"An investigation was made in the Cleveland Altitude wind tunnel to determine the performance of an Aeroproducts H20C-162-X11M2 four-blade propeller on a YP-47M airplane at high blade loadings and high engine powers. The propeller characteristics were obtained for a range of power coefficients from 0.30 to 1.00 at free-stream Mach numbers of 0.40 and 0.50. The results of the force measurements are indicative only of trends in propeller efficiency with changes in power coefficient and advance-diameter ratio because unknown interference effects existed during the investigation" (p. 1).

Report presenting the design of a two-stage, solid-fuel, rocket-propelled, general research pilotless aircraft suitable for investigating stability and control at supersonic velocities. The flight test investigation is described and information is provided for zero-length launchers and operational flight-test techniques of two-stage rockets. Results regarding launching characteristics and lateral stabilization and control flight tests are provided.

Report presenting a flight test of a supersonic research pilotless aircraft in which large-amplitude aileron oscillations, most likely aileron compressibility flutter, were encountered in the transonic and supersonic speed ranges. Results regarding power-on flight and coasting flight are provided.

Report discusses the development and testing of a rocket-propelled test vehicle to investigate aerodynamic control effectiveness at high subsonic, transonic, and supersonic speeds. Modifications to the section thickness and wing sweepback to improve performance are also described. A description of the vehicle, instrumentation, accuracy, and evaluation of testing results is included.

"Flight tests to determine propeller performance have been made of a Curtiss No. 838-102-18 three-blade propeller having trailing-edge extensions on a Republic P-47D-28 airplane in climb and high speed. These tests are a part of a general propeller flight-test program at the Langley Laboratory of the National Advisory Committee for Aeronautics. Results of climb tests indicate that when power is changed from approximately 1475 horsepower at 2550 rpm (roughly normal power) to 2400 horsepower at 2700 rpm (approximately military power) there is a loss in propeller efficiency of 3 percent at an altitude of 7000 feet, and 4 percent at 21,000 feet" (p. 1).

Report discussing testing of a model of the pilotless aircraft RM-1 to measure aileron hinge moments in flight in order to determine the reason for loss of roll stabilization at supercritical speeds in flight. The aileron was found to become quickly underbalanced over the full deflection range at supercritical speeds. Information about the general flight behavior, aileron hinge moments, and roll stabilization of the model is provided.

Report presenting an investigation to obtain the pressure distribution over a sharp-nose body of revolution with a circular-arc profile and fineness ratio 6 at transonic speeds using the NACA wing-flow method. Results regarding the variation of pressure coefficient with Mach number, pressure distributions along the body axis, pressure drag, and effects of interference and horizontal gradient are provided.

Report presenting a general analysis that allows the rolling motions of an aircraft using a displacement-response, flicker-type automatic pilot to be determined. The system is not ideal for many stabilization problems due to inherent residual oscillations, but it offers a simple and economical solution in situations in which steady state oscillations are not a problem. Results regarding some general remarks, transient and steady states, stabilization boundaries, amplitude equations, and period equations are provided.

Report presenting an investigation of the closed wind-tunnel phenomenon of choking and the wall-constriction effects in the subsonic Mach number range where supersonic Mach numbers appear using the hydraulic analogy. Application of the results to wind tunnel testing, the subsonic choking phenomena, and effects of the walls are described.

Memorandum presenting an approximate subsonic theory developed for the solid blockage interference in circular wind tunnels with walls slotted in the direction of flow. The theory indicated the possibility of obtaining zero blockage interference. Tests in a circular slotted tunnel based on the theory confirmed the theoretical predictions.

Report presenting pressure distributions over a prolate spheroid of fineness ratio 6 and over a combination of this body with an NACA 65-010 wing section for a range of Mach numbers. Results regarding wall and sting interference, nature of flow over a model in the transonic region, development of supersonic flow from subsonic flow, and a comparison of experimental and theoretical flow at subsonic stream Mach numbers are provided.

Report presenting drag measurements made on a 10-percent-thick wing and 8-percent-thick tail and a 8-percent-thick wing, 6-percent-thick tail version of the X-1 airplane at a variety of Mach numbers. The drag of the thicker wing was found to be much higher than that of the thinner wing. The fuselage was found to cause interference with the wing of both models, making the separation of wing and fuselage drag difficult to determine.

