"Flight tests to determine propeller performance have been made of a Curtiss No. 838-102-18 three-blade propeller having trailing-edge extensions on a Republic P-47D-28 airplane in climb and high speed. These tests are a part of a general propeller flight-test program at the Langley Laboratory of the National Advisory Committee for Aeronautics. Results of climb tests indicate that when power is changed from approximately 1475 horsepower at 2550 rpm (roughly normal power) to 2400 horsepower at 2700 rpm (approximately military power) there is a loss in propeller efficiency of 3 percent at an altitude of 7000 feet, and 4 percent at 21,000 feet" (p. 1).

None

This status report includes brief reports on measurements and calculations of quantities for nuclear data applications and data for reactor safety. Separate abstracts were prepared for those items with a significant amount of data. (RWR)

An analysis is presented of combined stresses in the LOFT Modular DTT for specified temperature gradients. All combined stress intensities are shown to stay within applicable allowable stress intensities. A fatigue analysis is also presented which indicates that the LOFT Modular DTT will withstand 70,000 blowdown cycles. The LOFT Modular DTT is shown to meet the Class 1 stress requirments. A stress analysis of the tab region of the newly designed MDTT tab-type shroud is included. This stress analysis shows that the Class 1 stress requirements are met by the tab-type MDTT shroud design and that this design imposes no fatigue life limitation on the MDTT.

Abstract: A drilling program was conducted by the Atomic Energy Commission on Cove Mesa, Arizona to further develop uranium and vanadium ore reserves that are vital to the National Defense. The drilling was performed by the Minerals Engineering Company of Grand Junction, Colorado. Uranium and vanadium ore horizons are found in the Salt Wash member of the Morrison formation on Cove Mesa.

The gasification of coal char by hydrogen is much slower than in steam or carbon dioxide; moreover, hydrogasification rate in pure hydrogen decreases sharply with conversion for most carbons. To overcome this kinetic behavior, the oxidation of the char prior to and during hydrogasification has been investigated as a means of enhancing hydro gasification rate. Kinetic rate studies under well-characterized conditions have been complemented by careful surface analyses to characterize oxygen on the char surface prior to and during hydrogasification.

The gasification of coal char by hydrogen is much slower than in steam or carbon dioxide; moreover, hydrogasification rate in pure hydrogen decreases sharply with conversion for most carbons. To overcome this kinetic behavior, the oxidation of the char prior to and during hydrogasification has been investigated as a means of enhancing hydro gasification rate. Kinetic rate studies under well-characterized conditions have been complemented by careful surface analyses to characterize oxygen on the char surface prior to and during hydrogasification.

This Analysis/Model Report (AMR) describes enhancements made to the infiltration model documented in Flint et al. (1996) and documents an analysis using the enhanced model to generate spatial and temporal distributions over a model domain encompassing the Yucca Mountain site, Nevada. Net infiltration is the component of infiltrated precipitation, snowmelt, or surface water run-on that has percolated below the zone of evapotranspiration as defined by the depth of the effective root zone, the average depth below the ground surface (at a given location) from which water is removed by evapotranspiration. The estimates of net infiltration are used for defining the upper boundary condition for the site-scale 3-dimensional Unsaturated-Zone Ground Water Flow and Transport (UZ flow and transport) Model (CRWMS M&O 2000a). The UZ flow and transport model is one of several process models abstracted by the Total System Performance Assessment model to evaluate expected performance of the potential repository at Yucca Mountain, Nevada, in terms of radionuclide transport (CRWMS M&O 1998). The net-infiltration model is important for assessing potential repository-system performance because output from this model provides the upper boundary condition for the UZ flow and transport model that is used to generate flow fields for evaluating potential radionuclide transport …

X-ray computed tomography is a useful tool for investigating soil physical properties nondestructively. There is a need to develop proper calibration relationships between soil properties and the x-ray absorption coefficient. The objective of the work was to evaluate soil factors affecting the x-ray absorption coefficient. Based on a theoretical analysis, experimental data from five soils and on results of several other investigators, it was concluded that for many applications, one calibration relationship is applicable to a wide range of soils. The montmorillinitic clay used in the study required special handling due to the extreme shrinkage of this soil upon drying. Knowledge of chemical composition enables approximations but not exact predictions of the x-ray absorption coefficient. The results suggested some reasonable alternative to exhaustive calibration for each anticipated soil condition. Quantification of root activity in terms of root growth and indirectly through water uptake is necessary for understanding plant growth dynamics. X-ray computed tomography (CT) enables qualitative as well as two quantitative outputs, one of which can lead to conclusions regarding root activity. A greenhouse study involving soil columns (Lakeland sand, bulk density 1.4 Mg/m{sup 3}) planted to soybean, Bahiagras, and control (no vegetation) was conducted in 1989. A treflan based …

