None

The background, operation, and need for solar thermal powered pumps for irrigation is reviewed, and a compilation of 38 literature references with summaries is presented. (WHK)

None

None

Using new experimental techniques, the spectra of $gamma$-rays from the capture of neutrons by $sup 181$Ta were measured at the Livermore 100-MeV linac for neutrons from 2 eV to 9 x 10$sup 4$ eV with a (Ge(Li)-NaI) three-crystal spectrometer. Individual primary $gamma$-ray lines were resolved to 1778-keV excitation in $sup 182$Ta. Neutron resonances were resolved to 200-eV neutron energy. Data analysis techniques and codes were developed to extract positions and intensities of resolved transitions from the large data matrices accumulated in this experiment. Techniques were developed to unfold the unresolved $gamma$- ray spectra using the simple response of the three-crystal spectrometer. The resolved transition data were used to place 110 states with spin and parity assignments in the $sup 182$Ta level diagram below 1780-keV excitation. A set of 1240 E1 transition strengths were analyzed to extract 1.38 +- 0.11 degrees of freedom for the most likely chisquared fit to the distribution of widths. The E1 strength function was extracted for E/sub gamma/ = 4 to 6 MeV and compared with previous results. The $gamma$-ray spectra for E/sub gamma/ = 1.5 to 6.1 MeV were unfolded for neutron energy groups between 20 and 9 x 10$sup 4$ eV. Below 5-MeV $gamma$-ray …

The requirements for mirror fusion electrical insulators are discussed. Insulators will be required at the neutral beam injectors, injector power supplies, direct converters, and superconducting magnets. Insulators placed at the neutral beam injectors will receive the greatest radiation exposure, 10/sup 14/ to 10/sup 16/ neutrons/m/sup 2/.s and 0.3 to 3 Gy/s (10/sup 5/ to 10/sup 6/ R/h) of gamma rays, with shielding. Direct converter insulators may receive the highest temperature (up to 1300/sup 0/K), but low voltage holding requirements. Insulators made from organic materials (e.g., plastics) for the magnet coils may be satisfactory. Immediate conductivity increases of all insulators result from gamma irradiation. With an upper limit to gamma flux exposures of 300 Gy/s in a minimally shielded region, the conductivity could reach 10/sup -6/ S/m. Damage from neutron irradiation may not be serious during several years' exposure. Surface changes in ceramics at the neutral beam injector may be serious. The interior of the injector will contain atomic hydrogen, and sputtering may transfer material away from or onto the ceramic insulators. Unknown and potentially damaging interactions between irradiation, electric fields, temperature gradients, cycling of temperature, surface and joint reactions, sputtering, polarization, and electrotransport in the dielectrics are of concern. Materials …

A series of experiments was performed in which gamma-ray spectra were measured, using a Ge(Li) detector, for incident 7 to 26-MeV protons on the even-even vibrational nuclei /sup 56/Fe, /sup 62/Ni, /sup 64/Zn, /sup 108/Pd, /sup 110/Cd, /sup 114/Cd, /sup 116/Cd, /sup 116/Sn, /sup 120/Sn, and /sup 206/Pb, and for incident 14-MeV neutrons on natural Fe, Ni, Zn, Cd, Sn, and Pb. These measurements yielded gamma-ray cross sections from which it was inferred that almost all of the gamma cascades from (p,p') and (n,n') reactions passed down through the first 2/sup +/ levels. Consequently, the strength of the 2/sup +/ ..-->.. 0/sup +/ gamma transitions were found to be an indirect measure of the (p,p') or (n,n') cross sections. Several types of nuclear model calculations were performed and compared with experimental results. These calculations included coupled-channel calculations to reproduce the direct, collective excitation of the low-lying levels, and statistical plus pre-equilibrium model calculations to reproduce the (p,p') and the (n,n') cross sections for comparison with the 2/sup +/ ..-->.. 0/sup +/ gamma measurements. The agreement between calculation and experiment was generally good except at high energies, where pre-equilibrium processes dominate (i.e. around 26-MeV). Here discrepancies between calculations from the two …

A laboratory study of the P-wave velocity and electric resistivity was undertaken on Cenozoic volcanic rocks collected from the Columbia Plateau volcanic basin (C) and the Jemez volcanic field (NM). Electric resistivities of cylindrical samples saturated with 0.1 N NaCl solution were measured using a four electrode system and a 1.0 KHz frequency source. Seismic P-wave velocities were calculated from measured transit time of mechanical pulses generated and received by piezoelectric transducers. The electric resistivity of water saturated samples decreased as temperature increased to the boiling point of water. Above boiling point, resistivity increased rapidly as water changed to vapor. Resistivity is most sensitive to temperature changes between 35/sup 0/C to 65/sup 0/C. Resistivities of samples increased with decrease in saturation. The effect is more pronounced at lower temperatures. No dependence of seismic P-wave velocities on temperature was observed. Both resistivity and P-wave velocity depend on porosity. The increase in porosity results in a decrease in the resistivity formation factor. Assuming a relationship FF = a phi/sup -m/ (Archie's Law), where FF and phi represent the formation factor and porosity respectively, least squares indicate a variation of a between .5 and 2.0. The value of m varied between 1.2 to …

The design and public demonstration of the MIVAC Drying System for drying peanuts, corn, sorghum, corn, and rice and the drying times with various dryer systems are reported. (LCL)

None

Westinghouse has completed the conceptual design of the Power System for the Ocean Thermal Energy Conversion (OTEC) Demonstration Plant project. This study included the development of a conceptual design for the following three items: first, a full-size power system module for the 100 MWe Demonstration Plant; second, a scaled proof of concept power system; and third, a heat exchanger test article. The study was limited to a closed cycle ammonia power system module, using a water temperature difference of 40/sup 0/F., and a surface platform/ship reference hull. Two power module of 50 MWe each are recommended for the demonstration plant. The 50 MWe module was selected since it has the lowest cost, and since it is of a size which convincingly demonstrates that future economically viable commercial plants, having reliable operation with credible anticipated costs, are possible. A modular, tube bundle approach to heat exchanger design makes large heat exchangers practical and economical. Other power module elements are considered to be within state-of-practice. Technological assessments of all subsystems indicate requirements for verification only, rather than continued research. A complete test program, which will verify the mechanical reliability as well as thermal performance, is recommended.

The stress analysis performed on the 4''-WH-237-E piping system inside containment penetration S-17B is presented. Deadweight, thermal expansion, and seismic loads were considered. Results of this analysis show that the subject piping system will meet ASME Code, Section III, Class 2 requirements.

None