None

"The rocket-propelled-model technique has been applied to the investigation of low-lift buffeting. Results of preliminary tests show that severe buffeting, wing dropping, and normal-force changes occur almost simultaneously near zero lift over a Mach number range near 0.9 on unswept wings 12 percent thick. On unswept wings 7 percent thick, buffeting did not occur; however, mild wing dropping and normal-force changes were experienced" (p. 1).

This report summarizes the findings of an experimental program conducted to support the modeling of the crush behavior of triaxial braid carbon fiber composites. The matrix material as well as braided panels and tubes were characterized in order to determine material properties, to assess failure modes, and to provide a test bed for new analytical and numerical tools developed specifically for braided composites. The matrix material selected by the ACC was an epoxy vinyl ester (Ashland Hetron 922). Tensile tests were used to compare two formulations-one used by the ACC and one recommended by the resin supplier. The latter was a faster reacting system and gelled in one-third the time of the ACC formulation. Both formulations had an average elongation at failure that was only half of the resin supplier's reported value. Only one specimen of each type came close to the reported elongation value and it was shown that failure invariably initiated at both surface and internal defects. Overall, the tensile properties of the two formulations were nearly identical, but those of the ACC system were more consistent. The properties of the ACC matrix formulation were measured in tension, shear, and compression and the average properties obtained in these …

None

A brief description is given of a calculational model developed to simulate a T(D,n)/sup 4/ He neutron source which is anisotropic in energy and intensity. The model also provides a means for including the time dependency of the neutron source. Although the model has been applied specifically to the Lawrence Livermore Laboratory ICT accelerator, the technique is general and can be applied to any similar neutron source.

An experiment is being directed at the Nevada Test Site to test the feasibility for storage of spent fuel from nuclear reactors in geologic media. As part of this project, an analysis of the earthquake hazard was prepared. This report presents the results of this seismic hazard assessment. Two distinct components of the seismic hazard were addressed: vibratory ground motion and surface displacement. (ACR)

A stress analysis was performed on the 3''-DW-1-E piping system inside containment penetration S-5C. Deadweight, thermal expansion, and seismic loads were considered. The results indicate that this piping will meet ASME Section III, Class 2 requirements.

This report is a Historical Review of General Revenue Financing in Social Security.

Large-scale scientific computation and all of the disciplines that support and help validate it have been placed at the focus of Lawrence Livermore National Laboratory (LLNL) by the Advanced Simulation and Computing (ASC) program of the National Nuclear Security Administration (NNSA) and the Scientific Discovery through Advanced Computing (SciDAC) initiative of the Office of Science of the Department of Energy (DOE). The maturation of simulation as a fundamental tool of scientific and engineering research is underscored in the President's Information Technology Advisory Committee (PITAC) June 2005 finding that ''computational science has become critical to scientific leadership, economic competitiveness, and national security''. LLNL operates several of the world's most powerful computers--including today's single most powerful--and has undertaken some of the largest and most compute-intensive simulations ever performed, most notably the molecular dynamics simulation that sustained more than 100 Teraflop/s and won the 2005 Gordon Bell Prize. Ultrascale simulation has been identified as one of the highest priorities in DOE's facilities planning for the next two decades. However, computers at architectural extremes are notoriously difficult to use in an efficient manner. Furthermore, each successful terascale simulation only points out the need for much better ways of interacting with the resulting avalanche of …

The Hanford Site Groundwater Protection Management Program recognized the need to integrate monitoring well activities in a centralized manner. A key factor to Hanford Site well integration was the need to clearly identify a responsible party for each of the wells. WHC was asked to identify all wells on site, the program(s) using each well, and the program ultimately responsible for the well. This report lists the custodian and user(s) for each Hanford well and supplies a comprehensive list of all decommissioned and orphaned wells on the Hanford Site. This is the first update to the original report released in December 1993.

This report discusses the role of Trade Adjustment Assistant (TAA) in U.S. trade policy, from its inception as a legislative option in the early 1950s, to its core role as a cornerstone of modern trade policy that many argue has served to promote the long-term U.S. trade liberalization agenda.

This document presents data from Savannah River Site routine environmental monitoring and surveillance programs.

