From Summary: "The author, who was a captain of the Reserves in the Technical Department of the Aviation Division (Board of Airplane Experts) during the war, shows what means were taken for the creation of new airplane types and what tests were employed for trying out their flying properties, capacities and structural reliability. The principal representative types of each of the classes of airplanes are described and the characteristics of the important structural parts are discussed. Data regarding the number of airplanes at the front and the flying efficiency of the various classes of airplanes are given."

The construction of giant airplanes was begun in Germany in August, 1914. The tables annexed here show that a large number of airplanes weighing up to 15.5 tons were constructed and tested in Germany during the War, and it is certain that no other country turned out airplanes of this weight nor in such large numbers. An examination of the tables shows that by the end of the War all the manufacturers had arrived at a well-defined type, namely an airplane of about 12 tons with four engines of 260 horsepower each. The aircraft listed here are discussed with regard to useful weight and aerodynamic qualities.

The report discussing single and two-seater airplanes as well as larger airplanes.

From summary: "A two-dimensional wind-tunnel investigation has been made of the relative effectiveness of two methods of boundary-layer control in increasing the maximum lift coefficient of an NACA 652-415 airfoil section."

"The present contribution is the sequel to a paper written by Messrs. R. Fuchs, L. Hopf, and H. Hamburger, and proposes to show that the methods therein contained can be practically utilized in computations. Furthermore, the calculations leading up to the diagram of moments for three airplanes, whose performance in war service gave reason for complaint, are analyzed. Finally, it is shown what conclusions can be drawn from the diagram of moments with regard to the defects in these planes and what steps may be taken to remedy them" (p. 1).

"In terminating the study of the adaptation of the engine to the airplane, we will examine the problem of the turbo-compressor, the first realization of which dates from the war; this will form an addition to the indications already given on supercharging at various altitudes. This subject is of great importance for the application of the turbo-compressor worked by the exhaust gases. Assuming that the increase of pressure in the admission manifold is the same in both cases, the pressure in the exhaust manifold would be greater in the case in which the compressor is worked by the exhaust gas and there would result a certain reduction of engine power which we must be able to calculate" (p. 1).

It became evident during World War I that ever-increasing demands were being placed on the mean power of aircraft engines as a result of the increased on board equipment and the demands of aerial combat. The need was for increased climbing efficiency and climbing speed. The response to these demands has been in terms of lightweight construction and the adaptation of the aircraft engine to the requirements of its use.

From Introduction: "The present paper has been prepared to give the results of the analysis of the V-G records obtained from three Boeing S-307 airplanes operating in Caribbean region and the northern part of South America during the period from 1940 to 1944."

From Introduction: "The present report is the second prepared to give the results of an analysis of V-G data from commercial transport airplanes. The present report is concerned with an analysis of data obtained with Douglas DC-3 airplanes flying over three transcontinental routes in the United States."

From Introduction: "Acceleration and airspeed data obtained from V-G records collected during commercial transport operations (references 1 and 2) are being analyzed in some detail to determine the flight loads and operating speeds as functions of airplane, route, season, and prewar and wartime operations."

Given here is a brief description of the Göttingen wind tunnel for the testing of aircraft models, preceded by a history of its development. Included are a number of diagrams illustrating, among other things, a sectional elevation of the wind tunnel, the pressure regulator, the entrance cone and method of supporting a model for simple drag tests, a three-component balance, and a propeller testing device, all of which are discussed in the text.

Report presenting suggestions for the standardization of the study of aerodynamics in laboratories in the United States and Europe. A report by each of the different scientists, all of whom are working in a variety of different labs and countries, is provided, and each discusses the progress made in their respective labs and their suggestions for standardization and progress in the field.

Note presenting an exploration of aircraft safety during curved flight, which leads to more stress on the wings than other types of flight.

Note presenting graphs for rapid evaluation of air-induction systems from considerations of their aerodynamic-performance parameters in combination with power-plant characteristics. The graphs cover the range of supersonic Mach numbers up to 3.0. The illustrative examples indicate that the inlet area required for optimum performance must change with altitude at a fixed Mach number as well as with Mach number at a fixed altitude.

