"So far, very careful investigations have been made regarding the flight properties, in particular the static and dynamic stability, of engine-propelled aircraft and of untowed gliders. In contrast, almost no investigations exist regarding the stability of airplanes towed by a towline. Thus, the following report will aim at investigating the directional stability of the towed airplane and, particularly, at determining what parameters of the flight attitude and what configuration properties affect the stability" (p. 1).

We have set ourselves the problem of calculating the laminar flow on a body of revolution in an axial flow which simultaneously rotates about its axis. The problem mentioned above, the flow about a rotating disk in a flow, which we solved some time ago, represents the first step in the calculation of the flow on the rotating body of revolution in a flow insofar as, in the case of a round nose, a small region about the front stagnation point of the body of revolution may be replaced by its tangential plane. In our problem regarding the rotating body of revolution in a flow, for laminar flow, one of the limiting cases is known: that of the body which is in an axial approach flow but does not rotate.

References to 193 publications of staff members of the Atomic Bomb Casualty Commission during 1947 through 1959 are listed in both English and Japanese. Author and subject indexes are included.

From Abstract: "Composition and performance specifications for a cellulose acetate laminating film suitable for a cellulose acetate laminating film suitable for archival use are presented. The properties of polyethylene and polyethylene terephthalate films of interest in connection with their possible use for the protection of documents are discussed."

"This bibliography lists selected articles on beryllium which have appeared in journals received in the library of the Lawrence Radiation Laboratory, Livermore, California and articles, reports, and books which have appeared in the following abstracting services between January, 1958 and August 1959."

A report about investigations of several binary alloy systems of thorium. Some of these alloys containing lead, molybdenum and tin have been prepared in the tungsten arc furnace.

Report presenting results obtained with quiescent fuel-air mixtures and with small diffusion flames, which indicate that combustion efficiencies close to 100 percent were obtained at pressure much lower than those found in turbojet combustors at altitudes of 60,000 feet.

Report presenting an investigation of a 45 degree sweptback-wing model with interchangeable round and sharp leading edges to determine the effect of leading-edge separation on the loads experienced by the models in gusts. Leading-edge separation was found to increase the gust load, which appeared to vary based on the gust-gradient distance and velocity.

Report presenting a correlation of carbon deposition of 19 fuels in a turbojet combustor as a function of the boiling point and of the flame height at the sooting point of the fuels in a simple wick lamp for a particular combustor operating at a single set of conditions. Two similar investigations with different combustors, operating conditions, and nine different fuels yielded similar correlations on the same graph.

From Summary: "An all-internal conical compression inlet with annular bleed at the throat was investigated at Mach 5.0 and zero angle of attack. The minimum contraction ratio of the supersonic diffuser, coincident with a mass-flow ratio of 1.0, was determined to be 0.084 as compared with the isentropic contraction ratio of 0.04 at Mach 5.0. The over-all inlet performance was very sensitive to the amount of annular bleed at the throat because of the extensive boundary layer."

"The wave drag of a combination of slender bodies of revolution at zero angle of attack is studied with a view to determining the arrangements for which the total drag is a minimum. Linearized theory is used to calculate the pressure distribution in the field surrounding the bodies. The interference drag coefficient is computed for different arrangements" (p. 1).

Note presenting a study of the factors that affect the survival of human beings in airplane accidents followed by fire by conducting full-scale crashes of transport- and cargo-type airplanes. Some of the factors studied include thermal injury, toxic gases, missiles, and structural destruction of occupied compartments are provided.

Report presenting a wind-tunnel investigation to determine the effects of a section modification on the aerodynamic characteristics of a wing with 35 degrees of sweepback. The wing was modified by increasing the leading-edge radius of the NACA 64A010 section and adding a small amount of camber to the forward portion of the chord. Lift, drag, pitching-moment, and trailing-edge-flap hinge-moment characteristics of the modified wing are compared with results from the original wing.

A study is made of the advantages that can be realized in compressible-flow research by employing a substitute heavy gas in place of air. The present report is based on the idea that by properly mixing a heavy monatomic gas with a suitable heavy polyatomic gas, it is possible to obtain a heavy gas mixture which has the correct ratio of specific heats and which is nontoxic, nonflammable, thermally stable, chemically inert, and comprised of commercially available components. Calculations were made of wind-tunnel characteristics for 63 gas pairs comprising 21 different polyatomic gases properly mixed with each of three monatomic gases (argon, krypton, and zenon).