The Chemical Technology Division (CMT) is one of eight engineering research divisions within Argonne National Laboratory, one of the U.S. government's oldest and largest research laboratories. The University of Chicago oversees the laboratory on behalf of the U.S. Department of Energy (DOE). Argonne's mission is to conduct basic scientific research, to operate national scientific facilities, to enhance the nation's energy resources, and to develop better ways to manage environmental problems. Argonne has the further responsibility of strengthening the nation's technology base by developing innovative technology and transferring it to industry. CMT is a diverse early-stage engineering organization, specializing in the treatment of spent nuclear fuel, development of advanced electrochemical power sources, and management of both high- and low-level nuclear wastes. Although this work is often indistinguishable from basic research, our efforts are directed toward the practical devices and processes that are covered by Argonne's mission. Additionally, the Division operates the Analytical Chemistry Laboratory and Environment, Safety, and Health Analytical Chemistry services, which provide a broad range of analytical services to Argonne and other organizations. The Division is multidisciplinary. Its people have formal training as ceramists; physicists; material scientists; electrical, mechanical, chemical, and nuclear engineers; and chemists. They have experience working …

This work reported here is part of the U. S. Department of Energy’s Science and Technology Initiative to develop improved conceptual models of flow and transport in the vadose zone, particularly for the Hanford Site, Washington. The National Academy of Sciences has identified significant knowledge gaps in conceptual model development as one reason for discovery of subsurface contamination in unexpected places. Inadequate conceptualizations limits, not only the understanding of long-term fate and transport, but also the selection and design of remediation technologies. Current conceptual models are limited partly because they do not account for the random heterogeneity that occurs under the extremes of very nonlinear flow behavior typical of the Hanford vadose zone. A major improvement in conceptual modeling of the Hanford vadose zone includes a better understanding and description of soil anisotropy, a property that appears to control much of the subsurface flow and transport in layered sediments at the Hanford Site.

An experimental facility was established at LLL to characterize radiation fields produced by a variety of sources and transmitted through various shielding materials. Specific techniques for acquiring and reducing continuous gamma-ray energy spectra are discussed including NaI(Tl) detectors. Use of several detector sizes allowed study of a wide variety of source intensities and calculation of response matrices for a number of collimated detector configurations. A computer program to perform the data reduction by an iterative unfolding process is described. The reduction technique discloses the continuous gamma-ray energy spectrum over the range 0.1 to 8 MeV as opposed to the traditional peak intensity analysis. 11 references.

This report includes these topics: Ecological issues relevant to environmental applications of genetically altered organisms / Elliott A. Norse -- An ecosystems approach to potential perturbations of energy flow and nutrient cycles associated with environmental applications of genetically altered organisms / David C. Coleman and Robert E. Hodson -- Ecological impact of genetically engineered organisms on ecosystems / James R. Gosz, C.N. Dahm, and Patrick W. Flanagan -- The genetic basis of changes in host range or habitat / Adrianne Massey and Fred Gould.

Use of an intermediate gas in the reaction chamber of an inertial fusion power reactor is under consideration to decrease the thermal shock to the walls resulting from target implosions. A model was developed and implemented in HEIGHTS package to simulate hydrodynamic and radiation shock waves in the chamber and used to determine the effect of xenon gas at various densities ranging from mtorr up to tens of torr. Numerical calculations for the dense-gas case indicated that two pressure peaks result from the shock wave interacting with the chamber wall, and radiation energy accumulates directly in front of the hydrodynamic shock wave. The shock wave should reach a maximum pressure peak when the chamber gas has a density between the two extremes analyzed. In general, calculated results with our model compared favorably with previously published data.

None

Effective remediation of an environmental site requires extensive knowledge of the geologic setting, as well as the amount and distribution of contaminants. Seismic investigations provide a means to examine the subsurface with minimum disturbance, Laboratory measurements are needed to interpret field data. In this experiment, laboratory tests were performed to characterize manufactured soil samples in terms of their elastic properties. The soil samples consisted of small (mass) percentages (1 to 20 percent) of peat moss mixed with pure quartz sand. Sand was chosen as the major component because its elastic properties are well known except at the lowest pressures. The ultrasonic pulse transmission technique was used to collect elastic wave velocity data. These data were analyzed and mathematically processed to calculate the other elastic properties such as the modulus of elasticity. This experiment demonstrates that seismic data are affected by the amount~of peat moss added to pure sand samples. Elastic wave velocities, velocity gradients, and elastic moduli vary with pressure and peat moss amounts. In particular, ultrasonic response changes dramatically when pore space fills with peat. With some further investigation, the information gathered in this experiment could be applied to seismic field research.

