This preliminary report discusses the qualities of uranium and zirconium as getters, describing the methods of incorporating the elements.

A report about thermal-conductivity and electrical-resistivity measurements made on a uranium-1.5 w/o zirconium alloy surrounded by NaK enclosed in a Zircaloy-2 capsule which were in poor agreement with measurements made directly on a uranium-1.5 w/o zirconium specimen.

From Abstract: "Fuel tubes of enriched uranium-aluminum alloy were melted to various degrees of severity in the SPERT I reactor as a part of a program to evaluate reactor operating hazards. The heat flux encountered during the tests ranged from 200,000 to 650,000 pcu/(hr)(ft^2). The time required for the metal temperature to reach the melting point from the time when burnout began varied from 1.3 to 4.9 seconds. During these tests, pressure pulses were produced at a frequency of about one per second with peaks of about 150 psi."

Phase I - Plant Transient Analysis. Behavior of the basic and refined kinetic models differs only slightly. It is therefore suggested that the basic model be used in any studies where the improvement in fidelity attainable fro the refined model is not warranted by the complexities introduced by the addition of function generator to the analog circuitry and derivation of the function to be programmed. The parameter responses of both kinetic models appear to be essentially similar to those of the plant with the exception of the primary pressure. In the pressurizer analysis it was noted that the primary system pressure surges of the model should be higher than those of the plant because of the adiabatic steam compression assumed in the model derivation. the fact that the mode surge is very much greater indicates that the compression process is far from adiabatic. A more detailed and complex model of the pressurizer, one that evaluates heat transfer in the steam pocket boundaries, would therefore reduce the costly conservatism otherwise necessary in the specification of pressurizer vessel size. Phase II - Xenon Reactivity Transients. On the basis of this study an analog computer circuit has been presented which accurately represents bank …

The basic investigation of transistor feedback amplifiers has proven mathematically simple and of great practical value. The behavior of single-stage common-emitter amplifiers is described and provides a building block with which cascaded feedback amplifiers can be analyzed and designed. From the results of this analysis the conditions for minimum drift for cascaded single-stages and cascaded loops have been derived.

The method of detecting unpaired electrons in liquid and solid systems by electron spin resonance is discussed. The significance of the hyperfine structure in electron spin resonance is discussed and the possible use of these structural features of the electron spin resonance spectrum to elucidate the nature of the photoproduced unpaired electrons in photosynthesizing systems is introduced.

In this report we present solutions of the design problem in which a system of quadruple lenses is required to carry a particle beam from given focal lines in the x and y planes to other given focal lines. Particular attention will be given to the case of the anastigmatic lens system which takes a beam from one focal point to another focal point. Since the general problem is almost impossibly complicated a simplification is introduced by breaking the lens system into two parts. The first part of the lens system is required to bring the initial beam to the state where it is parallel to the z axis in both planes. The second part carries the initially parallel beam to the required final condition. Each part will involve two quadrupoles so that the complete system will consist of four quadruples; usually, however, the field gradients in the second and third quadrupoles can be made identical so that those quadrupoles can be combined into one and the system becomes a three quadrupole system. The configuration of the lens element will be as shown in the figures below. These figures indicate also the general character of the beam path in the …

GE is amending its application of 6/5/57 to construct and operate the Nuclear Test Reactor in order to incorporate changes in procedure and equipment.