The Redox process uses or produces only a very few materials that are hazardous for reasons other than radioactivity. The conditions under which these materials become hazardous were carefully taken into consideration in the development of the process and design of the equipment. A considerable about of information on the hazardous properties of the process materials was obtained so that the pertinent material could be incorporated into the process specifications. Providing the equipment is operating properly and the process is being carried out within specification limits, no hazardous conditions can be created by the process. The purpose of this report is to assemble in a single, readily available document all of the information on the normal concentration limits and safe handling procedures needed to adequately control the use and storage of these materials. This report should be helpful in preparing safety bulletins and provide guidance in case of unusual incidents, malfunctioning of equipment, or contemplated changes in either the process or equipment. It is important to remember that a maximum allowable concentration (MAC) is only a limit on the concentration of a toxic material which cannot be exceeded in the air to which workers are constantly exposed to every working …

Report presenting the total drag coefficients of 60 degree cone cylinders of fineness ratio 2.07 measured in free flight from Mach numbers of 1.5 to 8.2. Results regarding the smooth 60 degree cone cylinder, rifled models, and discontinuity lines in the shadowgraph pictures are provided.

Small metal spheres of various densities were fired at high speed into thick targets of copper and lead. In general, it was found that all of the penetrations could be correlated quite well for engineering purposes by a function relating the depth of penetration to the impact momentum per unit volume.

Report of progress on the metabolic properties of various materials, biological studies of radiation effects, health chemistry and physics.

Report presenting a wind-tunnel investigation to determine the effects of leading-edge radius and maximum thickness-chord ratio on the variation with Mach number of the aerodynamic characteristics of several thin symmetrical NACA 4-digit-series airfoil sections. The variations with Mach number of the lift, drag, and pitching moment for a 4-percent-chord-thick airfoil section are not significantly affected by a change of leading-edge radius from 0.18 to 0.53 percent of the chord. Results regarding the leading-edge radius effects and maximum thickness-chord ratio are provided.

Report presenting the aerodynamic characteristics of several wing-fuselage combinations measured at a Mach number of 0.25. Each combination consisted of a triangular wing with an aspect ratio of 2.0 and body of revolution with a fineness ratio of 12.5. Results regarding wings in the presence of bodies, wing-body combinations, and dorsal fins are provided.

Irradiation of a living animal with X-rays induces alternation in the proteins of cells in which ionization events occur. Systematic end-products such as the proteins of plasma would, by changes in quality and quantity divulge modification of their synthetic pathways, or compensatory responses of the hematopoietic systems to stresses caused by irradiation in other organs. Serological identification of proteins, a sensitive means of biochemical characterizations was chosen to reveal variations in the proteins of the plasmas of chickens that had been exposed to large, but sub-lethal, doses of X-ray irradiation. Turbidimetric comparisons were made of precipitation tests involving reactions between antisera produced in rabbits against the sera of normal chickens, and pre-irradiation and post-irradiation samples of plasma from 15 chickens.

Memorandum presenting a description of the Ames supersonic free-flight wind tunnel, which is a new piece of equipment for aerodynamic research at high supersonic Mach numbers. It has a wide Mach number range extending from low supersonic speeds to Mach numbers in excess of 10. The air stream in the tunnel is imperfect, mainly due to a symmetrical pair of oblique shock waves which reflect down the test section.

An investigation was conducted on an axial-flow-compressor type turbojet engine in the NACA Lewis altitude wind tunnel to determine the operational characteristics of several ignition systems, cross-fire tube configurations and fuel systems over a range of simulated flight conditions. The opposite-polarity-type spark plug provided the most satisfactory ignition. Increasing the cross-fire-tube diameter improved intercombustor flame propagation. At high windmilling speeds, accelerations to approximately 6200 rpm could be made at a preset constant throttle position. The use of a variable-area nozzle reduced acceleration time.

Memorandum presenting an investigation to determine the low-speed aerodynamic characteristics of a 45 degree swept wing with leading-edge inlets. The wing had a constant chord and completely spanned the wind tunnel. Results regarding surface-pressure characteristics, lift and pitching-moment characteristics, wake-drag characteristics, and internal-flow characteristics are provided.