With an unsymmetrical wing and a rotating Magnus cylinder, the lift is produced by the superposition of parallel and circulatory flows. An explanation of the circulatory flow is furnished by the boundary-layer theory of Prandtl and the consequent vortex formation. According to this explanation, it must evidently be possible to increase the circulation either by increasing the size of the stronger (lower) vortex or by decreasing the size of the weaker (upper) vortex.

Many treatises in regard to construction of airship sheds are lacking in data on air currents, for which reason this phase of the problem will be here thoroughly discussed in connection with the accompanying photographs of currents.

In an attempt to follow the time rate of change of the processes in turbulent flows by quantitative measurements the measurement of the pressure is often beset with insuperable difficulties for the reason that the speeds and hence the pressures to be measured are often very small. On the other hand, the measurement of very small pressures requires, at least, considerable time, so that the follow-up of periodically varying processes is as goad as impossible. In order to obviate these difficulties a method, suggested by Prof. Prandtl, has been developed by which the pressure distribution is simply determined from the photographic flow picture.

Report presenting the fatigue data obtained at the Aluminum Research Laboratories from tests of various types of 17S-T and 53S-T specimens. The specimens were large enough to represent actual service conditions, but the repetition of loading was more rapid than would occur in ordinary service.

Report presenting tests made on an XCG-7 all-wood glider on a PT-19A training airplane with a tubular metal fuselage and wooden wings by passing electrical surges simulating lightning discharges through the aircraft and measuring the voltage induced between various points which might be touched by an occupant. While certain recommendations for electrical protection are provided, the personnel in a metal fuselage aircraft are reasonably well protected from induced voltage shock without other protection.

From Summary: "An investigation of a heated jet was conducted in conjunction with tests of an axial-flow jet-propulsion engine in the Cleveland altitude wind tunnel. Pressure and temperature surveys were made across the jet 10 and 15 feet behind the jet-nozzle outlet of the engine. Surveys were obtained at pressure altitudes of 10,000, 20,000, 30,000, and 40,000 feet with test-section velocities from 30 to 110 feet per second and test-section temperatures from 60 F to -50 F. From measurements taken throughout the operable range of engine speeds, tail-pipe outlet temperatures from 500 F to 1250 F and jet velocities from 400 to 2200 feet per second were obtained."

"A method is described by which the total temperature of the gases at the combustion-chamber outlet of a ram-jet engine may be determined from the loss in total pressure measured across the combustion chamber. A working chart is presented by means of which the ratio of the total temperature of the gases at the combustion-chamber outlet to the total temperature of the gases at the combustion-chamber inlet may be determined from the measured loss of total pressure across the combustion chamber and the known values of air flow, total pressure, and total temperature at the combustion-chamber inlet. Values of total-temperature ratio across the combustion chamber of a 20-inch ram jet were obtained in the Cleveland altitude wind tunnel over a range of pressure altitudes from 6000 to 15,000 feet" (p. 1).

Report presenting a method for calculating the drag, in a real compressible fluid and at subcritical Mach numbers, of airfoil sections at arbitrary life coefficients and of bodies of revolution at zero angle of attack. The values of drag coefficient are compared with values obtained for the same configurations by other methods. The differences between the results are found to lie withint he limits of accuracy of current experimental techniques.

"It is shown that for velocities slightly in excess of sonic, the position of detached shock wave located in front of a given body at zero angle of attack may be estimated theoretically to a reasonable degree of accuracy. In case of bodies of revolution the result was simple, but for two-dimensional bodies, pressure coefficient varies with Mach number, and slight difficulty appears. Theory developed compares favorably with available experimental data" (p. 1).

"An investigation has been made at large scale of the characteristics of highly swept wings. Data were obtained at several angles of sideslip on wings having angles of sweep of plus or minus 45 degrees, plus or minus 30 degrees, and 0 degrees. The airfoil sections of the wings varied from approximately NACA 0015 at the root to NACA 23009 at the tip. Each wing was investigated with flaps under flection, partial-span split flaps deflected 60 degrees, full-span split flaps defected 60 degrees and split-flap-type ailerons deflected plus or minus 15 degrees" (p. 1).

