A double-peak, energy-dependent Breit-Wigner model of the E1 gamma-ray strength function was applied to nuclei from As to Rh, to predict their neutron capture cross sections and capture gamma-ray spectra. A consistent set of model parameters was obtained in this mass region to describe the step in the low-energy tail of the E1 strength function. This step allows agreement with photonuclear data at high energies, the correct GAMMA/sub gamma/ to be obtained for agreement with neutron capture cross-section data, and the calculation of the observed hardness in the capture gamma-ray spectra. For nuclei at or near the closed, N = 50 shell, however, the double-peak assumption breaks down. In these cases, good results are still obtained if the same set of model parameters is applied, except that the E1 strength function is formulated in terms of the first, narrower peak. 8 figures.

Although materials that exhibit nearest-neighbor-only antiferromagnetic interactions and geometrical frustration theoretically should not magnetically order in the absence of disorder, few such systems have been observed experimentally. One such system appears to be the pyrochlore Tb{sub 2}Ti{sub 2}O{sub 7}. However, previous structural studies indicated that Tb{sub 2}Ti{sub 2}O{sub 7} is an imperfect pyrochlore. To clarify the situation, we performed neutron powder diffraction (NPD) and x-ray absorption fine structure (XAFS) measurements on samples that were prepared identically to those that show no magnetic order. The NPD measurements show that the long-range structure of Tb{sub 2}Ti{sub 2}O{sub 7} is well ordered with no structural transitions between 4.5 and 600 K. In particular, mean-squared displacements (u{sup 2}'s) for each site follow a Debye model with no offsets. No evidence for Tb/Ti site interchange was observed within an upper limit of 2%. Likewise, no excess or deficiency in the oxygen stoichiometry was observed, within an upper limit of 2% of the nominal pyrochlore value. Tb L{sub III} and Ti K-edge XAFS measurements from 20-300 K similarly indicate a well-ordered local structure. Other aspects of the structure are considered. We conclude that Tb{sub 2}Ti{sub 2}O{sub 7} has, within experimental error, an ideal, disorder-free pyrochlore lattice, …

We are developing cryogenic bolometers to measure the total energy of the Linac Coherent Light Source (LCLS) free electron X-ray laser that is currently being built at the Stanford Linear Accelerator Center. LCLS will produce ultrashort {approx}200 fs X-ray laser pulses with {approx}10{sup 13} photons at 0.8 keV up to {approx}10{sup 12} photons at 8 keV per pulse at a repeat interval as short as 8 ms, and will be accompanied by a halo of spontaneous undulator radiation. Our bolometer consists of a 375 {micro}m thick Si absorber and a Nd{sub 0.67}Sr{sub 0.33}MnO{sub 3} sensor operated at its metal-insulator transition. It will measure the total energy of each pulse with a precision of <1%, and is designed to meet the conflicting requirements of radiation hardness, sensitivity, linearity over a dynamic range of three orders of magnitude, and readout speed compatible with the LCLS pulse rate. Here we discuss bolometer design and fabrication, and the photoresponse of prototype devices to pulsed optical lasers.

One of the primary concerns in the design and operation of high-intensity proton synchrotrons and accumulators is the electron cloud and associated beam loss and instabilities. Electron-cloud effects are observed at high-intensity proton machines like the Los Alamos National Laboratory's PSR and CERN's SPS, and investigated experimentally and theoretically. In the design of next-generation high-intensity proton accelerators like the Spallation Neutron Source ring, emphasis is made in minimizing electron production and in enhancing Landau damping. This paper reviews the present understanding of the electron-cloud effects and presents mitigation measures.

None

Initial- and final-state interactions from gluon exchange, normally neglected in the parton model, have a profound effect in QCD hard-scattering reactions, leading to leading-twist single-spin asymmetries, diffractive deep inelastic scattering, diffractive hard hadronic reactions, as well as nuclear shadowing and antishadowing-leading-twist physics not incorporated in the light-front wavefunctions of the target computed in isolation. The physics of such processes thus require the understanding of QCD at the amplitude level; in particular, the physics of spin requires an understanding of the phase structure of final-state and initial-state interactions, as well as the structure of the basic wavefunctions of hadrons themselves. I also discuss transversity in exclusive channels, including how one can use single-spin asymmetries to determine the relative phases of the timelike baryon form factors, as well as the anomalous physics of the normal-normal spin-spin correlation observed in large-angle proton-proton elastic scattering. As an illustration of the utility of light-front wavefunctions, the transversity distribution of a single electron is computed, as defined from its two-particle QED quantum fluctuations.

Liquid array technology has previously been used to show proof-of-principle of a multiplexed non structural protein serological assay to differentiate foot-and-mouth infected and vaccinated animals. The current multiplexed assay consists of synthetically produced peptide signatures 3A, 3B and 3D and recombinant protein signature 3ABC in combination with four controls. To determine diagnostic specificity of each signature in the multiplex, the assay was evaluated against a naive population (n = 104) and a vaccinated population (n = 94). Subsequently, the multiplexed assay was assessed using a panel of bovine sera generated by the World Reference Laboratory for foot-and-mouth disease in Pirbright, UK. This sera panel has been used to assess the performance of other singleplex ELISA-based non-structural protein antibody assays. The 3ABC signature in the multiplexed assay showed comparative performance to a commercially available non-structural protein 3ABC ELISA (Cedi test{reg_sign}) and additional information pertaining to the relative diagnostic sensitivity of each signature in the multiplex is acquired in one experiment. The encouraging results of the evaluation of the multiplexed assay against a panel of diagnostically relevant samples promotes further assay development and optimization to generate an assay for routine use in foot-and-mouth disease surveillance.

