Journal about library issues in Texas including collection development, programming and activities, managements, and other topics of interest.

The Redox process uses or produces only a very few materials that are hazardous for reasons other than radioactivity. The conditions under which these materials become hazardous were carefully taken into consideration in the development of the process and design of the equipment. A considerable about of information on the hazardous properties of the process materials was obtained so that the pertinent material could be incorporated into the process specifications. Providing the equipment is operating properly and the process is being carried out within specification limits, no hazardous conditions can be created by the process. The purpose of this report is to assemble in a single, readily available document all of the information on the normal concentration limits and safe handling procedures needed to adequately control the use and storage of these materials. This report should be helpful in preparing safety bulletins and provide guidance in case of unusual incidents, malfunctioning of equipment, or contemplated changes in either the process or equipment. It is important to remember that a maximum allowable concentration (MAC) is only a limit on the concentration of a toxic material which cannot be exceeded in the air to which workers are constantly exposed to every working …

Small metal spheres of various densities were fired at high speed into thick targets of copper and lead. In general, it was found that all of the penetrations could be correlated quite well for engineering purposes by a function relating the depth of penetration to the impact momentum per unit volume.

Report presenting the aerodynamic characteristics of several wing-fuselage combinations measured at a Mach number of 0.25. Each combination consisted of a triangular wing with an aspect ratio of 2.0 and body of revolution with a fineness ratio of 12.5. Results regarding wings in the presence of bodies, wing-body combinations, and dorsal fins are provided.

This is a revision of the Reactor Safety Bibliography prepared for the Reactor Safety Conference held at New York City on Oct. 31, 1957. It is not an exhaustive review of the published material on reactor safety but includes 223 selections from reports and published literature as a guide to some of the more recent and relevant material. (J.E.D.)

The burns to the skin of anesthetized rats were determined for the thermal radiation pulses of a carbon arc on a hot-wet uniform when spaced 5 mm from the skin. The radiant exposures to cause burns resulting in eschar were tion pulses corresponding to 250, 1000, 2900, and 10,000 kiloton detonations, respectively. The threshold lesions were caused by volatile products not associated with ignition. The associated temperatures were recorded. (auth)

Monthly journal about library issues in Texas including collection development, programming and activities, managements, and other topics of interest.

Report presenting the effects of variation of trailing-edge angle and trailing-edge thickness on the lift characteristics of a 10-percent-chord thick symmetrical NACA airfoil section with a 25-percent-chord plain flap as determined from wind tunnel tests over a range of Mach numbers. Results regarding the section lift and pitching-moment characteristics, variation of lift coefficient with flap deflection, schileren photographs, and effect of angle of attack are provided.

Monthly magazine discussing natural resources, parks, hunting and fishing, and other information related to the outdoors in Texas.

Memorandum presenting the results of an investigation to establish rupture and total-deformation strengths at 1200 and 1800 degrees Fahrenheit for typical commercial treatments of low-carbon N-155 alloy. The results show that there were large differences in strength between the heats of bar stock at temperatures above 1200 degrees Fahrenheit except when a 2200 degree Fahrenheit solution treatment was used.

The background for the conference is given. Plenary sessions papers are abstracted but discussions are quoted. Lists are included of technical sessions, U.S. papers, organizations, delegates, exhibits, with some pictures included, contents of the technical library and films available. Press releases are reported. Also included are two U.S. brochures prepared for the U.S. Exhibit, ''United States Research Reactor'' and ''Techical Exhibition of the United States of America.''