From Summary: "A theory is developed for the airfoil of finite span at supersonic speed analogous to the Prandtl airfoil theory of 1918-1919 for incompressible flow. In addition to the profile and induced drags, account must be taken at supersonic flow of still another drag, namely, the wave drag, which is independent of the wing aspect ratio. Both wave and induced drags are proportional to the square of the lift and depend on the Mach number, that is, the ratio of flight to sound speed. In general, in the case of supersonic flow, the drag-lift ratio is considerably less favorable than is the case for incompressible flow."

The icing hazard can, in most cases, be avoided by correct execution of the flights according to meteorological viewpoints and by meteorologically correct navigation (horizontal and, above all, vertical). The zones of icing hazard are usually narrowly confined. Their location can be ascertained with, in most cases, sufficient accuracy before take-off.

This paper restricts itself to radial impellers with cylindrical blades since, as Prasil has shown, the flow about an arbitrarily curved surface of revolution may be reduced to this normal form we have chosen by a relatively simple conformal transformation. This method starts from the simple hypotheses of the older centrifugal impeller theory by first assuming an impeller with an infinite number of blades. How the flow is then modified is then investigated.

In the present report, aerodynamic relations under the effect of the weight moments are investigated, and an example given of the computation of the stability for a practical case. Later, the effects of the masses of the controls on the dynamic longitudinal stability will be considered.

This paper is a presentation of the experiments and equipment used in investigations at the Guidonia wind tunnel. The equipment consisted of: a number of subsonic and supersonic cones, an aerodynamic balance, and optical instruments operating on the Schlieren and interferometer principle.

"This report derives equations containing only directly measurable constants for the quantities involved in the hydrodynamic theory of detonation. The stable detonation speed, D, is revealed as having the lowest possible value in the case of positive material velocity, by finding the minimum of the Du curve (u denotes the speed of the gases of combustion). A study of the conditions of energy and impulse in freely suspended detonating systems leads to the disclosure of a rarefaction front traveling at a lower speed behind the detonation front; its velocity is computed" (p. 1).

"For an infinitely long plate strip of constant curvature there is set up the buckling condition for combined shear and axial stresses. Assumptions are made of the vanishing of the moments acting on the longitudinal edges and of the vanishing of the tangential displacements u and the transverse stresses sigma(sub y) (longitudinal stiffeners nonresistant to bending in the circumferential direction). The buckling condition is evaluated for the case of pure shear and an approximate formula is derived for the critical stresses for large curvatures" (p. 1).

This report contains a survey of past radiator research. This report also is intended as a systematic comparison of theoretical and experimental radiator drag, with the object of ascertaining the most important loss sources and their interaction in different cases of installation, and to separate the radiator systems which are amenable to calculation, both as regards axial flow and drag. The sources of loss due to the diffuser are to be looked into closely as in many cases they can be of preeminent magnitude and their customary appraisal, according to Fliegner's formula, does not meet actual conditions.

The subject of the present paper is confined to the investigations and methods employed by the Fiat company in their studies on the altitude performance of an air-cooled engine of the production type. The experimental set-up as well as test engine data are provided.

The purpose of this paper is to give an outline of the present state of development and point out the possibilities available for the further increase in the power/displacement ratio, the economy, and the reliability of the engine. Some of the aspects discussed are methods of increasing take-off power, the various methods of preparation of the fuel mixture and their effect on power, economy, and safety.

A method is developed with no neglect of certain factors in mass flow of air and in the drag of the heated radiator, i.e., one under actual operating conditions, as compared with the corresponding values in the cold state, may be simply computed. Although a symmetrical duct radiator has been used to bring out the flow relations, the results apply equally as well to the unsymmetrical radiator shapes usual in airplane construction.

The experimental methods at the Guidonia towing basin are discussed including specifications. Some of the components examined are the bridge towing carriage, side towing carriage, catapult installation, and dynamometer systems. Tests were performed on hulls and floats, as well as motor boats and torpedo shaped bodies. Theoretical investigations were also performed to determine pressure distributions on geometrically simple bodies, propagation of small wave motions, and planing and submerged surfaces.