Memorandum presenting a preliminary investigation to determine the effects of alpha-particle bombardment on the creep rate of aluminum wire at 400 degrees Fahrenheit. The alpha radiation from an 85-millicurie polonium source appeared to decrease slightly the creep rate of the aluminum.

Memorandum discussing four related methods for the study of compressible flow by means of the linear perturbation theory for the case of three-dimensional flow with axial symmetry. A general method which includes the other is also discussed briefly. In each case, the properties of the compressible flow are obtained from those of a corresponding incompressible flow.

Report presenting the optical principle of the NACA ultrahigh-speed camera. Simplified sketches are included illustrating the optical principle and main design features of the camera, but without minor design details. A detailed description of the camera is provided as well as some sample photographs taken with the camera.

Investigations were conducted to determine effectiveness of refrigerants in increasing thrust of turbojet engines. Mixtures of water an alcohol were injected for a range of total flows up to 2.2 lb/sec. Kerosene was injected into inlets covering a range of injected flows up to approximately 30% of normal engine fuel flow. Injection of 2.0 lb/sec of water alone produced an increase in thrust of 35.8% of rate engine conditions and kerosene produced a negligible increase in thrust. Carbon dioxide increased thrust 23.5 percent.

"The results of an experimental investigation made for the purpose of developing suitable jet-engine nacelle designs for a high-speed medium bomber are presented. Two types of nacelles were investigated, the first enclosing two 4000-pounds-thrust jet engines and a 65-inch-diameter landing wheel and the second enclosing a single 4000-pounds-thrust jet engine. Both types of nacelles were tested in positions underslung beneath the wing and centrally located on the wing" (p. 1).

Report presenting an investigation of the low-speed characteristics of a 25-foot span triangular wing with an aspect ratio of 2. the airfoil section of the wing was a symmetrical double wedge with 5-percent maximum thickness at 20-percent chord. Results regarding the longitudinal characteristics, lateral characteristics, and directional characteristics are provided.

Report presenting a study of the characteristics of a large-scale triangular wing to include the effects of section modifications. The wing in this report is the same as the one in the previous report but features various degrees of rounding of the wing leading edge and wing maximum thickness rather than having sharp edges. Results regarding the effects of airfoil section modifications, visible trailing vortices, and surveys in the extended chord plane are provided.

Memorandum presenting wind-tunnel tests that have been made to determine the aerodynamic characteristics of a model tail plane with modified NACA 65-010 sections and a tapered plan form. Results were obtained with the model tail plane unswept and swept back. The data show the lift, drag, pitching-moment, and hinge-moment coefficient variation with angle of attack and flap deflection at various Mach numbers.

Report presenting testing of a semispan model of a wing of triangular plan form and aspect ratio 2 in the 12-foot pressure tunnel to determine the aerodynamic characteristics of the wing as influenced by the independent effects of Reynolds number and Mach number up to Mach numbers approaching unity. Results regarding the effect of body and effect of wing-profile modification are also provided.

Report presenting a wind tunnel investigation to determine the downwash angles, dynamic pressure loss, and wake width behind wings with sweep angles of 45, 30, and 0 degrees. Results indicated that the spanwise distribution of downwash was affected by sweep in a manner similar to span loading, increased toward the root by sweepforward and toward the tip by sweepback.

From Introduction: "Analyses that provide a basis for comparing the centrifugal-stress distributions inherent in jet-engine turbine blades of several designs currently in use were therefore made and are presented."

Memorandum presenting the results of a wind-tunnel investigation of the low-speed characteristics of horizontal tails of aspect ratio 3 with unswept and swept-back plan forms. Two models were tested which had identical areas, aspect ratio, taper ratio, and airfoil section, differing only in the angle of sweepback and elevator area ratios. The major effect of sweepback was to increase the rate of change of hinge-moment coefficient with angle of attack, to reduce the rate of change with elevator deflection, and to reduce the elevator effectiveness.

Report presenting results of an experimental investigation to determine the temperature distribution in an aircraft-engine gas-turbine disk. Calculated stresses based on the measured temperature distributions are presented. Results regarding stresses in the inner region of the disk and stresses in the rim of the disk are provided.

Report presenting an investigation with a ram-jet combustion chamber to determine the effect of fuel-air ratio and the inlet-air parameters of pressure, temperature, and velocity on combustion limit, combustion efficiency, and flame length.