Report presenting wind-tunnel testing to determine the low-speed lift, drag, and pitching-moment characteristics of a 40 degree sweptback wing with high-lift and stall-control flaps and a fuselage with a fineness ratio of 10.2 to 1. Low, medium, and high-wing-fuselage combinations were tested at high Reynolds numbers. Results regarding the high-lift and stall-control flaps and wing-fuselage combinations are provided.

Report presenting the results of testing on a model of the D-558-1 in order to determine its pitching-moment, lift, and drag characteristics with no nose-inlet flow, and with the tail removed and at a constant setting. Only a limited analysis is provided.

Report presenting the results of two runs made with liquid diborane and hydrogen peroxide in a small-scale rocket engine. The first run was very erratic and modifications were made to the testing apparatus and procedures for the second run. In the second run, the combustion started immediately and continued smoothly for 12 seconds of operation.

Report presenting testing in the 300 mph tunnel of a model with a sweptback vee tail and a sweptback wing to determine its low-speed stability and control characteristics. The results are compared to testing with the same tail panel with zero dihedral on the same wing-fuselage combination. The longitudinal stability characteristics, downwash at the tail, longitudinal control characteristics, lateral stability characteristics, and rudder control characteristics are provided.

Report presenting testing of six flutter wings, two swept 45 degrees and four unswept, attached to three freely falling bodies. Flutter frequency and phasing were recorded.

Memorandum presenting an investigation of an axial-flow compressor rotor operating with supersonic velocities relative to the blade rows in order to determine the performance characteristics in air and to confirm the performance obtained in Freon-12 at another laboratory. Results regarding the weight flow, work of compression, pressure ratio and adiabatic efficiency, and entry of shock are provided.

Memorandum presenting an approximate method for the estimation of the properties of the incompressible laminar boundary layer on a flat plate in the slip-flow region using Karman's momentum method. At equivalent stations, the total thickness and the skin friction of a slipping boundary layer are less than that of the normal boundary layer at the same Reynolds number.

The problems of static and dynamic longitudinal stability both at high speeds and at low speeds are discussed and data are presented which indicate recent progress made in the solution of these problems.

This report contains a selected list of Government sponsored research projects on related aircraft materials in effect during the calendar year 1947. Information is contained on titles, description, sponsoring and conducting agencies.

The effects on dynamic lateral stability and controllability of some of the important aerodynamic and mass characteristics are discussed and methods are presented for estimating the various stability parameters to be used in the calculation of the dynamic lateral stability of airplanes with swept and low-aspect-ratio wings.

Report presenting an investigation to study cowling-spinner combinations based on the NACA 1-series nose inlets and to obtain systemic data for one family of approximately ellipsoidal spinners. 11 of the spinners were also tested in various combinations with 9 NACA open-nose cowlings, which were also tested without spinners. Results regarding flow over spinners, internal flow, external flow over cowling, critical Mach number characteristics, envelope values, and cowling section are provided.

Report presenting a wind-tunnel investigation to explore the merits of split and chord-extension flaps on a 45 degree sweptback wing. Testing occurred at low speed on a semispan model equipped with split flaps of 60 and 90-percent span and a full-span chord-extension flap. Results regarding split flaps, chord-extension flap, and resultant lift coefficients after balancing pitching-moment coefficients are provided.

Free-flight performance of five 16-inch-diameter ram-jet units was determined over range of free-stream Mach numbers of 0.50 to 1.86 and gas total-temperature ratios between 1.0 and 6.1 Time histories of performance data are presented for each unit. Correlations illustrate effect of free-stream Mach number and gas total-temperature ratio on diffuser total-pressure recovery, net-thrust coefficient, and external drag coefficient. One unit had smooth steady burning throughout the entire flight and encountered a maximum free-stream Mach number of 1.86 with a net acceleration of approximately 4.2 g's.

