performance characteristics of a ducted rocket with gasoline and liquid oxygen as the fuel mixture and with a mass flow of 1 slug per second. Evaluations of net thrust, frontal area, thrust per unit frontal area, and specific fuel consumption are given for all of the flight conditions under which it might operate.

"On the basis of a recently developed theory for finite sweptback wings at supersonic speeds, calculations of the supersonic wave drag at zero lift were made for a series of wings having thin symmetrical biconvex sections with untapered plan forms and various angles of sweepback and aspect ratios. The results are presented in a unified form so that a single chart permits the direct determination of the wave drag for this family of airfoils for an extensive range of aspect ratio and sweepback angle for stream Mach numbers up to a value corresponding to that at which the Mach line coincides with the wing leading edge. The calculations showed that in general the wave-drag coefficient decreased with increasing sweepback" (p. 1).

Memorandum presenting a wind-tunnel investigation conducted to determine the rotary stability characteristics in yawing flow of a series of untapered wings with angles of sweep of -45, 0, 45, and 60 degrees. The results of the yawing-flow tests indicated that the values of the rotary derivatives agreed fairly well with simple sweep theory for a moderate range of lift coefficients.

From Introduction: "An analysis of an engine having a division of work such that the power of the reciprocating engine is just sufficient to drive the compressor is reported herein. This combination of a reciprocating-type internal-combustion engine that drives its own supercharging compressor and generates gas for further expansion through a turbine will be called a piston-type gas generator in this report."

Report presenting an investigation to determine the spin, recovery, and longitudinal-trim characteristics of a 60 degree delta-wing model through an extensive range of mass loadings. Variations in the relative density, center-of-gravity position, and inertia parameters were included in testing. Results regarding the single-vertical-tail and multiple-vertical-tail configurations are provided.

Report presenting a blade-vibration survey that was conducted during normal operation of a 10-stage axial-flow compressor powered by part of a complete jet engine. Strain-gage records were obtained from all stages during acceleration, deceleration, and constant-speed runs. Results regarding the inlet disturbances and damping characteristics are provided.

From Introduction: "This paper presents the results of the investigation of the wing-alone and wing-fuselage configurations employing a wing with the quarter-chord line swept back 60^o, aspect ratio 2, taper ratio 0.6, and an NACA 65A006 airfoil section parallel to the free stream."

Report presenting the results of an experimental investigation of the downwash and wake characteristics behind two highly swept wings in a supersonic stream. Results regarding the rate of change of downwash with angle of attack at zero lift, variation of downwash angle with angle of attack, and wake are provided.

From Introduction: "The results of two phases of this investigation, presented in references 1 and 2, have indicated possible ways of reducing hull drag without causing large changes in aerodynamic stability and hydrodynamic performance."

Report presenting an investigation of a turbojet engine with compressor-inlet total pressure at various values below that of the exhaust pressure to determine engine performance under conditions simulating operation with inlet-duct losses. Results regarding general performance, application to inlet-duct losses, application to airplane boundary-layer control, and application to turbojet-engine thrust control are provided.

Memorandum presenting wind-tunnel tests at high subsonic Mach numbers conducted on a model of a pursuit airplane with a 45 degree sweptback wing. Tests were made to determine the effect of the wing trailing-edge angle, the fuselage contour at the wing-fuselage intersection, and an extension at the leading edge of the wing root.

Report presenting testing of a series of thin, triangular plan-form wings, including eight triangular wings of vertex angles and three swept-back wings with circular-arc sections. Results regarding lift, center of pressure, and ideal operation of different types of wings are provided.

Report discussing flight tests of airplane-like models to determine the effect of airfoil section profile and thickness ratio on the zero-lift drag of low-aspect-ratio wings at supersonic speeds. Five rectangular wings with the same aspect ratio and a variety of airfoil thicknesses were tested to determine the effect of thickness ratio.

From Summary: "The trajectories of waterdrops in air flowing over airfoils are determined for three airfoil-angle-of-attack combinations using the differential analyzer to solve the differential equations of motion of the waterdrops. From these trajectories the rate of water impingement, the area of impingement, and the distribution of impingement are determined as functions of two dimensionless moduli. Comparisons are made of the rate of water impingement on these airfoils and the rate of water impingement on cylinders."