Preparation of UCl₄ With Hexachloropropylene and Other Chlorinated Organic Compounds (open access)

Preparation of UCl₄ With Hexachloropropylene and Other Chlorinated Organic Compounds

Abstract: "A summary of the information contained in several reports relative to the use of hexachloropropylene for the preparation of UCl4. Data relative to the performance of charge material so prepared and to pilot plants are omitted."
Date: April 29, 1946
Creator: Miller, A. J. & Dean, L. B., Jr.
System: The UNT Digital Library
A Comparative Analysis of the Liquid Metal Heat Transfer Systems for WMA (open access)

A Comparative Analysis of the Liquid Metal Heat Transfer Systems for WMA

Introduction. As stated in Report KAPL 116, one of the objectives of the KAPL reactor is "to provide a prototype demonstration of the practical general of electrical power from Nuclear energy using molten sodium as the primary coolant. The reactor will generate steam at a temperature of 550 degrees F and 465 psia, including 90 degree superheat potentially capable of an efficiency of twenty-eight per cent in electrical output." The work reported here is intended to increase the scope and supply an independent check on the heat transfer system analysis that has previously been done. The purpose of these analyses is to investigate the effects on load rating and top reactor temperature.
Date: April 29, 1949
Creator: Selby, J. D.
System: The UNT Digital Library
Interaction of Be with Fission Neutrons (open access)

Interaction of Be with Fission Neutrons

To determine whether or not the (n,2n) reaction in Be would produce a net increase in fission neutrons in a power plant, the distribution of In resonance neutrons slowed down from fission energies in a graphite block was measured with and without a 2" of Be in front of a U3O8 slab undergoing fission. The thermal neutrons producing the fissions were obtained by slowing down neutrons from a cyclotron source. The observed distribution without Be was well represented by a Gaussian source range 36 cm. (corresponding to an initial fission energy of 3 MeV) and a similar sink of range 7.8 cm. The total In resonance intensity with Be was 5% less than without Be. On the assumption that the effect of the Be is entirely due to its different mean free path and moderating power, the In distribution with Be was calculated. Since the m.f.p. as a function of energy is not known for Be, two separate calculations were made using the highest (2.9 cm.) and the lowest (1.80 cm.) possible values for the effective Be m.f.p. Both calculated curves were found to be higher than the observed Be distribution, indicating that at least 10% of the fission neutrons …
Date: April 29, 1942
Creator: Borst, L.; Allison, S. K.; Wheeler, John Archibald, 1911-2008 & Weinberg, Alvin Martin, 1915-2006
System: The UNT Digital Library