Report presenting the aerodynamic properties of a model of a jettisonable nose section with a circular cross section as determined at low speed from an investigation in the 20-foot free-spinning tunnel. The results indicated that the aerodynamic characteristics of the nose were greatly affected by proximity to the fuselage. Even for a stabilized nose, it may be necessary to eject the nose forward forcibly in order to prevent high accelerations along the backbone of the pilot.

Report presenting an investigation to determine the high-speed performance and static longitudinal stability and control characteristics of a model of the Lockheed YP-80A airplane. High-speed aerodynamic characteristics are presented for speeds up to Mach number 0.96. Results regarding the scale effects, longitudinal stability, and longitudinal-control effectiveness are provided.

From Summary: "A review of the status of the knowledge on turbine-blade cooling and a description of pertinent NACA investigations are presented. The current limitations in performance of uncooled and cooled engines are briefly discussed. Finally, the knowledge available and investigations to increase the knowledge on heat transfer, cooling-flow, and performance characteristics of cooled turbines are discussed."

Report presenting a test-stand investigation conducted on a rectangular ramjet engine design for installation in an aircraft wing. The engine operated without excessive engine noise or vibration over the entire range of operating conditions. Results regarding inlet velocity, exhaust flame characteristics, fuel-air ratio, and total-temperature rise are provided.

An altitude-wind-tunnel investigation of the performance of AN-F-58 and AN-F-32 fuels in an experimental turbojet engine was conducted over a range of simulated altitudes and flight Mach numbers. Combustion efficiencies obtained with AN-F-58 and AN-F-32 fuels were approximately equal. The minimum-speed altitude operational limit was essentially the same with either AN-F-58 or AN-F-32 fuel. Starting characteristics of the two fuels were approximately the same at low wind milling speeds. Visual observation showed no apparent differences in the carbon-deposition rates of AN-F-58 and AN-F-32 fuels.

Report presenting an investigation of the two-dimensional aerodynamic characteristics of several NACA airfoil sections at four Reynolds numbers. Results regarding the minimum drag, maximum lift, lift-curve slope, and angle of zero lift and pitching moment are provided.

Testing was conducting to evaluate the effects of support interference on the drag characteristics of two bodies of revolution at zero angle of attack at Mach number 1.5. Drag and base-pressure measurements are made for a variety of Reynolds numbers to determine the effect of varying the length or diameter of the rear support.

Memorandum presenting high-speed wind-tunnel testing to investigate the aerodynamic characteristics at subsonic speeds of two symmetrical double-wedge airfoil sections of 4- and 6-percent-chord thickness suitable for application to supersonic aircraft. Section coefficients of lift, drag, and quarter-chord pitching moment are presented for a moderate range of angles of attack at Mach numbers up to approximately 0.93. The double-wedge airfoil exhibits no characteristics other than those common to the usual subsonic profile which would contribute to unsteady or uncontrollable flight at subsonic speeds of aircraft employing such a section for lifting surfaces.

Report discusses the development and testing of a rocket-propelled test vehicle to investigate aerodynamic control effectiveness at high subsonic, transonic, and supersonic speeds. Modifications to the section thickness and wing sweepback to improve performance are also described. A description of the vehicle, instrumentation, accuracy, and evaluation of testing results is included.

Report presenting part of the results obtained to determine the effects of compressibility at high Mach numbers on a model of the Bell XS-1 transonic research airplane. General trends that can be qualitatively analyzed for level-flight Mach numbers up to 0.93 are given. Results regarding force characteristics and a comparison of results with wing-flow investigation are also provided.

Report discussing testing on a 42 degree swept-back wing to determine its low-speed aerodynamic characteristics in pitch and yaw at high Reynolds numbers. The main effect of increasing the Reynolds number was delayed wing stalling to higher angles of attack. Roughness on the wing leading edge also had a large adverse effect on lift, drag, and pitching-moment characteristics at higher Reynolds numbers.