"The author believes, on the basis of experimental ignition-lag data, that the character of a fuel cannot be stated in terms of a single constant (such as octane or cetane number) but that at least two and generally three constants are required. Thus no correlation between knock ratings can be expected if in one set of tests the charge temperature was varied while in the other the charge pressure was varied. For this reason, he favors knock rating being based on an equation characterizing the ignition lag of the fuel as a function of pressure and temperature of the charge" (p. 1).

The results of pressure distribution measurements that were made on a model wing section of a Fieseler F 5 R type airplane are presented. Comparison of those model tests with the corresponding flight tests indicates the limitations and also the advantages of wind tunnel investigations, the advantages being particularly that through the variety of measuring methods employed the more complicated flow conditions may also be clarified. A fact brought out in these tests is that even in the case of "well rounded" slots it is possible for a vortex to be set up at the slot entrance and this vortex is responsible for certain irregularities in the pressure distribution and in the efficiency of the slot.

"An investigation is made of the mutual interference of the wings of a biplane under the general assumption that each wing may be replaced by a vortex system of the type given by the Prandtl wing theory. The additional velocities induced at each wing by the presence of the other are determined by the Biot-Savart law and converted into an equivalent change in the angle of attack, the effect being that of an additional twist given to the wings in changing their lift distributions. The lift distributions computed in this manner for several airplane types are compared with the results of measurement" (p. 1).

This report makes use of the results obtained in the Gottingen ice tunnel in which the atmospheric conditions are simulated and the process of ice formation photographed. The effect of ice formation is threefold: 1) added weight to the airplane; 2) a change in the lift and drag forces; 3) a change in the stability characteristics.

Direct measurements were undertaken at the Aeronautics Laboratory in Turin of the aerodynamic actions on an oscillating wing. The tests conducted had as their essential object the examination of the operation of apparatus designed for this measurement. The values experimentally obtained for the aerodynamic coefficients are in good agreement with the theory of oscillatory motion of the wing of finite span and show clear deviation from the values obtained by theory of plane motion.

"Three general theories treating the potential flow about an arbitrary wing section are discussed in this report. The first theory treats the method of conformal transformation as laid down by Theodorsen and Garrick; the second is a generalization of Birnbaum's theory for moderately thick airfoils; the third is a general investigation of the complex velocity function with particular reference to the relations first discussed by F. Weinig. The relative merits of the different methods in question are illustrated on a worked-out example and will be published in a subsequent issue of this periodical" (p. 1).

In this report, two reliable methods are presented, with the aid of which the undisturbed flight dynamic pressure and the true static pressure may be determined without error. These problems were solved chiefly through practical flight tests.

Report presenting some considerations and test results that may lead to higher tension, compression, and buckling stresses than is possible with the welded-steel-tube struts of the usual familiar construction. The new construction method makes possible a considerably better material utilization and hence a saving in weight.

Engine knock is, as is known, preceded by normal burning of the first part of the charge, and only the part burned last (residual charge), knocks. The aim of the present measurements was, first, to reexamine the combustion form in this residual charge, because of the absence of uniform and frequently contradictory results in the very extensive literature on the subject. On top of that, an attempt was to be made to gain a deeper insight into the mechanism accompanying the combustion process, by means of the electrical test equipment perfected in recent years.

The present report deals with six-component measurements in the small tunnel of the DVL on a model of the BFW-M 27b(sub 1), which were made to determine the effect of rolling and yawing on the air forces and moments. The wind was given a spiral motion by means of a rotating screen, the model being suspended in the conventional manner. The lack of accuracy in the measurement of the rolling-yawing moments was very noticeable.

"The optimum circulation distribution and hence the maximum theoretical thrust obtainable for contra-vanes fitted behind propellers is markedly dependent on the number of guide vanes. The outer portion of the vanes, even if projecting considerably beyond the edge of the propeller slipstream, still contribute appreciably to this theoretical gain of thrust. But, owing to the always existing friction of the vanes, the limit of the optimum vane length lies at relatively small diameters" (p. 1).

As no investigation of supercharging in 2-stroke-cycle engines has been published up to the present, this article is an attempt in that direction, with a view to establishing the mathematical principles and the constructive rules for the design of such engines.