Note presenting a flight investigation of a three-blade propeller in climb and at high speed to determine the effects of blade power loading. Increasing the blade power coefficient from 0.06 to 0.09 was found to increase the efficiency approximately 8 percent at an airplane Mach number of 0.7 and a propeller-tip Mach number of 1.13. In climb, an increase in power loading over the range of blade power coefficients investigated was shown to reduce efficiency, as a consequence of increased induced drag losses.

Results of an investigation at low speeds to determine the gust-alleviation capabilities (reduction in lift-curve slope) of spoilers and deflectors on a 35 degree swept-wing model of high aspect ratio and on a 1/4-scale model of the X-5 airplane with 35 degree swept wings indicate that deflector and spoiler-deflector types of controls can be designed to provide considerable gust alleviation for a swept-wing airplane while still maintaining stability and control.

Report presenting measurements in sideslipping flight of the pressure distribution over the horizontal tail surface of a tractor-propeller-driven pursuit airplane to determine the effects of angle of sideslip and propeller operation on the tail-load distribution. Results regarding the reduction of data, effect of sideslip and power on tail loads, effect of sideslip and power on tail moments, and a comparison of the calculated loading with experimental results.

Note presenting an investigation to determine the yield strength, ultimate strength, ductility, and plastic stress-stain relations for 24S-T aluminum alloy when subjected to biaxial stresses. The data were interpreted by a generalized St. Venant theory in an attempt to predict the biaxial stress-strain relations in terms of the uniaxial tensile stress-strain relations. Stress-strain data were also obtained from flat control specimens cut from tubular specimens and compared with tension test data obtained from tubular specimens.

Discussed here are the principles and operation of aircraft engine superchargers used to maintain and increase engine power as aircraft encounter decreases in the density of air as altitude rises. Details are given on the design and operation of the centrifugal compressors. A method is given for calculating the amount of power needed to drive a compressor. The effects of the use of a compressor on fuel system operation and design are discussed. Several specific superchargers that were in operation are described.

It was a conclusion of this detailed study of the practicality of using airships for carrying passengers that, although slow, airships are capable of carrying useful loads over long distances. However, it is noted that there is a certain limit to the advantages of large cubature. Beyond a certain point, the maximum altitude of the airship goes on decreasing, in spite of the fact that the range of action in the horizontal plane and the useful load go on increasing. The possibility of rapid climb is an essential factor of security in aerial navigation in the case of storms, as is velocity.

Tests indicated that: 1) C airplanes with two struts are extremely susceptible to aileron maneuvers, slight alterations of the aileron sufficing to compensate great unequalized moments; 2) great unequalized moments can be produced or neutralized by the unequalized alternation of the angle of attack below the outer and inner struts. Adjustment below the outer strut is the more effective of the two. 3) When a load of bombs is suspended beyond the center of the airplane, below the wings, the bombs need not be dropped simultaneously. 4) The propeller wash of a wide open engine has considerable influence on the position and operation of the elevator. The elevator is more susceptible in flight with the engine running than in gliding flight. 5) Adjustable tail planes are not advisable for D airplanes, nor for the C type, but they are, on the other hand, to be recommended for large size and giant airplanes in which the center of gravity changes during flight. 6) The aileron values obtained by wind tunnel measurements are about 10 percent too low, though otherwise applicable. For the elevator, the results of such measurements should be taken as mean values between flight with the engine running and …

Given here are the rules officially adopted by the Aeronautical Commission of the Aero Club of France for a flight competition to be held in France in 1920 at the Villacoublay Aerodrome. The prize will be awarded to the pilot who succeeds in obtaining the highest maximum and lowest minimum speeds, and in landing within the shortest distance.

Report presenting a paper in two parts about transition and turbulent boundary layers. The first part reviews the current problem of the instability of laminar boundary layers. The second part reviews the current state of knowledge of the mechanics of turbulent boundary layers and of the methods now being used for fundamental studies of the turbulent fluctuations in turbulent boundary layers.

"This report describes methods used by the National Advisory Committee for Aeronautics to study visually the air flow around airplanes. The use of streamers, oil and exhaust gas streaks, lampblack and kerosene, powdered materials, and kerosene smoke is briefly described. The generation and distribution of smoke from candles and from titanium tetrachloride are described in greater detail because they appear most advantageous for general application. Examples are included showing results of the various methods" (p. 1).