None

Recent technical progress in fusion research has been sufficient to encourage the development of conceptual designs for fusion power systems. These design efforts suggest that more attention should be paid to the safety and environmental effects of the radioactivity induced in the structural materials by the fusion neutrons. In particular, radioactivity from neutron activation of the structural components of a fusion power system will be a concern for occupational exposure of personnel. Careful choice of structural materials can significantly reduce this exposure. We propose the Remote Maintenance Rating (RMR) as a numerical means of comparing materials and machine designs with respect to occupational exposures. The RMR is defined as the dose rate at the surface of a uniformly activated, thick, infinite slab with the same composition and density as the machine component. We used the RMR rating system to evaluate the suitability of several different iron-based alloys. The specific fusion power system design used in our evaluation was a conceptual design from the Mirror Advanced Reactor Study (MARS). We determined that HT-9 is significantly better in terms of radiological dose rates at early times than the other iron-based alloys (by a factor of 3 to 7). We also calculated the …

Magnesium aryloxides were prepared in a variety of solvents through the reaction of dibutyl magnesium with sterically varied aryl alcohols: 2,6-dimethylphenol (H-DMP), 2,6-diisopropylphenol (H-DIP), and 2,4,6-trichlorophenol (H-TCP). Upon using a sufficiently strong Lewis-basic solvent, the monomeric species Mg(DMP){sub 2}(py){sub 3} (1, py = pyridine), Mg(DIP){sub 2}(THF){sub 3}, (2a, THF = tetrahydrofuran) Mg(TCP){sub 2}(THF){sub 3} (3) were isolated. Each of these complexes possesses a five-coordinate magnesium that adopts a trigonal bipyramidal geometry. In the absence of a Lewis base, the reaction with H-DIP yields a soluble trinuclear complex, [Mg(DIP){sub 2}]{sub 3} (2b). The Mg metal centers in 2b adopt a linear arrangement with a four-coordinate central metal while the outer metal centers are reduced to just three-coordinate. Solution spectroscopic methods suggest that while 2b remains intact, the monomeric species (1, 2a, and 3) are involved in equilibria, which facilitate intermolecular ligand transfer.

None

Techniques for producing intense negative ion beams are discussed. These beams are required for intense neutral beam development at energies greater than 150 keV. Handling, acceleration, and stripping of negative ion beams are described.

Objective was to examine the creative process, demonstrated by 5 student participants in a class at the Art Center College of Design in Pasadena CA, from the germ of the creative idea through the final creative product. The students, drawn from classes sponsored by LLNL, were assigned the problem of representing ``big`` science, as practiced at LLNL, in a graphic, artistic, or multimedia product. As a result of this study, it was discovered that the process of creativity with these students was not linear in nature, nor did it strictly follow the traditional creativity 5-step schema of preparation, incubation, insight, evaluation, and elaboration. Of particular interest were several emergent themes of the creative process: spontaneous use of metaphor to describe the Laboratory; a general lack of interest in ``school`` science or mathematics by the American art students; a well developed sense of conscience; and finally, the symbolism inherent in the repeated use of a single artistic element. This use of the circle revealed a continuity of thinking and design perhaps related to the idealistic bias mentioned above.

Since 2003, MicrobesOnline (http://www.microbesonline.org) has been providing a community resource for comparative and functional genome analysis. The portal includes over 1000 complete genomes of bacteria, archaea and fungi and thousands of expression microarrays from diverse organisms ranging from model organisms such as Escherichia coli and Saccharomyces cerevisiae to environmental microbes such as Desulfovibrio vulgaris and Shewanella oneidensis. To assist in annotating genes and in reconstructing their evolutionary history, MicrobesOnline includes a comparative genome browser based on phylogenetic trees for every gene family as well as a species tree. To identify co-regulated genes, MicrobesOnline can search for genes based on their expression profile, and provides tools for identifying regulatory motifs and seeing if they are conserved. MicrobesOnline also includes fast phylogenetic profile searches, comparative views of metabolic pathways, operon predictions, a workbench for sequence analysis and integration with RegTransBase and other microbial genome resources. The next update of MicrobesOnline will contain significant new functionality, including comparative analysis of metagenomic sequence data. Programmatic access to the database, along with source code and documentation, is available at http://microbesonline.org/programmers.html.

This article describes fabricating wood-rubber composites using rubber processing to improve water resistance and mechanical properties.

Cells use feedback to implement a diverse range of regulatory functions. Building synthetic feedback control systems may yield insight into the roles that feedback can play in regulation since it can be introduced independently of native regulation, and alternative control architectures can be compared. We propose a model for microbial biofuel production where a synthetic control system is used to increase cell viability and biofuel yields. Although microbes can be engineered to produce biofuels, the fuels are often toxic to cell growth, creating a negative feedback loop that limits biofuel production. These toxic effects may be mitigated by expressing efflux pumps that export biofuel from the cell. We developed a model for cell growth and biofuel production and used it to compare several genetic control strategies for their ability to improve biofuel yields. We show that controlling efflux pump expression directly with a biofuel-responsive promoter is a straight forward way of improving biofuel production. In addition, a feed forward loop controller is shown to be versatile at dealing with uncertainty in biofuel production rates.

Article reports that the massive amount of available neurodata suggests the existence of a mathematical backbone underlying neuronal oscillatory activities. The authors assert that the Monge’s theorem might contribute to our visual ability of depth perception and the brain connectome can be tackled in terms of tunnelling nanotubes.