Page three of a report by Sidney Siedband. The page lists the phone numbers of various individuals.

Report presenting a correlation of carbon deposition of 19 fuels in a turbojet combustor as a function of the boiling point and of the flame height at the sooting point of the fuels in a simple wick lamp for a particular combustor operating at a single set of conditions. Two similar investigations with different combustors, operating conditions, and nine different fuels yielded similar correlations on the same graph.

Report presenting a wind-tunnel investigation to determine the effects of leading-edge radius and maximum thickness-chord ratio on the variation with Mach number of the aerodynamic characteristics of several thin symmetrical NACA 4-digit-series airfoil sections. The variations with Mach number of the lift, drag, and pitching moment for a 4-percent-chord-thick airfoil section are not significantly affected by a change of leading-edge radius from 0.18 to 0.53 percent of the chord. Results regarding the leading-edge radius effects and maximum thickness-chord ratio are provided.

Work was completed on the high-temperature, high efficiency air filter. Technical assistance was given at a large-scale, privately financed run of an all-glass medium. Full-size filers have been produced in quantity and are offered by manufacturers; it is considered that commercial manufacture has been established. A survey was made of air sampling practices at 37 laboratories. Analysis of the survey results indicated that 22 different kinds of air-sampling filer media were in use among the laboratories questioned. We have recommended that air-assay practice be simplified by use of fewer media. A group of five media has been proposed as adequate for meeting all requirements. Laboratory work was done on the development of a high-efficiency, low-ash, all-purpose, air-assay paper. Two methods of approach were tried. In one an effort was made to produce cellulose fibrils in sufficient quantity and quality to act as the fine-fiber component of a filter. Only moderate success was attained. Better promise was shown by combining synthetic organic microfibers with cellulose fibers in a wet-formed sheet. No plant work was undertaken on this item.

Memorandum presenting the results of an investigation to establish rupture and total-deformation strengths at 1200 and 1800 degrees Fahrenheit for typical commercial treatments of low-carbon N-155 alloy. The results show that there were large differences in strength between the heats of bar stock at temperatures above 1200 degrees Fahrenheit except when a 2200 degree Fahrenheit solution treatment was used.