As a prerequisite to high accuracy measurements involving the bulk configuration of /sup 6/LiD we must have a good grasp of the details of the RTNS-I neutron source energy spectrum. Experiments to this end involving neutron yield vs deuteron energy, ratios of foil activation of selected elements, and pulse height distributions of a Si surface barrier detector are described. With this knowledge, the /sup 4/He-production cross sections for /sup 6/Li and /sup 7/Li are found experimentally to be 0.512b and 0.336b, respectively, at anti E/sub N/ = 15.0 MeV in free-field geometry. 14 references.

Supporting research activities continued to provide the technical basis for future mirror-confinement experiments. The industrial development of a high-current, high-field, high-current-density Nb/sub 3/Sn conductor was the main goal of the superconducting magnet program. Beam direct conversion was being developed as a means of raising the efficiency of neutral-beam production, and plasma direct conversion was shown to work as predicted. Conceptual designs were completed for various types of power reactors. The neutral-beam program progressed in three areas: experimental work, facility construction, and conceptual design. Experiments on the 14-MeV Rotating Target Neutron Source (RTNS-II) included participation by experimenters from many different institutions. Methods for processing tritium-contaminated wastes were pursued, as were studies of tritiated methane in stainless-steel vessels, the control of tritium in mirror fusion reactors, and the development of titanium tritide targets for the RTNS. The report period witnessed a rapid maturation in ability to describe theoretically the behavior of ion-cyclotron noise in the 2XIIB and the influence of that noise on the confined plasma. The high beta values achieved in 2XIIB prompted much theoretical analysis of the properties of high-beta equilibria and stability, including those of a field-reversed state. Excellent progress was made on the development of computer codes applicable …

The third US-Japan Workshop on Plasma Polarization Spectroscopy was held at the Lawrence Livermore National Laboratory in Livermore, California, on June 18-21, 2001. The talks presented at this workshop are summarized in these proceedings. The papers cover both experimental investigation and applications of plasma polarization spectroscopy as well as the theoretical foundation and formalisms to understand and describe the polarization phenomena. The papers give an overview of the history of plasma polarization spectroscopy, derive the formal aspects of polarization spectroscopy, including the effects of electric and magnetic fields, discuss spectra perturbed by intense microwave fields, charge exchange, and dielectronic recombination, and present calculations of various collisional excitation and ionization cross sections and the modeling of plasma polarization spectroscopy phenomena. Experimental results are given from the WT-3 tokamak, the MST reverse field pinch, the Large Helical Device, the GAMMA 10 mirror machine, the Nevada Terrawatt Facility, the Livermore EBIT-II electron beam ion trap, and beam-foil spectroscopy. In addition, results were presented from studies of several laser-produced plasma experiments and new instrumental techniques were demonstrated.

This paper describes the method developed and the results obtained in an extensive program of measurement of the masses of charged pions. Measurements were made of the total ranges in nuclear track emulsion and the momenta (obtained from the curving of the particle trajectory in the magnetic field of the 184-inch cyclotron) of pions and protons of nearly the same velocity.

Since their discovery by Bednorz and Mueller (1986), high-temperature cuprate superconductors have been the subject of intense experimental research and theoretical work. Despite this large-scale effort, agreement on the mechanism of high-T{sub c} has not been reached. Many theories make their strongest predictions for underdoped superconductors with very low superfluid density n{sub s}/m*. For this dissertation I implemented a scanning Hall probe microscope and used it to study magnetic vortices in newly available single crystals of very underdoped YBa{sub 2}Cu{sub 3}O{sub 6+x} (Liang et al. 1998, 2002). These studies have disproved a promising theory of spin-charge separation, measured the apparent vortex size (an upper bound on the penetration depth {lambda}{sub ab}), and revealed an intriguing phenomenon of ''split'' vortices. Scanning Hall probe microscopy is a non-invasive and direct method for magnetic field imaging. It is one of the few techniques capable of submicron spatial resolution coupled with sub-{Phi}{sub 0} (flux quantum) sensitivity, and it operates over a wide temperature range. Chapter 2 introduces the variable temperature scanning microscope and discusses the scanning Hall probe set-up and scanner characterizations. Chapter 3 details my fabrication of submicron GaAs/AlGaAs Hall probes and discusses noise studies for a range of probe sizes, which suggest …