We are currently investigating the use of magnetic particles--polymeric-based spheres containing dispersed magnetic nanocrystalline phases--for the precise delivery of drugs via the human vasculature. According to this review, meticulously prepared magnetic drug targeting holds promise as a safe and effective method of delivering drugs to specific organ, tissue or cellular targets. We have critically examined the wide range of approaches in the design and implementation of magnetic-particle-based drug delivery systems to date, including magnetic particle preparation, drug encapsulation, biostability, biocompatibility, toxicity, magnetic field designs, and clinical trials. However, we strongly believe that there are several limitations with past developments that need to be addressed to enable significant strides in the field. First, particle size has to be carefully chosen. Micrometer-sized magnetic particles are better attracted over a distance than nanometer sized magnetic particles by a constant magnetic field gradient, and particle sizes up to 1 {micro}m show a much better accumulation with no apparent side effects in small animal models, since the smallest blood vessels have an inner diameter of 5-7 {micro}m. Nanometer-sized particles <70 nm will accumulate in organ fenestrations despite an effective surface stabilizer. To be suitable for future human applications, our experimental approach synthesizes the magnetic drug …

The major objectives of the proposed study were to: 1.) determine the leaching characteristics of hexavalent chromium [Cr(VI)] from contaminated sediments collected from 100 Area spill sites; 2.) elucidate possible Cr(VI) mineral and/or chemical associations that may be responsible for Cr(VI) retention in the Hanford Site 100 Areas through the use of i.) macroscopic leaching studies and ii.) microscale characterization of contaminated sediments; and 3.) provide information to construct a conceptual model of Cr(VI) geochemistry in the Hanford 100 Area vadose zone. In addressing these objectives, additional benefits accrued were: (1) a fuller understanding of Cr(VI) entrained in the vadose zone that will that can be utilized in modeling potential Cr(VI) source terms, and (2) accelerating the Columbia River 100 Area corridor cleanup by providing valuable information to develop remedial action based on a fundamental understanding of Cr(VI) vadose zone geochemistry. A series of macroscopic column experiments were conducted with contaminated and uncontaminated sediments to study Cr(VI) desorption patterns in aged and freshly contaminated sediments, evaluate the transport characteristics of dichromate liquid retrieved from old pipelines of the 100 Area; and estimate the effect of strongly reducing liquid on the reduction and transport of Cr(VI). Column experiments used the < …

Core characterization showed only 4 out of 13 core liner samples were intact samples and that the others were slough material. The intact samples showed typical Ringold Unit E characteristics such as being dominated by gravel and sand. Moderately reducing conditions are inferred in some core from borehole C4299. This reducing condition was caused by the hard tool process used to drill the wells. One core showed significant presence of ferric iron oxide/clay coatings on the gravels. There were no highly contaminated sediments found in the cores from the three new boreholes in UP-1 operable unit, especially for uranium. The presence of slough and ''flour'' caused by hard tooling is a serious challenge to obtaining field relevant sediments for use in geochemical experiments to determine the adsorption-desorption tendencies of redox sensitive elements such as uranium. The adsorption of COCs on intact Ringold Formation sediments and Fe/clay coatings showed that most of the anionic contaminants [Tc(VII), Se(VI), U(VI), Cr(VI), and I(-I)] did not adsorbed very well compared to cationic [Np(V), Sr(II), and Cs(I)] radionuclides. The high hydrous iron oxide content in Fe/clay coatings caused the highest Kd values for U and Np, suggesting these hydrous oxides are the key solid adsorbent …

Measurements were made of the neutron spectrum produced by bombarding a thick beryllium target with 30-MeV deuterons at the University of California, Davis cyclotron. This spectrum is of interest in studying the effect of neutrons on materials to be used in future fusion reactors. The spectrum was inferred from the activation of two sets of detector foils placed at 0/sup 0/ to the deuteron beam, one immediately behind the beryllium target block, and one 40 mm to the rear. A least-squares program was used to analyze the foil activation data to obtain the fluence in each of seven energy groups. The neutron spectrum (fluence/MeV) close to the target decreases continuously with energy in the range 5-32 MeV, while the spectrum 40 mm back has a peak at about 13 MeV. The contribution from neutrons of energies less than 10 MeV is much greater than that found in previous spectral measurements made at large distances from the target. This difference is attributed to the neutrons which are emitted at large angles from the deuteron beam. These observations show the importance of evaluating the neutron spectrum near the target if samples of materials are to be irradiated in this location. (auth)

Experimental photoion-photoelectron coincidence (PIPECO) spectra have been obtained at different nozzle stagnation pressures for Ar, Kr, Xe, and CO dimers and trimers in the wavelength regions corresponding to the respective ground states through all states accessible with a photon energy of 20 eV. Ionization energies for all ground states were measured and agree well with previously reported values. The formation of stable dimer ions from fragmentation of larger cluster ions initially produced by photoionization is efficient. For nozzle expansion conditions which minimize the formation of clusters larger than dimers, the intensities of the excited PIPECO bands for all clusters, except Ar{sub 2}{sup +} and Ar{sub 3}{sup +}, are found to be negligible with respect to the ground state PIPECO bands. The PIPECO technique has been used successfully to obtain the mass-selected threshold photoelectron spectra of the SO and S{sub 2}O transient molecules formed from a microwave discharge, effusive beam source. Analysis of the PIPECO spectra of all the clusters and transient molecules are presented. 177 refs., 32 figs., 6 tabs.

