Definite identification has been made of an isotope of the element with atomic number 98 through the irradiation of Cm{sup 242} with 35 Mev helium ions in the Berkeley Orocker Laboratory 60-inch cyclotron. The isotope which has been identified has an observed half-life of about 45 minutes and probably has the mass number 244. The observed mode of decay of the 98{sup 244} is through the emission of alpha-particles, with energy about 7.1 Mev, which agrees with predictions, and other considerations involving the systematics of radioactivity in this region indicate that it should also be unstable toward decay by electron-capture. The chemical separation and identification of the new element was accomplished through the use of ion exchange adsorption methods employing the resin Dowex-50. The element 98 isotope appears in the eka-dysprosium position on elution curves containing 4.6-hour Bk{sup 243} (formed by a d,n reaction in the same bombardment) and the bombarded Cm{sup 242} as reference points; that is, it preceded berkelium and curium off the column just as dysprosium precedes terbium and gadolinium. The experiments so far have revealed only the tripositive oxidation state of eka-dysprosium character but practically no attempts at oxidation to possible IV and V states have …

Summary: A method for the separation of cesium from macro quantities of sodium and potassium using an ion exchange resin, Dowex 50, has been developed. A 95% recovery of cesium with a reduction of the solid content of 95% was found possible. Curves illustrating the effect of acidity, column length, and flow rate are presented in the report. The sodium form, hydrogen form and ammonium form of Dowex 50 were investigated; the hydrogen form was found to give the best separation.

Report detailing an analysis of the deposition of I-131 on vegetation. Analysis was necessary to determine the potential hazards of the gases from the dissolution of the metal on vegetation.

Abstract: This report gives the results of a radiochemical analysis of particles collected by electrostatic precipitation from ventilation air of the "B" plant at Hanford Works.

Abstract: "The niobium-oxygen equilibrium has been determined by metallographic examination of arc-cast alloys made of electron-gun-refined niobium metal and special purity niobium pentoxide. Two intermediate oxides, NbO and NbO2, melt without decomposition at 1945 C and 1915 C, respectively. Eutectic reactions exist between niobium and NbO and 1915 C and between NbO and NbO2 at 1810 C. Experimental supports a peritectic reaction between NbO2 and Nb2O5 1510 C. The maximum solid solubility of oxygen in niobium metal is 0.72 weight per cent."

Report presenting a study that evaluates various types of refractories for use in a refractory-lined vessel that would be used for continuous reduction of uranium tetrafluoride to uranium metal.

Abstract: "The corrosion rate in 680 F water of the uranium-50 w/o zirconium binary alloy was found to be -0.20 mg/(cm2)(hr), and that of the uranium-40 w/o zirconium binary alloy was -0.34 mg/(cm2)(hr). Both alloys correlated uniformly, with no evidence of discontinuous failure. Normal variations in interstitial content in either alloy had no significant effect on corrosion behavior. Tantalum additions, in the range of 0.2 to 5 w/o, improved the corrosion rate of the uranium-50 w/o zirconium base, with a minimum rate of -0.06 mg/(cm2)(hr) for the 5 w/o tantalum alloy. The 5 w/o tantalum addition to the uranium-40 w/o zirconium alloy. The 5 w/o tantalum addition to the uranium-40 w/o zirconium alloy decreased the corrosion rate of the base to -0.11 mg/(cm2)(hr) in the [...] condition only. In either conditions, the 5 w/o tantalum alloy failed discontinuously. All other additions to both bases either had no effect or decreased corrosion resistance. These included aluminum, chromium, iron, molybdenum, nickel, platinum, tin, titanium, tungsten, and vanadium additions."

Abstract: The thermal distortion of a Y-shaped hafnium control rod heated by arrays of individually controlled radiation heaters was studied. The large axial and radial temperature gradients specified for this control rod were easily obtained with the radiation-heating method. The distortion, as measured with dial indicators, amounted to a 2-mil movement of the free end of the rod in the direction of the coolest blade.

Survey of properties of materials which might be suitable for use in various locations in a supercritical-water reactor. Properties examined include tensile strength, rupture strength, endurance strength, Young's modulus, tensile elongation, coefficient of thermal expansion, coefficient of thermal conductivity, density, nominal composition, usual heat treatments and thermal-neutron-absorption cross sections.

This report covers a study of the deformation characteristics of uranium in grooved rolls. The study's purpose was to provide a basis for possible improvements in the uniformity of the rolled rod produced for the Hanford and Savannah River reactors.

This report follows work performed to determine the effects of large boron additions on the fabricability and room-temperature tensile properties of various steels for reactor shielding.

Report presenting some of the hydrodynamic problems associated with launching an air missile from underwater. The results of an experiment with models are also provided, including deviation angle, effect of forward speed of the submarine, curved path of the missile, and potential environmental disruptions.

From Introduction: "These data have been collected for presentation in this report to illustrate the performance of turbojet and ram-jet cycles utilizing several of the more promising high-energy fuels. Results are presented in terms of engine over-all efficiency and thrust per pound of airflow as functions of flight Mach number."

As a part of the five year budget study requested by HOO-AEC, a study of separations waste storage requirements for this period was made. This study took into consideration the variant estimates of amount of irradiated uranium to be processed, and the goals in the waste reduction research and development program. The conclusions of this study were at variance, to some extent, with prior studies. Interest has been expressed in publication of this study to permit independent assessment of its bases and assumptions.

Technical report detailing expansion of the Aircraft Nuclear Propulsion at the Oak Ridge National Laboratory. Major facilities completed at this time were the Shielding Rector, the ANP Critical Facility, and the 86-in. Cyclotron. Outlines further need for radiation damage studies. [From Summary]

Technical report and preliminary design calculations describing a type of liquid fuel reactor adaptable for production or breeding on a U-233 cycle based on data at Brookhaven National Laboratory. Describes design calculations for generating significant amounts of power and neutrons by use of uranium-bismuth solutions with fused salts in the reactor system.

Technical report outlining how uranium hexaflouride was prepared be the direct combination of irradiated uranium metal with elemental fluorine and subsequently decontaminated by adsorption, filtration, and sublimation on a laboratory scale. Report proposes a survey of other methods of preparing UF6 from uranium metal, a study of adsorption techniques for removing plutonium from UF6, and an investigation of fractional distillation for removing the volatile fission product fluorides from UF6. [From Abstract, Summary]

The following report investigates the possible use of thermal emf's to produce the plasma-containing magnetic field in a thermonuclear reactor.

The following report discusses the construction of two heavy-ion linear accelerators, one at the the University of California Radiation Laboratory and the other at Yale University. The goal for these accelerators is to produce ions of masses up to that of neon with energies of 10 Mev per nucleon.

"Characteristics of a pulsed, occluded-gas ion source, operating in a magnetic field, have been investigated. Mass spectra of hydrogen- and deuterium-loaded sources are presented. Constructional details of the source and its operating characteristics are discussed."

Report that discusses the possibility of testing the T-invariance in β-meson decay. The author describes a past experiment performed by Lee and Yang, as well as the specifics of the proposed experiment to test the time reversal in β-meson decay.

This report analyzes two high-current linear accelerators, the A-54--a 48.5 megacycle resonant cavity accelerator--and the A-48, that is under construction during the time this report is written.

The following report provides results from investigations of torsional vibration stresses in the drive shafts of two Westinghouse motor generator sets in 1952.

The following report describes a beta and gamma scintillation detector similar to what was used in previous decay studies, yet was modified to make it suitable for the analysis of mixtures of radio-nuclides.