Summary: "The laboratory data collected during the metallurgical evaluation of these rods indicate that lower rolling temperatures increased the ultimate and yield strength, the amount of cold work, and the degree of preferred orientation existing in these uranium rods."

Abstract: "A batch of slugs is being prepared for which the U-235 content will be 1.75 per cent, and it is of interest to calculate the minimum number of such slugs required for a critical assembly in water. Using Handbook (CL-697) methods, a critical assembly of these slugs arranged in a lattice with a spacing of 5.5 cm."

The following report deals with the application of the water boiler neutron source to the exponential experiments in an attempt to speed up lattice testing measurements.

Report presenting results of a study regarding the critical masses and nuclear properties of plutonium as well as the use and effects of various tampers.

Seven runs were made with the system Penn. Ref. Co. "Supersol" (dispersed) water (continuous) to investigate the effects of pulse frequency, amplitude plate spacing, volume flow ratio, and throughput on backmixing, using the technique of continuous injection of a tracer solution into the packed section. Backmixing was found to be surprisingly insensitive to all the above variables over the range studied with the exception of pulse amplitude and continuous phase flow rate, showing greatest dependence on the later. Backmixing increased with decreasing continuous phase flow rate and increased with pulse amplitude.

The purpose of this study has been to evaluate the chemical resistance of various bearing materials to solutions of nitric acid and uranyl nitrate hexahydrate with views toward selecting the best material to be used as bearings in Purex submerged rotating equipment.

Comparison of experimentally determined relaxation lengths to the value calculated from the concrete composition.

Because of the excessive vertical fragility and high replacement costs of mice-window G-M tubes used in vertical and horizontal lead-pig shelf counters, it was requested that a simple system of conversions to reliable scintillation detection be accomplished.

Whenever fissile materials are handled in significant quantities such as in fuel element fabrication, separation processes, or in exponential and/or critical experiments a potential criticality hazard exists. The usual procedure which is followed by those persons conducting critical mass experiments is to either place the potential reactor in a heavily shielded cell or to conduct the experiments remotely in which case distance provides a measure of safety in the event of an unscheduled radiation outburst. In considering potential critically incidents, especially for the personnel not specifically engaged in critical mass studies, it is very likely that at the time of the incident neither the conditions of shielding nor distance will prevail for the personnel involved.

A program has been prepared for the 709 computer which will determine extrapolation length from horizontal traverses measurements taken in an exponential pile. The flux across the pile is assured to fit a cosine function of the form y = A cos B (X-C)

The chromium-nickel-manganese alloys are a group of austenitic stainless steels which were developed during the Korean War to conserve nickel. These alloys are very similar to their corresponding 300 Series grades in mechanical, physical and corrosion properties. A portion of the nickel in the 300 Series grades has been replaced by approximately 2% manganese for each percent of nickel replaced. Two compositions, AISI 201 and AISI 202, are recognized as standard grades. Two other compositions, AISI 204 and AISI 204-L, have been produced in limited quantities to replace AISI 304 and AISI 304-L. Experience with the 200 Series steels indication they are every bit as good as the grades for which they were once alternates. In some shapes, such as rod and sheet, the cost per pound is considerably lower than the corresponding 300 Series grades.