Memorandum presenting an investigation to determine the automatic lateral stability characteristics of a model equipped with a gyro stabilizing unit that gave response to bank and yaw. Stable flights were obtained with the flicker-type automatic control, and the amplitude of the oscillations was decreased by adding the attachment which provided hunting control.

"Flight tests were conducted at the NACA Pilotless Aircraft Research Station, Wallops Island, to determine the characteristics of the Allegany Ballistics Laboratory's 6.2inch-diameter Deacon and 10-inch-scale model solid-propellant rocket motors. The tests were performed to assist in the development of these rockets which were designed for, and urgently needed to propel supersonic research models and pilotless aircraft. The tests showed that the rocket motors functioned properly under various flight- acceleration loads over a range of pre-ignition grain temperatures" (p. 1).

Report presenting the results of flight tests showing lateral oscillation in the Bell X-1 and calculations created to determine the effects of changes in several mass and aerodynamic parameters on the lateral oscillations. Calculations indicate that lateral stability should be improved by a more positive inclination of the principal axis of inertia or a reduction of the value of yawing moment of inertia.

Report presenting testing of low-aspect-ratio triangular-plan-form lifting surfaces located on conical and cylindrical portions of a body have been determined at Mach number 1.2 and several subsonic speeds to determine if the aerodynamic characteristics of these surfaces at supersonic speeds could be improved by locating them in the subsonic conical-flow field. Results regarding lift and drag coefficients and lift-curve slopes are provided.

Report presenting an analysis of the effects of compressibility on the pressure coefficients of several bodies of revolution by comparing experimentally determined pressure coefficients with corresponding pressure coefficients calculated by the use of linearized equations of compressible flow. The results indicated that the theoretical methods predict the subsonic pressure-coefficient changes over the central portion of the body but do not predict the pressure-coefficient changes near the nose.

Report presenting an investigation of the characteristics of a low-aspect-ratio wing at high subsonic Mach numbers in the high-speed tunnel. The wing model had an NACA 65-108 airfoil section, an aspect ratio of 4.01, a taper ratio of 0.498, and no twist or dihedral. Results regarding normal-force characteristics, pitching-moment characteristics, and drag characteristics are provided.

"A flight test of the Aero jet Engineering Corporation's 7KS-6000 T-27 Jato rocket motor was conducted at the Langley Pilotless Aircraft Research Station at Wallops Island, Va, to determine the flight performance characteristics of the motor. The flight test imposed an absolute longitudinal acceleration of 9.8 g upon the rocket motor at 2.8 seconds after launching. The total impulse developed by the motor was 43,400 pound-seconds, and the thrusting time was 7.58 seconds" (p. 1).

"A flight test was made to determine the servoplane effectiveness and stability characteristics of the free-floating horizontal stabilizer to be used on the XF10F airplane. The results of this test indicate that servoplane effectiveness is practically constant through the speed range up to a Mach number of 1.15, and the stabilizer static stability is satisfactory. A loss of damping occurs over a narrow Mach number range near M = 1.0, resulting in dynamic instability of the stabilizer in this narrow range" (p. 1).

Memorandum presenting an investigation of the effects of compressibility on the forces, pitching moments, and surface pressures on a wing-nacelle combination. The leading edge of the wing was swept back 37.25 degrees and the nacelle was a body of revolution with a fineness ratio of 6.5. The effects of compressibility on the surface pressures and on the drag of a body of revolution similar to the nacelle were also determined.

Report discussing an investigation of two transonic research airplane models at a range of Mach numbers and Reynolds numbers. The main difference between the models was the aspect ratio of the horizontal tail. Results regarding the stability, control, incremental horizontal-tail characteristics, downwash, horizontal-tail load, stability factors, and a tailless configuration are provided.

Memorandum presenting a study of the relationship between the static and dynamic properties of heat-resistant alloys at high temperatures. An auxiliary objective is to provide a better basis for evaluating the results from the various types of fatigue machines.

Report presenting longitudinal frequency-response characteristics of a 35 degree swept-wing airplane computed from flight measurements. Also presented are pitching-velocity frequency responses to displacements of the adjustable stabilizer. Results regarding frequency-response curves, transfer functions, elevator effectiveness, altitude variations, and potential errors in data are provided.