This report provides bibliography of resources related to the growth of the computer industry that were published in 1974.

The objective of this Class III project is to demonstrate that detailed reservoir characterization of slope and basin clastic reservoirs in sandstones of the Delaware Mountain Group in the Delaware Basin of West Texas and New Mexico is a cost-effective way to recover a higher percentage of the original oil in place through geologically based field development. The project focused on reservoir characterization of the East Ford unit, a representative Delaware Mountain Group field that produces from the upper Bell Canyon Formation (Ramsey Sandstone). The field, discovered in 1960, is operated by Oral Petco, Inc., as the East Ford unit: it contained an estimated 18.4 million barrels (MMbbl) of original oil in place.

Samples from three time-series sediment traps deployed in the Santa Monica Basin off the California coast were analyzed to study the flux and scavenging of uranium and thorium series isotopes. Variations of uranium and thorium series isotopes fluxes in the water column were obtained by integrating these time-series deployment results. Mass and radionuclide fluxes measured from bottom sediment traps compare favorably with fluxed determined from sediment core data. This agreement suggests that the near-bottom sediment traps are capable of collecting settling particles representative of the surface sediment. The phase distributions of {sup 234}Th in the water column were calculated by an inverse method using sediment trap data, which help to study the variations of {sup 234}Th scavenging in the water column. Scavenging and radioactive decay of {sup 234}Th are the two principal processes for balancing {sup 234}Th budget in the water column. The residence times of dissolved and particulate {sup 234}Th were determined by a {sup 234}Th scavenging model.

Plutonium, thermally cycled through the low-temperature allotropic transformations, exhibited extensive physical damage. The physical damage was greater than that reported for any other metal or alloy. The extent of physical damage was determined by measurements of fluid displacement and the dimensional changes. The internal porosity was examined metallographically. Physical damage varied considerably, depending on the cycling conditions and the characteristics of the metal (particularly inclusions and casting imperfections). Observations showed that increasing the specimen size produced a greater decrease in density as a function of the number of cycles. The degree of void formation was directly proportional to volume change associated with the phase transformation. Other variables such as the length-diameter ratio (constant diameter) had little or no influence on the amount of physical damage. The dimensional growth was both radial and longitudinal. The tensile strength and the yield strength of tensile specimens cycled ten times between the gamnna and alpha phases were decreased to an average of 30,000 and 26,000 psi, respectively. (auth)

Many scientific applications and experiments, such as high energy and nuclear physics, astrophysics, climate observation and modeling, combustion, nano-scale material sciences, and computational biology, generate extreme volumes of data with a large number of files. These data sources are distributed among national and international data repositories, and are shared by large numbers of geographically distributed scientists. A large portion of data is frequently accessed, and a large volume of data is moved from one place to another for analysis and storage. One challenging issue in such efforts is the limited network capacity for moving large datasets to explore and manage. The Bulk Data Mover (BDM), a data transfer management tool in the Earth System Grid (ESG) community, has been managing the massive dataset transfers efficiently with the pre-configured transfer properties in the environment where the network bandwidth is limited. Dynamic transfer adjustment was studied to enhance the BDM to handle significant end-to-end performance changes in the dynamic network environment as well as to control the data transfers for the desired transfer performance. We describe the results from the BDM transfer management for the climate datasets. We also describe the transfer estimation model and results from the dynamic transfer adjustment.

This report discusses the power of new tools for teaching and learning

The EMSL Quarterly Highlights Report covers the science, staff and user recognition, and publication activities that occurred during the 1st quarter (October 2007 - December 2007) of Fiscal Year 2008.

Significant improvements in technology-supported information services have created opportunities for their utilization by the farmers and ranchers of our Nation. This report highlights the development and expanded offering of these systems, describes current operational and experimental systems, and presents salient legislative initiatives which address this priority area.

Annual report submitted by the Boy Scouts of America to Congress describing highlights from 1970, activities, organizational leadership, and other information about scouting programs.

Report presenting testing of two rocket-propelled research models to determine the effect of the intersection of thin aerodynamic surfaces and the effect of moderate sweepback of thick aerodynamic surfaces on low-lift buffeting. Results regarding trim changes and drag are also provided. It was discovered that low-lift buffeting may be induced at high subsonic speeds by interference due to the intersection of thin aerodynamic surfaces.